Bosch BODG-100 Manuel utilisateur

Bosch
Marque
Bosch
Modèle
BODG-100
Taper
Manuel utilisateur
Issue Date: 2021-10-22 Page
1
of
7
Version #
0.2
The 4G-Gateway for Split System Heat Pump
Revision History
Version Author Description Issue Date
0.1 TL Cheung Initial Release 2021-10-21
0.2 TL Cheung Change to “BLE 4.2” in the Product Specification 2021-10-22
0.3 TL Cheung Perfect RF description 2021-11-15
Product Specification
Product: 4G-Gateway
Model: BODG-100
Rating: 5Vdc, 550 mA (max)
Operating temperature: -10°F to 160°F
Storage temperature: -40°F to 185°F
Moisture Resistance: 90% RH
Wireless Communication: LTE Cat-M
BLE 4.2
Wired Communication: RS-485
BLE Operation Frequency:
2402MHz~2480MHz
BLE Channel Numbers: 40
BLE Channel Separation: 2MHz
BLE Modulation Type: GFSK
Crystal for BLE: 38.4MHz
BLE Antenna Type: Integral Antenna
BLE Antenna Gain: 3.83dBi
Issue Date: 2021-10-22 Page
2
of
7
Version #
0.2
LTE Antenna Type:
Dipole Antenna
LTE Antenna Gain:
band 2: 4.715dbi, band 4: 4.31dbi, band 5: 4.149dbi,
band 12: 0.885dbi,band 13: 1.427dbi, band 25: 4.72dbi, band 26:
4.244dbi
Product Description
This is a LTE IoT gateway with the following main features:
- Provide IDS outdoor unit wireless connectivity: to send data to the network cloud via LTE Cat-M.
- Provide homeowners the ability to remotely monitor the unit
- Provide contractors and service technicians the ability to view unit data via a local Bluetooth
connection.
- Derive power from the existing IDS ODU control board power supply.
Issue Date: 2021-10-22 Page
3
of
7
Version #
0.2
Product Diagram
Issue Date: 2021-10-22 Page
4
of
7
Version #
0.2
Product Wiring Diagram
Issue Date: 2021-10-22 Page
5
of
7
Version #
0.2
Installation
Issue Date: 2021-10-22 Page
6
of
7
Version #
0.2
⚠
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Issue Date: 2021-10-22 Page
7
of
7
Version #
0.2
⚠
This device contains licence-
exempt transmitter(s)/receiver(s) that comply with Innovation, Science
and Economic Development Canada’s licence-exempt RSS(s). Operation is subject
to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause
undesired operation of the device
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux
CNR d’Innovation, Sciences et Développement économique Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes :
1. L’appareil ne doit pas produire de brouillage;
2. L’
appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
⚠
RF Exposure:
This equipment complies with FCC/ISED RF radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with a minimum
distance of 20 centimeters between the radiator and your body.
⚠
CAN ICES-3 (B)/NMB-3 (B)
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de classe B est conforme à la norme canadienne ICES-003.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7

Bosch BODG-100 Manuel utilisateur

Bosch
Marque
Bosch
Modèle
BODG-100
Taper
Manuel utilisateur
Télécharger le PDF
rapport

dans d''autres langues

Autres documents