Malone MPG481 Manuel utilisateur

Marque: Malone

Modèle: MPG481

Taper: Manuel utilisateur

MALONE

DownLoaderDownLoaderTM

J-STYLE FOLDING KAYAK CARRIER

12’ Safety LinesJawz Universal Adapters Mounting BoltsKayak Carriers Load Straps T-Knobs

60mm

70mm

Installation & Loading Instructions - Please Read Before Beginning

Veuillez lire les instructions avant d’entreprendre l’installation et le chargement

. Insert Mounting Bolt through one hole of a Jawz adapter.

Insert washer and loosely apply a T-knob. See image 2.

. Faites passer le boulon de fixation dans l’un des trous

d’un adaptateur Jawz puis vissez légèrement un bouton

en ‘‘T’’ à la base du boulon. (Figure 2)

. Prior to installation, insert a bolt into the mounting holes in

the bottom of the carriers. Push upward to open the two

mounting hole covers located in the Base pads.

. Insert a Mounting Bolt into one mounting hole from the top

side. Rotate and close the mounting hole cover.

See image 1.

. Insérez un boulon de fixation dans l’un des trous hexagonaux

situés sur le côté supérieur du support.

(Figure 1)

. Place the carrier onto the front cross bar with the boarding

ramp facing out. Swing the Jawz under the cross bar as

shown. See image 3.

. Placez le support sur la barre transversale avant, la rampe

de chargement vers l’extérieur. Faites passer l’adaptateur

Jawz sous la barre transversale, tel qu’indiqué. (Figure 3)

Mounting Bolt Washers

Base Pad

Covers

IMPORTANT WARNING: All vehicular transports are potentially hazardous. Any person(s) using Malone products are personally responsible for

following the given directions for use and/or installation and accepts full responsibility for any and all damages or injury of any kind including death,

which may result from their use and/or installation.

It is critical that all Malone racks and accessories be properly and securely attached to your vehicle. Improper attachment could result in a serious

accident, and could cause serious bodily injury or death to you or to others. You are responsible for securing the racks and accessories to your car,

checking the attachment’s prior to use, and periodically inspecting the products for adjustment, wear, and damage.

You must read and understand all of the instructions and cautions supplied with your Malone products(s) prior to installation or use. If you do not

understand all of the instructions and cautions, or, if you have no mechanical experience and are not thoroughly familiar with the installation

procedures, you should have the product installed by a professional installer.

MISE EN GARDE IMPORTANTE: Tout transport d’un chargement sur le toit d’un véhicule est potentiellement dangereux. Une personne qui

utilise les produits Malone doit suivre sans faute les instructions d’installation et d’utilisation fournies et assume l’entière responsabilité pour tout

dommage ou toute blessure, y compris un décès, pouvant résulter d’une telle installation ou utilisation.

Il est essentiel de xer correctement et solidement les supports et les accessoires à votre véhicule. Une mauvaise installation ou attache pourrait

provoquer un accident, entraîner des blessures corporelles graves à vous et aux autres et même causer la mort. Vous avez la responsabilité de

xer solidement les supports et les accessoires à votre véhicule, de vérier l’installation avant l’utilisation et d’inspecter périodiquement le produit

pour déceler tout signe d’usure ou de dommage ou tout problème d’ajustement.

Vous devez lire et comprendre les instructions et les mises en garde fournies avec les produits Malone avant l’installation et l’utilisation. Si vous

ne comprenez pas les instructions et les mises en garde ou si vous ne possédez pas d’expérience en mécanique et ne connaissez pas à fond les

procédures à suivre d’installation, vous devriez faire monter et poser le produit par un installateur professionnel.

MPG481

MPG481 Storage Trunk

Fits the Following Malone Trailers:

MicroSporttm, LowMaxtm,

EcoLighttm Trailers

Assembly & Installation Instructions

Shown on MPG595

Important Note

Product Warranty & Registration Form

All information is condential and used exclusively by MALONE only.

