APURO CD969-A Manuel utilisateur

Catégorie
Scelleuses sous vide
Taper
Manuel utilisateur
Model:
CD969-A
Vacuum Pack
Machine
Instruction manual
2
EN Telephone Helpline: 1300225960
Safety Instructions
• Position on a flat, stable surface.
• A service agent/qualified technician should carry out
installation and any repairs if required. Do not remove any
components on this product.
• Consult Local and National Standards to comply with the
following:
- Health and Safety at Work Legislation
- Fire Precautions
- Wiring Regulations
- Building Regulations
This product is not intended to be used for
liquids.
• DO NOT immerse the appliance in water.
• The sealing bar becomes hot during use. DO NOT touch the
sealing bar during or immediately after operation.
• Do not turn Off at the plug to halt operation; always use the
Cancel button.
• Do not use the appliance for anything other than its intended
use.
• Only use bags recommended by the supplier/manufacturer
with the appliance.
• Always switch off and disconnect the power supply to the
appliance when not in use.
• Not suitable for outdoor use.
• Keep all packaging away from children. Dispose of the
packaging in accordance to the regulations of local authorities.
• If the power cord is damaged, it must be replaced by an
APURO agent or a recommended qualified technician in order
to avoid a hazard.
3
EN
Telephone Helpline: 1300225960
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience or knowledge, unless they have been
given supervision or instruction concerning the use of the
appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play
with the appliance.
• APURO recommend that this appliance should be periodically
tested (at least annually) by a Competent Person. Testing
should include, but not be limited to: Visual Inspection,
Polarity Test, Earth Continuity, Insulation Continuity and
Functional Test.
Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and operation of
this machine will provide the best possible performance from your APURO product.
Pack Contents
The following is included:
APURO Vacuum Pack Machine Lid gasket
Heater wire assembly Instruction manual
APURO prides itself on quality and service, ensuring that at the time of unpacking the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your APURO dealer immediately.
Location of Controls
1 2 7
3 5 64
4
EN Telephone Helpline: 1300225960
Controls
1. Vacuum & Seal Button / Cancel
Press to start automatic operation of vacuuming the bag and then automatically seal the bag
when vacuum is completed
Press to stop the Vacuum cycle and release lid
2. Manual Seal
Use to seal open end of a bag when making bags from roll
During automatic ‘Vacuum and Seal’ function press to immediately start the bag sealing process
(to avoid crushing delicate items)
3. Vacuum Time Screen
Shows the working time and progress of vacuuming
4. Vacuum Time Adjusting Button (Vac Time “+” or “-”)
Simply adjust the vacuum time “up” or “down” by using “+” or “-” buttons
5. Seal Time Screen
Shows the working time and progress of sealing function
6. Seal Time Adjusting Button (Seal Time “+” or “-”)
Simply adjust the seal time “up” or “down” by using “+” or “-” buttons
7. Vacuum Gauge
Shows the vacuum level inside the vacuum chamber
Operation
Plug in Vacuum Pack Machine and turn on Power Switch. The machine is now ready for use.
Vacuum Packing Food
1. Place the food inside in the bag
2. Allow minimum of 25mm-50mm of space at the top of bag to ensure a good seal.
3. Place the open end of the bag across the sealing bar. Close lid.
4. Press the Vacuum/Seal button
5. The machine goes to vacuum cycle. When vacuuming, vacuum time will be shown on the Digital
Display and count down from default setting to 0.
(Note: Vacuum time is adjustable from 20-99 seconds.)
6. At anytime during vacuum cycle pressing the ‘Manual Seal’ button will override timer and complete
the vacuuming and sealing cycle.
7. After the vacuum process the machine automatically goes to sealing cycle.
8. When sealing, seal time will be shown on the Digital Display and count down from default setting to 0.
(Note: Seal time is adjustable from 3-9 seconds. If the setting time is 0, the machine will
not seal.)
9. Take out the bag and check the vacuum and seal.
(Note: A good seal will look clear upon inspection. If the seal is spotty, incomplete,
wrinkled, white or milky, remove sealed portion and run vacuum and seal process again.)
10. Press “Cancel” button to stop the machine at any time.
Please store the vacuumed items properly. All perishable foods must be
refrigerated or frozen to prevent spoilage.
5
EN
Telephone Helpline: 1300225960
Cleaning, Care & Maintenance
Always allow to cool before cleaning.
WARNING: Do not allow any water to spill into the appliance when cleaning.
Use warm, soapy water and a damp cloth to clean the appliance.
Dry thoroughly after cleaning.
Troubleshooting
A qualified technician should carry out repairs if required.
Fault Probable Cause Solution
The appliance is
not working
The unit is not switched on Check the unit is plugged in correctly and
switched on
Plug or lead is damaged Replace plug or lead
Mains power supply fault Check mains power supply
Appliance does
