Keeson Technology RF406 Remote Control Manuel utilisateur

Marque
Keeson Technology
Modèle
RF406 Remote Control
Taper
Manuel utilisateur
2021-09-23
Hervey
1.0
Page 1 of 5
RF406 User Manual
1. Function Picture
Massage Head
Massage Timer
Antisnore
TV/PC
Lounge
UBB
Foot down
Foot up
Massage Foot
Head down
Head up
Massage timer led
ZeroG
Allflat
Music
1 / 5
2021-09-23
Hervey
1.0
Page 2 of 5
ITEM
1.1 Massage head test
Click massage head button, the head massage motor switches the massage intensity, and the
massage intensity cycles between 0-1-3-6;
1.2 Massage foot test
Click massage foot button, the foot massage motor switches the massage intensity, and the
massage intensity cycles between 0-1-3-6;
1.3 Massage timer test
Click the massage timer button to switch the massage motor massage time, and the massage
time will cycle between 0-10min-20min-30min;
1.4 Head Lift +
Press and maintain, head lift stretches out
1.5 Head Lift -
Press and maintain, head lift retracts
1.6 Foot Lift +
Press and maintain, foot lift stretches out
1.7 Foot Lift -
Press and maintain, foot lift retracts
2 / 5
2021-09-23
Hervey
1.0
Page 3 of 5
1.8 UBB tese
Click UBB button , UBB will turn on, click again to turn it off;
1.9 zeroG button test
Click zeroG button, then actuator will move to zeroGposition, during the movement, click any
button to stop it;
1.10 Anti-Snore test
Click Anti-Snore butoon, actuator will move in to Anti-Snore position;
1.11 Lounge test
Click Lounge butoon, actuator will move in to Lounge position;
1.12 TV/PC test
Click TV/PC butoon, actuator will move in to TV/PC position;
1.13 mUSIC test
Click Music butoon, actuator will move in to Music position;
1.14 FLAT test
Click FLAT butoon, actuator will move in to lowest position;
3 / 5
2021-09-23
Hervey
1.0
Page 4 of 5
2.1 For pairing
Button is inside the battery cover for pairing.
Federal Communications Commission (FCC) Statement
You are cautioned that changes or modifications not expressly approved by the part responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received, including interference that may cause
undesired operation of the device.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
4 / 5
for pairing
2021-09-23
Hervey
1.0
Page 5 of 5
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
Canada, Industry Canada (IC) Statement
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of the device.
Le present appareil est conforme aux CNR d'Industrie Canada applicables auxappareils radio
exempts de licence.L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage adioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
5 / 5
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5

Keeson Technology RF406 Remote Control Manuel utilisateur

Marque
Keeson Technology
Modèle
RF406 Remote Control
Taper
Manuel utilisateur
Télécharger le PDF
rapport

dans d''autres langues

Autres documents