AmazonBasics B08441B3D3 Manuel utilisateur

3-Color Temperature Level and 3-Section

Dimming LED Cabinet Light

Lampe de Placard à LED à 3Températures

de Couleur et Intensité Variable à 3Niveaux

Luz LED para Gabinetes con Atenuador

de 3Secciones y Nivel de Temperatura de

3Colores

B08441B3D3, B084411CGP, B084415L9D,

B084417MQQ

English . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

Français . . . . . . . . . . . . . . . . . . . . . . . . . 24

Español . . . . . . . . . . . . . . . . . . . . . . . . . 42

3

A (x 1)

B (x 1)

Ø 1/4"

C (x 1)

5/8"

EN

4

IMPORTANT

SAFETY

INSTRUCTIONS

Read these instructions carefully and

retain them for future use. If this product

is passed to a third party, then these

instructions must be included.

When using electrical appliances, basic safety

precautions should always be followed to reduce

the risk of ﬁre, electric shock, and/or injury to

persons including the following:

CAUTION

Risk of electric shock! To

prevent risk of electric shock, turn off the power

at the main circuit breaker box before installation.

WARNING

Risk of ﬁre! Most dwellings

built before 1985 have supply wiring rated up

to 140 °F (60 ºC). Consult a qualiﬁed electrician

before installation.

EN

5

CAUTION

Risk of electric shock! This

product must be installed in accordance with

the applicable installation codes by a person

familiar with the construction and operation of

the product and the hazards involved. Consult

a qualiﬁed electrician to ensure correct branch

circuit conductor.

CAUTION

Risk of ﬁre! Do not install the

product on a radiant-heating ceiling.

CAUTION

Risk of eye damage! LEDs

emit bright light. Avoid looking directly into the

light source for prolonged periods.

• This product is rated 120 VAC and must be

connected to a suitable power source.

• This product is not intended for recessed

installation in ceilings, or sofﬁts.

• Do not install any lighting assembly closer

than 6" (15.24 cm) from any curtain or similar

combustible material.

• The product employs non-replaceable LED

light sources.

EN

6

• Contact the municipal building department to

learn about applicable local codes, permits

and/or inspections.

• This product is intended for use in

accordance with the National Electrical Code,

ANSI/NFPA 70, and the Canadian Electrical

Code, Part I, in non-hazardous locations, and

the Mexican Electrical Code [Instalaciones

Eléctricas (utilización), NOM-001-SEDE].

• This product should not be used with an

external dimmer.

SAVE THESE

INSTRUCTIONS

Intended Use

• This product is intended for residential use

only. It is not intended for commercial use.

• This product is intended to be used in dry

indoor areas only.

EN

7

CAUTION

Risk of electric shock! DO

NOT USE WHERE DIRECTLY EXPOSED TO

WATER.

• This product is not intended for use with

emergency exits.

• No liability will be accepted for damages

resulting from improper use or non-

compliance with these instructions.

Product Description

2

3

100 %

50 %

0 %

1

4

WW*

CW*

DL*

* WW: 3000 K, CW: 4000 K, DL: 5000 K

EN

8

1

Jumper connector

2

Brightness selection touch switch

3

Color temperature selection switch

4

Knockout plug

Before First Use

• Check the product for transport damages.

• Remove all the packing materials.

DANGER

Risk of suffocation! Keep any

packaging materials away from children – these

materials are a potential source of danger,

e.g. suffocation.

EN

9

Installation

DANGER

Risk of electric shock!

Disconnect power before installation.

NOTICE

This product must be mounted

onto a structurally sound surface that will

support weight of the ﬁxture.

EN

10

Step 1

Prise open the desired knockout plug (4) for the

conduit connector (B).

Step 2

Loosen the screws and open the cover.

EN

11

Step 3

Install the conduit connector (B) and secure it with

the nut.

B

EN

12

Step 4

Attach the metal conduit (5/8") to the conduit

connector (B) and secure it by tightening the

screws.

B

EN

13

Wiring

WARNING

Risk of

electric shock! To prevent

risk of electric shock, turn off

the power at the main circuit

breaker box before installation.