not remove all
the air from the
bag
Bag not correctly positioned Open lid and reposition bag
Open end of bag is dirty Clean bag
Bag may be punctured Replace bag
Incorrect bags used Use correct bags
Bags are not
sealing correctly
Moisture in bag under the sealing
bar
Ensure inside of the bag is dry and free from
moisture where it is to be sealed
Incorrect bags used Use correct bags
End of bag not placed above sealing
bar
Move end of bag over sealing bar
Sealing Bar requires replacement Replace the Sealing Bar
Error message
E1 in Digital
Display
Lid in poor contact with chamber Clean lid gasket and chamber
Lid Gasket distorted or broken Replace the lid gasket
Internal system leak Call APURO agent or qualified technician
Error message
E2 in Digital
Display
Safety switch / electronic fault Call APURO agent or qualified technician
NOTE: Sealing bar replacement is not covered under warranty
6
EN Telephone Helpline: 1300225960
Technical Specifications
Model Voltage Power Current Vacuum Pressure
(approx.)
Dimensions
h x w x d mm
Weight
(kg)
CD969-A 220-240V~
50Hz
350W 1.5A -950mbar 270 x 415 x 410 12.6
Electrical Wiring
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:
Live wire (coloured brown) to terminal marked L
Neutral wire (coloured blue) to terminal marked N
Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency
disconnection being required they must be readily accessible.
Compliance
The product must not be disposed of as household waste. To help prevent possible harm to human
health and/or the environment, the product must be disposed of in an approved and environmentally safe
recycling process. For further information on how to dispose of this product correctly, contact the product
supplier, or the local authority responsible for waste disposal in your area.
APURO parts have undergone strict product testing in order to comply with regulatory
standards and specifications set by international, independent, and federal authorities.
APURO products have been approved to carry the following symbol:
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic,
mechanical, photocopying, recording or otherwise, without the prior written permission of APURO.
Every effort is made to ensure all details are correct at the time of going to press, however, APURO reserve the right to
change specifications without notice.
DECLARATION OF CONFORMITY
Conformiteitsverklaring Déclaration de conformité Konformitätserklärung Dichiarazione di conformità
Declaración de conformidad Declaração de conformidade
Equipment Type Uitrustingstype • Type d'équipement Gerätetyp
Tipo di apparecchiatura Tipo de equipo Tipo de equipamento
Model Modèle Modell Modello
Modelo Malli
Chamber Vacuum Pack Machine
CD969 -A
Application of Territory Legislation &
Council Directives(s)
Toepassing van Europese Richtlijn(en) •
Application de la/des directive(s) du
Conseil Anwendbare EU-Richtlinie(n) •
Applicazione delle Direttive
• Aplicación de la(s) directiva(s) del
consejo Aplicação de directiva(s) do
Conselho
Electrical safety
IEC 60335-1:2010 +A1:2013 +A2:2016
IEC 60335-2-45:2002 +A1:2008 +A2:2011
EN 62233:2008
Electro-Magnetic Compatibility
EN 55014-1:2017 +A11:2020
EN 55014-2:2015
EN IEC 61000-3-2:2020
EN 61000-3-3:2013 +A1:2019
Producer Name Naam fabrikant Nom du producteur Name des Herstellers
Nome del produttore Nombre del fabricante Nome do fabricante
Apuro
I, the undersigned, hereby declare that the equipment specified above conforms to the above Territory Legislation, Directive(s)
and Standard(s).
Ik, de ondergetekende, verklaar hierbij dat de hierboven gespecificeerde uitrusting goedgekeurd is volgens de bovenstaande
Richtlijn(en) en Standaard(en).
Je soussigné, confirme la conformité de l'équipement cité dans la présente à la / aux Directive(s) et Norme(s) ci-dessus
Ich, der/die Unterzeichnende, erkläre hiermit, dass das oben angegebene Gerät der/den oben angeführten Richtlinie(n) und
Norm(en) entspricht.
Il sottoscritto dichiara che l'apparecchiatura di sopra specificata è conforme alle Direttive e agli Standard sopra riportati.
El abajo firmante declara por la presente que el equipo arriba especificado está en conformidad con la(s) directiva(s) y
estándar(es) arriba mencionadas.
Eu, o abaixo-assinado, declaro que o equipamento anteriormente especificado está em conformidade com a(s) anterior(es)
Directiva(s) e Norma(s)
Date • Data • Date • Datum • Data •
Fecha • Data
10th August 2021
Signature Handtekening • Signature
Unterschrift Firma • Firma •
Assinatura
Full Name Volledige naam • Nom et
prénom Vollständiger Name • Nome
completo Nombre completo Nome
por extenso
Ashley Hooper
Position Functie Fonction • Position
Qualifica Posición Função
Technical & Quality Manager
Supplier
Producer Address • Adres fabrikant •
Adresse du producteur • Anschrift des
Herstellers • Indirizzo del produttore •
Dirección del fabricante • Morada do
fabricante
Fourth Way,
Avonmouth,
Bristol,
BS11 8TB
United Kingdom
Campbelltown
NSW 2560
DocuSign Envelope ID: 3ABE5FDC-D764-4055-A55F-EE3D6052BFCD
CD969-A_A5_v4_20220321
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

APURO CD969-A Manuel utilisateur

Catégorie
Scelleuses sous vide
Taper
Manuel utilisateur

dans d''autres langues