Lenco DVP-947BK Le manuel du propriétaire

DVP-947 BK

Bluetooth

DVP-947BK

/STOP long press is STOP

Charging the headphone ba ery

Remark:

not be used then.

the headphone and the USB connector to an USB charger (not included) or a PC but you can also use

the USB port of the DVD player (ONLY if the DVD player is powered by the supplied AC adaptor or

Car adaptor).

- To avoid that the DVD player can’t ﬁnd your Bluetooth headphone, please disable the

low power and must be charged.

- if you ﬁnd the max headphone level is too low, please increase the volume level on the DVD

player itself.

Connect the DVD Player with the included Bluetooth Headphone

Please follow the below steps to connect your DVD player with the Bluetooth headphone:

1. Press and hold the Power bu

on of Bluetooth headphone and release it when you hear the “

power on” message from the headphone. The headphones power led will ﬂash red/bl

ue.

2. Press the SETUP bu

on on the remote control and navigate to the AUDIO SETUP PAGE,

Go to the BLUETOOTH op

on and switch it

o ON. A Blu

etooth

icon will be displayed on

the right corner of

3. Now go to the SEARCH DEVICE op

on, choose SEARCH and then press the ENTER bu on on

the remote control to ini

te the Bluetooth device search. The player now will show

"Searching...".

4. When "Searching..." is disappeared from the screen, the Bluetooth icon is changed to

you’ll hear a short beep from the headphone and the headphone’s power led will stop

ﬂashing red/blue.

The DVD player is now connected with the Bluetooth headphone.

A on:

t

the screen.

,

en

Last Memory

ON ON

OFF

Last Memory

stopped, powered down or dvd was reinserted.

OFF

ON

BLUETOOTH

GO TO AUDIO SETUP PAGE

SEARCH DEVICE

Enable/Disable the Bluetooth funcon of the DVD player. A Bluetooth icon will be shown in

The right corner of the player if the Bluetooth funcon is enabled.

When selected, the DVD player will search for available Bluetooth devices which are in paring mode.

If the Bluetooth connecon is successfully made, the displayed icon will change to

you can also use other Bluetooth devices like Bluetooth speakers, a Bluetooth car radio or Bluetooth

HiFi set.

Search Device

Remark:

Bluetooth

If you drive for more than 4 hours, do not forget to take the AUX cable and USB cable.

When the headphonehas no power, you can either recharge it through the USB connector

of the DVD player, or you can plug the AUX (3.5mm) cable in your headphone and DVD player

and enjoy the movies without Bluetooth.

Remark:

DVD player

BT Headphone

Baery : Lithium 7.4V 1000mAh

Baery: Lithium 3.7V 250mAh

Playme: ~ 2 hours in D VD mode on

Playme: ~3.5 – 4.5 hours

Charge me: ~3-4h

Charge me: ~1.5h

DVP-947BK

/STOP

Lang indrukken is STOPPEN

La page est en cours de chargement...

Lenco DVP-947BK Le manuel du propriétaire

Lenco DVP-947BK Le manuel du propriétaire

dans d''autres langues

Documents connexes

Autres documents