WARNING

Risk of electric shock! This

product must be connected to a properly

grounded electrical system. Never wire the

product to a two-wire system that is not

grounded. Contact a qualiﬁed electrician for

information with regards to proper grounding

methods as required by the local electrical code

in your area.

Black Phase

Product

Circuit

breaker

box

White

Neutral

Green

Ground

WARNING

OFF

EN

14

Step 1

Insert wires* into the open hole of the push-in

wire connector.

Phase

0.2"

(5 mm)

Neutral Ground

If the product is not linked with another

light(s), cut marked 3 wires and seal them

with an insulating tape.

* Connector Wire Gauge: 14-18 AWG

* Connector Wire Type: solid, stranded

EN

15

Step 2

Close the cover. Fix the product under the

cabinet using the provided 2 screws.

Step 3 (optional)

To link multiple products together, connect the

connecting cable (C) into the jumper connector

(1) of each light.

EN

16

CAUTION

Risk of ﬁre! Total power of lights

connected together: max. 270 W.

C

Operation

1. Adjust the brightness (0/50/100 %) using the

brightness selection touch switch (2).

2. Adjust the color temperature

(3000/4000/5000 K) by the color

temperature selection switch (3).

Cleaning and Maintenance

WARNING

Risk of electric shock! To

prevent electric shock, turn off the power at the

main circuit breaker box before cleaning.

EN

17

Cleaning

• To clean the product, wipe with a soft, slightly

moist cloth.

• Never use corrosive detergents, wire

brushes, abrasive scourers, metal or sharp

utensils to clean the product.

FCC – Supplier’s Declaration

of Conformity

Unique Identiﬁer

B08441B3D3 - 3-Color Temperature Level

and 3-Section Dimming LED Cabinet Light,

Linkable, Direct Wire, White Finish, 12-Inch

B084411CGP - 3-Color Temperature Level

and 3-Section Dimming LED Cabinet Light,

Linkable, Direct Wire, White Finish, 18-Inch

B084415L9D - 3-Color Temperature Level

and 3-Section Dimming LED Cabinet Light,

Linkable, Direct Wire, White Finish, 24-Inch

B084417MQQ - 3-Color Temperature Level

and 3-Section Dimming LED Cabinet Light,

Linkable, Direct Wire, White Finish, 32-Inch

EN

18

Responsible

Party

Amazon.com Services LLC

U.S. Contact

Information

410 Terry Ave N.

Seattle, WA

98109, United States

Telephone

Number

(206) 266-1000

FCC Compliance Statement

1. This device complies with Part 15 of the

FCC rules. Operation is subject to the

following two conditions:

(1) this device may not cause harmful

interference, and

(2) this device must accept any interference

received, including interference that may

cause undesired operation.

2. Changes or modiﬁcations not expressly

approved by the party responsible for

compliance could void the user’s authority to

operate the equipment.

EN

19

FCC Interference Statement

This equipment has been tested and found

to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable

protection against harmful interference in a

residential installation. This equipment generates,

uses and can radiate radio frequency energy

and, if not installed and used in accordance with

the instructions, may cause harmful interference

to radio communications. However, there is

no guarantee that interference will not occur

in a particular installation. If this equipment

does cause harmful interference to radio or

television reception, which can be determined

by turning the equipment off and on, the user is

encouraged to try to correct the interference by

one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the

equipment and receiver.

EN

20

• Connect the equipment into an outlet on

a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio /

TV technician for help.

Speciﬁcations

Rated voltage: 120 VAC, 60 Hz

Color rendering index

(CRI):

> 90

Power factor (PF): > 0.7

Color temperature: 3000/4000/5000 K

Standard deviation color

matching (SDCM):

≤ 6

Lifetime: 50000 hours

NOTICE

4000K color temperature is not

limited with SDCM.

La page est en cours de chargement...

AmazonBasics B08441B3D3 Manuel utilisateur

Ce manuel convient également à

AmazonBasics B08441B3D3 Manuel utilisateur

dans d''autres langues

Documents connexes

Autres documents