Information contained in this document is PRIVILEGED and CONFIDENTIAL
[KT001 WH 01] Simple manual
●Product Overview
Channel Select
Button [CS] Power Button [PWR]
Volume Up Button [Vol.+]
Volume Down Button [Vol.-]
USB-C port
Function LED (RGB)
Charging LED (Red)
Topic Value
Product type Bluetooth®Headphone
For dedicated RSI unit
Chipset QCC3004
LED RGB LED x1 (function)
Red LED x1 (charging)
Button
4 buttons
Power
Volume Up/Down
Channel Select (CS)
MIC MEMS x1 *1
USB USB type-C
●Hardware Information
Topic Value
ADK ADK QCC300x 1.0.167
Bluetooth®version Bluetooth®5.0
Support profiles A2DP v1.3.1 AVRCP v1.6
HFP v1.7
Support codecs SBC
Multipoint No
Pairing PIN 0000
PDL size 2 devices
BT Device Name KT001 WH 01
BT VID source USB Implementers Forum
BT Vendor ID 0x0230
BT Product ID 0x0012
●Software Information
*1. Always muted without factory test mode.
Specification Remarks
•Not supported any use case of connecting with
general smartphones.
•Pairing mode is locked when PDL is fully registered.
Information contained in this document is PRIVILEGED and CONFIDENTIAL
*1. Pairing mode is locked when 2 devices are already paired.
UI Event User Action
Power on Long press [PWR]
Power off VLong press [PWR]
Enter pairing mode *1 Hold [PWR] after power on
Channel Switch Short press [CS]
Volume up Short press [Vol +] / Hold [Vol +]
Volume down Short press [Vol -] / Hold [Vol -]
Factory Reset
(Clear PDL) VVLong press [PWR] & [CS] at power off
Enter Maintenance
mode VVLong press [PWR] & [Vol +] at power off
(Enter DUT mode)VLong press [CS] & [Vol +] in maintenance
mode
(Enter BCCMD mode) VLong press [PWR] & [Vol -] in
maintenance mode
●UI –Button operation
UI Event User Action
Short Press Press and release within 800ms
Long Press Press and hold for 1.0 sec long
Very Long Press Press and hold for 2.0 sec long
(In Factory Test Mode, 1.5 sec long)
Very Very Long Press Press and hold for 3.5 sec long
Double Press Press and release 2 times within 800ms
Triple Press Press and release 3 times within 800ms
●Button Duration
Information contained in this document is PRIVILEGED and CONFIDENTIAL
●UI –Charging LED
LED State Image
Charge in progress
Charge completed No LED
Charge Error
R
R
●UI –Function LED
LED Event Image
Power On
Power Off
Connected
Ch.1 selected
Ch.2 selected
Factory Reset
G
O… flash 8times
G
B
O O
O
LED State Image
Not Connected
Pairing Mode
Connected
Maintenance mode
DUT mode
BCCMD Mode No LED
B BB B
B R B R B R
G
B B
R + B
How to pair 2 devices in Normal mode
1. System enters pairing mode automatically when PDL is empty.
2. In order to pair the 2nd device, press and hold the Power button for 2 seconds long in power off.
[Important]
In case that headset does not enter pairing mode, the key operation is locked.
It is necessary to clear PDL by executing factory reset.
Information contained in this document is PRIVILEGED and CONFIDENTIAL
Canada
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innova
tion, Science and Economic Development Canada’s licence-exempt RSS(s). Operation
is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause un
desired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conform
e aux CNR d’Innovation, Sciences et Développement économique Canada applicables
aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditio
ns suivantes :
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage e
st susceptible d’en compromettre le fonctionnement.
This equipment complies with ISED radiation exposure limits set forth for an uncontrol
led environment and meets RSS-102 of the ISED radio frequency (RF) Exposure rules
as this equipment has very low levels of RF energy.