MALONE

MALONE AUTO RACKS 81 County Rd. Ste 1, Westbrook, ME 04092

P: 207.774.9100 F: 207.615.0551

E: support@maloneautoracks.com W: www.maloneautoracks.com

Dear Customer,

Thank you for your purchase of a Malone Product.

In order to be eligible for the Malone Warranty program, we ask that you contact us online at the link provided

below: With-in 30 days of purchase. You can also mail this letter back to the address at the bottom.

• Online: https://maloneautoracks.com/product-registration.php

We will require the information below.

Here is the information collected:

First Name:

Last Name:

Address:

Address2:

City:

State:

Zip:

Country:

Email:

Phone:

Product Description/Name:

Product MPG#

Date Purchased:

Store Where Purchased:

Purchase Price:

Thank you for choosing Malone!

MALONE

Mounting Brackets (2) Storage Trunk & Lid (1)

Load Strap (1)D-Ring (2)

EcoLight Mounting

Hardware (4pcs)

NOTE: All images are for reference only, providing steps for installation and may not reect your

trailer exactly.

Mounting the Brackets

MicroSport Trailer Users: The rear 3/8” x 1” hex bolt holding

the Front Spring Hanger(s) in place will be used to secure the

Storage Trunk mounting brackets. Utilizing the hole circled. Image 1.

LowMax Trailer Users: The two 3/8” x 1” hex bolts holding the

Rear Spring Hangers in place will be used to secure the Storage

Trunk mounting brackets . Utilizing the holes circled. Image 2

ExtraLight and EcoLight Trailer Users: MAY REQUIRE(S)

DRILLING new holes along the top of the frame rail by the

fenders. These will be used to secure the Storage Trunk mounting

brackets. Utilizing the holes circled. Image 3

IF your trailer contains these mounting holes already, skip to the

install steps.

To Begin:

1). Using a 9/16” wrench and socket, install the D-rings to the

mounting brackets as pictured. See image 1.

MicroSport & LowMax Trailers:

2). Using a 9/16” wrench and socket drive, remove the lock

nut(s) from the hex head bolt(s) on the corresponding spring hanger.

See image 2.

Note: Carefully work around the wiring harness during this process

to avoid damage. See image 2.

Note: Where there is no tension on the assembly from the Spring.

The bolts will fall out freely.

3). Carefully remove the hex bolt(s) and place a mounting

bracket on the trailer frame so that the hole(s) in the bracket

align with the hex head bolt hole(s).

Conrm that the wiring harness is above the ange of the bracket

and dressed to the inside. See image 3.

4). Insert the hex head bolt(s) and hand tighten the lock nut(s). See

image 3.

Note: It may be necessary to slightly realign the Spring Hanger in order

for the hex head bolts to be inserted.

Note: This part to be can used on both the right and left side of the trailer.

There will be unused holes.

5). Using a 9/16” wrench and socket drive, rmly tighten the lock

nut(s) on the hex head bolts. See image 4.

6). Repeat steps 2-5 for the second mounting bracket on the other

side of the trailer.

MALONE

ExtraLight and EcoLight Trailers:

1). Measuring from the rear corner of the frame. Make a mark at

8.625“ and 17.625“ along the frame rail, in front of the fenders.

2). Using a 3/8” bit, carefully drill new mounting holes as seen in

image 1.

3). Place a mounting bracket on the trailer frame so that the two

holes in the bracket align with the two hex head bolt holes.

4). Use the provided mounting hardware to secure the brackets,

with the nut on the inside of the frame rail. See image 2.

Note: This part to be can used on both the right and left side of the trailer.

There will be unused holes.

5). Using a 9/16” wrench and socket drive, rmly tighten the two lock

nuts on the hex head bolts.

6). Repeats mounting steps for second bracket.

MALONE

Secure the Storage Box

CAUTION: THIS TRUNK IS NOT WATERPROOF.

MATERIALS THAT CAN BE DAMAGED FROM WATER SHOULD NOT BE PLACED IN THIS TRUNK.

1). Place the trunk onto the brackets as shown, Making sure the

brackets capture the storage box properly. See image 1.

