Monster MLB7-1027-WW Manuel utilisateur

MLB7-1027-WW
Monster
Marque
Monster
Modèle
MLB7-1027-WW
Catégorie
Éclairage d'ambiance
Taper
Manuel utilisateur
MODEL MLB7-1027
V4.0 0623
Operation Manual
RGB+W
Multicolor + Multiwhite LED Light Strip
with Remote Control
Features
What’s Included
Introduction
• USB powered from any 5V standard USB port
• Self-adhesive backing for easy application
• Color changing and flash modes with controllable brightness
adjustment
• 44 RGB color and 44 warm white LED lights for multi-color and
multi-white lighting
• 6.5ft (2m) length fits TV’s up to 65" to create ambient
backlighting
• Remote control works up to 26 feet away
• Plug and play
• 6.5ft RGBW LED Light Strip
• IR Remote Control with battery (1 x 3V battery, CR2025*)
• User Manual x1 pc
This Multi-color/Multi-white LED strip is easy to install,
easy to use, and is ideal for adding ambient backlighting
behind your TV or computer monitor for a great movie or
gaming experience
Safety
Instructions
Please read and understand all instructions before using
this product. If damage is caused by failure to follow the
instructions, this warranty is null and void.
• Keep these instructions.
• Do not drop, puncture, or disassemble this product.
• Do not expose this product to dripping or splashing of
drinks or liquids of any kind.
• Avoid long exposure to direct sunlight, which may cause
damage.
• Do not expose this product to open flames.
• Do not use the product in a strong magnetic field.
• Use a clean, soft cloth to clean. Do not use any corrosive
cleaners/oils to clean.
• Do not attempt to repair the device or open the unit as this
will void the warranty.
Get Started
1
2
3
5
4
Clean the surface you intend to stick the LED Light to
Peel beginning of adhesive backing off and firmly stick LED
Light onto the mounting surface (be careful to peel off only
the backing and not the adhesive)
Peel off more of the adhesive backing as you mount the
LED Light, pressing and holding each section firmly against
the surface
Remove the tab from the battery compartment of the
remote control
Connect the USB cable to a USB wall charger or a power
bank (1A adapter required – not included)
4
2
3
1
Installation Notes:
(Back of TV)
USB
the pinch the pinch
For best mounting results, place adhesive onto desired
surface with ONE attempt. Reapplying multiple times will
not guarantee secure mounting onto surface.
Make sure the desired location is close enough to a power
source like a TV’s USB port or a wall outlet with a 1A USB
adapter (not included)
For optimal performance, place IR receiver in a location
away from the IR receiver on the TV to avoid interference
from the TV remote control signal
For backlighting a TV or monitor, follow the mounting
diagram below:
MODEL MLB7-1027
V4.0 0623
Operation Manual
①
②
③
④
⑤
⑥
⑦
⑧
Controls, at a Glance
ON/OFF
MULTI-WHITE SELECTORS
MULTI-COLOR SELECTORS
FLASH
STROBE
FADE
SMOOTH
RESET
DIMMER BUTTONS
⑥
Turn the product on and off
Select from cool, soft, or warm white
Change the color to match your mood
Flash color-changing mode
Strobe color-changing mode
Fade color-changing mode
Smooth color-changing mode
Reset to default settings
Adjust the brightness/intensity
④ ⑤ ⑥ ⑦
⑧
⑥
①
②
③
IR Remote
IR Remote
Operation
1
2
3
4
1
2
3
Changing the remote control battery:
The battery for the remote control has already been installed.
Remove and discard the clear plastic pull tab before use.
NOTE: For best operation, point the IR remote towards the IR
Receiver at the beginning of the light strip.
* The listed battery type may differ slightly from what is supplied.
When replacing the battery, please verify the actual battery size in
the remote control.
Turn on the LED Light by pushing the ON button on the
remote control
Select the desired color or the desired effect by pushing
the corresponding button on the remote control
Set the desired brightness using the buttons to
increase/decrease the intensity of color
Push the OFF button to turn off the LED Light
The battery compartment is located on the narrow side of
the remote control, press the release tab inwards and
remove the tray
Remove the empty battery and insert a 3V battery, type
CR2025*, with the positive terminal pointing upwards
Place the battery compartment back in the remote control
so it locks in place
Customer
Service
1 Year Limited Warranty
Scan QR code for warranty information
866-246-2008
[email protected]
In the event this product becomes defective,
please do not return this product to your retailer.
Warning
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s warranty or authority
to operate the equipment.
Specifications
• LED Light (USB): 5V
• output: 2.5W
• length: 6.5ft
• remote control: 3V
(1 x 3V battery, type CR2025*)
The illustrated products and specifications may dier slightly from those supplied.
The M Monster logo is a registered trademark of Monster, Inc. or its subsidiaries in the
U.S. and other countries and are used under license. All other brand names are
trademarks of their respective owners. Neither Jem Accessories, Inc. nor Monster, Inc.
is aliated with the respective owners of their trademarks. Licensed and
Manufactured by Jem Accessories, Inc. Edison, NJ 08817. Made in China.
www.monsterilluminessence.com/manuals/
scan for manuals
rechercher des guides d’utilisation
buscar los manuales
nach Handbüchern scannen
scansione dei manuali
сканирование для руководств
Need the Quick Start Guide in another language?
Besoin du guide de démarrage rapide dans une autre langue?
¿Necesita la guía de comienzo rápido en otro idioma?
Benötigen Sie die schnellstartanleitung in einer anderen Sprache?
Serve la guida rapida in un'altra lingua?
Вам нужно Краткое руководство на другом языке?
EN
FR
ES
DE
IT
RU
* The listed battery type may differ slightly from what is supplied. When
replacing the battery, please verify the actual battery size in the remote control.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10

Monster MLB7-1027-WW Manuel utilisateur

MLB7-1027-WW
Monster
Marque
Monster
Modèle
MLB7-1027-WW
Catégorie
Éclairage d'ambiance
Taper
Manuel utilisateur
Télécharger le PDF
rapport

dans d''autres langues

Autres documents