Cet équipement est conforme aux limites d’exposition aux rayonnements énoncées p
our un environnement non contrôlé et respecte les règles d’exposition aux fréquences
radioélectriques (RF) CNR-102 de l’ISDE puisque cet appareil a une niveau tres bas d'
energie RF.
U.S.A
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment
-Properly shielded and grounded cables and connectors must be used for connection to host computers and / or
peripherals in order to meet FCC emission limits.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and
receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected. —Consult the dealer or an experienced radio/TV technician for help.
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC
radio frequency (RF) Exposure Guidelines as this equipment has very low levels of RF energy.
Mexico
La operación de este equipo está sujeta a las siguientes dos condiciones: (1) es posib
le que este equipo o dispositivo no cause interferencia perjudicial y (2) este equipo o
dispositivo debe aceptar cualquier interferencia, incluyendo la que pueda causar su o
peración no deseada.
Nigeria
Korea
-Model name (KT001 WH 01)
-Manufacturer name (Foster Electric Co., Ltd.)
-Country of manufacture (China)
Information contained in this document is PRIVILEGED and CONFIDENTIAL
Oman
Oman-TRA
TRA/TA-R/XXXX/XX
Dealer No：D090024
EU
Safety instructions for rechargeable Lithium-ion battery pack
This product has a built-in rechargeable lithium ion battery pack.
Danger
Do not use or handle the battery under the following conditions.
・use, storage or transportation of the battery in an excessively high or low temperature environment;
・disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery;
・leaving a battery in an extermely high temparature surrounding environment;
・leaving a battery in an extermely low air pressure surrounding environment;
Handling under the above conditions may cause battery leakage, and in extreme cases, explosion, heat genera
tion, fire, smoke or gas generation.
Warning
・Do not charge a product with built-in rechargeable batteries if ambient temperatures above 0-45 ℃.
・Product with built-in rechargeable batteries should not be heated to temperatures above 60 ℃.
・Do not charge the product if there is a clear defect in the product that contains the rechargeable battery.
Disposal Method
・Dispose of product with built-in rechargeable batteries at special collection points or
return them to your specialist dealer.
EU
Frequency Band: 2400-2483.5MHz
Frequency of Operation: 2402-2480MHz
Transmit Power: Typical: +0.5dBm, MAX: +3.5dBｍ
Information contained in this document is PRIVILEGED and CONFIDENTIAL
CU declaration (Russia/Belarus/Kazachstan)
· Product name(Bluetooth®Headphone) and/or model name (KT001 WH 01)
· Manufacturer name and / or brand name (FOSTER ELECTRIC CO.,LTD.)
· Country of origin (China)
· The inquiry destination of the product
(Foster Electric Co., Ltd.
1-1-109, Tsutsujigaoka, Akishima City, Tokyo,
196-8550, Japan)
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG,
Inc. and any use of such marks by Foster Electric Company Limited is under license. Other
trademarks and trade names are those of their respective owners.
Scope of Delivery
1
2
(1) Headphones
(2)¹USB Cable
1 P/N:639725
Information contained in this document is PRIVILEGED and CONFIDENTIAL
Label Position (Behind Earpad)
Detachable Earpad
Labels on headphone side.
-
1
-
2
-
3
-
4
-
5
-
6
-
7
dans d''autres langues
- English: Foster KT001 User manual
Autres documents
-
NCR Quantum QR1000 Manuel utilisateur
-
MindMobile BLE301i Manuel utilisateur
-
Ingenico iSMP4 Manuel utilisateur
-
-
DENSO TEN TN0022A Car Navigation Manuel utilisateur
-
Michelin RV5-01 Manuel utilisateur
-
Monoprice SB-300 Virtual Dolby Atmos 2.0 Channel Soundbar Manuel utilisateur
-
Champion Power Equipment Champion 1638Wh Solar Generator 3200/1600-Watt Power Station Le manuel du propriétaire
-
Motorola WM500 Guide d'installation
-
Panasonic RBM300BE Manuel utilisateur