2). Place the cam buckle of the load strap on the center of the

storage box and pull the free end of the load strap through the

D-ring on one side. See image 2.

3). Pull the free end over the storage box and through the second

D-ring.

4). Finish by dressing the free end through the buckle and pull to

tighten. The trunk should now be rmly stored and ready for

transport. See image 3

2 3

Shown on MPG595

MALONE AUTO RACKS 81 County Rd. Ste 1, Westbrook, ME 04092

P: 207.774.9100 F: 207.615.0551

E: support@maloneautoracks.com W: www.maloneautoracks.com

MALONE AUTO RACKS 81 County Rd. Ste 1, Westbrook, ME 04092

P: 207.774.9100 F: 207.615.0551

E: support@maloneautoracks.com W: www.maloneautoracks.com

Limited Five (5) Year Warranty

The Malone Auto Racks (Malone) Limited 5 Year Warranty covers certain Malone-brand products that have been specically

identied for inclusion in the program. This warranty is in eect for ve (5) years, from the time of sale, for the original retail purchaser

of the product. This warranty is terminated after ve years from the date of purchase, or, when the original retail purchaser sells or

otherwise transfers the product to any other person or entity during the ve year warranty period.

Subject to the limitations and exclusions described in this warranty, Malone will remedy defects in materials and/or workmanship

by repairing or replacing, at its option, a defective product without charge for parts or labor. Malone may elect, at its option, not to

repair or replace a defective product but rather issue to the original retail purchaser a refund equal to the purchase price paid for the

product, or credit to be used toward the purchase of a replacement Malone product.

This warranty does not cover, and no warranty is given for defects or problems caused by normal wear and tear, which includes,

but is not limited to, surface (aesthetic) metal corrosion, scratches, dents, deformities, accidents, unlawful vehicle operation, or any

modication of a product not performed or authorized in writing by Malone.

In addition, this warranty does not cover problems resulting from conditions beyond Malone’s control including, but not limited to,

theft, misuse, overloading, or failure to assemble, mount or use the product in accordance with Malone’s written instructions or

guidelines included with the product provided to the original retail purchaser.

No warranty is given for Malone products purchased outside of the continental United States, Canada and Mexico.

If the product is believed to be defective, the original retail purchaser should contact the Malone dealer from whom it was purchased,

who will give the original retail purchaser instructions on how to proceed. If the original retail purchaser is unable to contact the

Malone dealer, or the dealer is not able to remedy the defect, the original retail purchaser should contact Malone by email at

[email protected].

In the event that the product must be returned to Malone, a technician at the email address above will provide the original purchaser

with return shipping instructions. The original purchaser will be responsible for the cost of mailing the product to Malone. In order

to be eligible to receive any remedy under this warranty, a copy of the original purchase receipt, a description of the defect and a

return address must be provided.

Disclaimer of Liability

Repair or replacement of a defective product, or the issue of a refund or credit (as determined by Malone) is the original retail

purchaser’s sole and exclusive remedy under this warranty. Damage to original purchaser’s vehicle, cargo, or property, and/ or to

any other person or property is not covered by this warranty.

This warranty is expressly made in lieu of any and all other warranties, express or implied, including the warranties of merchantability

and tness of a particular purpose

Malone’s sole liability to any purchaser is limited to the remedy set forth above. In no event will Malone be liable for any direct,

indirect, consequential, incidental, special, exemplary, or punitive damages , or, for any other damages of any kind or nature

(including but not limited to, lost prots, lost income or lost sales).

Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations may not be

applicable.

In addition, all vehicular transports are potentially hazardous. Any person(s) using Malone products are personally responsible for

following the given directions for use and/or installation and accepts full responsibility for any and all damages or injury of any kind

including death, which may result from their use and/or installation.

MALONE

Malone MPG481 Manuel utilisateur

Marque: Malone

Modèle: MPG481

Taper: Manuel utilisateur

Télécharger le PDF

rapport

dans d''autres langues

English: Malone MPG481 User manual

Malone MPG481 Manuel utilisateur

Malone MPG481 Manuel utilisateur

dans d''autres langues

Documents connexes