In Common With GEMMA Manuel utilisateur

Catégorie
Accessoires de moto
Taper
Manuel utilisateur
Part G
Calla Shade
Part F
G9 LED Bulb
Part C
Wago Clips (x3)
Part A
Backplate
Part D
Flora Diuser
Part B
Mounting Screws (x4)
Part E
Tool + Washer
Part H
Canopy + Stem
Gemma Pendant, Medium
Assembly Guide incommonwith.com1 of 4
Contents
How to Install Your New Light
Please check that you received all of the components pictured in
this guide. Reach out to us if anything is missing. It’s very rare, but it
happens. Don’t forget to turn o the electrical power source.
Tools you will need that aren’t included: standard wire stripper,
Phillips head screwdriver.
CAUTION
Electrical shock risk. Turn o electrical power at the main fuse box
or circuit panel before beginning installation, servicing the light,
or installing accessories. We recommend working with a qualified
electrician familiar with the type of work youd like done.
ATTENTION
Risque de choc électrique. Coupez l’alimentation électrique au
niveau de la boîte à fusibles principale ou du panneau de circuits
avant de commencer l’installation, lentretien de la lumière ou
l’installation d’accessoires. Nous vous recommandons de travailler
avec un électricien qualifié familier avec le type de travail que vous
souhaitez eectuer.
Gemma Pendant, Medium
Assembly Guide incommonwith.com2 of 4
Step 2: Mount the backplate (A) to the junction box using a phillips head
screwdriver to tighten two of the provided mounting screws (B).
!
Step 1: Turn o electrical power at the main fuse box or circuit panel
before beginning installation.
Step 3: Gently slide the canopy cover down the stem (H).
A
B
H
Step 4: Use the wago clips (C) to connect the fixture’s wires to the
corresponding wires from the junction box in the wall or ceiling. White
is neutral; Black is live; Green/ Yellow is ground. One ground wire will be
attached to the backplate (A), the other ground wire should come from
the junction box. If needed use a wire stripper to remove 3/8” of the
insulation from each wire before inserting them into the corresponding
wago clip.
C
A
Gemma Pendant, Medium
Assembly Guide incommonwith.com3 of 4
Step 5: Mount canopy base on the stem (H) into the backplate using a
phillips head screwdriver to tighten two remaining mounting screws (B).
Step 6: Gently slide the canopy cover back up the stem (H). Rotate the
canopy cover clockwise to secure firmly in place.
Step 7: Carefully align the socket with the hole in the shade, and slide
the shade up. With one person holding the shade (G) in place, use the
included tool to thread the washer (E), tightening the shade to the stem
(H).
H
B
H
H
G
E
Step 8: Push included bulb (F) into socket.
F
E
Gemma Pendant, Medium
Step 9: Thread the diuser (D) over the bulb. Turn the power back on at
the main fuse box or circuit panel you disabled before installation.
Assembly Guide incommonwith.com4 of 4
D
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

In Common With GEMMA Manuel utilisateur

Catégorie
Accessoires de moto
Taper
Manuel utilisateur

dans d''autres langues