3454B 04172020

701 Millennium Blvd. | Greenville, SC 29607 | (864) 678-1000 | www.hubbellcontrolsolutions.com

Copyright © 2020 Hubbell Control Solutions, a division of Hubbell Lighting, Inc. All rights reserved. All product and company names, logos

and product identiers are trademarks ™ or registered trademarks ® of Hubbell Lighting, Inc. or their respective owners. Use of them does not

necessarily imply any aliation with or endorsement by such respective owners.

NX™ Bluetooth® Radio Module

PRECAUTIONS

• Read and understand all instructions before beginning installation.

1. Plug the Bluetooth radio module into a SmartPORT™ on the Room Controller or a Smart Switch. Make certain that you hear a distinct “click” as the

RJ-45 connector locks into the socket.

2. If the Bluetooth module is being installed behind a Smart Switch, be careful to guide the module into the clear space in the box behind the switch

as the screws are tightened.

3. Contact HCS Technical Support for instructions on obtaining and installing the Smart Phone App

4. When the App is started, any modules in range will be discovered and appear on the screen. If several modules are installed, it is likely that you

will discover more than one. Each discovered room will include a signal strength indicator. This can be useful in identifying the local room.

5. Touch the room to which you wish to connect.

6. Consult the NX Smart Phone Wireless App Operation Guide for instructions on using the App to set up and congure the lighting controls in

the zone.

2. This device must accept any interference received, including interference that may cause undesired operation

Changes or modications not approved by Hubbell Control Solutions could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful interference in a commercial installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio

communications.

This device complies with Industry Canada license exempt RSS standard(s). Operation is subject to the following two conditions:

under license. Other trademarks and trade names are those of their respective owners.