Atel FJ1510MA Manuel utilisateur

Taper
Manuel utilisateur
Page | 1
FJ1510MUserMannual
1 Plug in the test wire
Plugthe test wire of TM97 into the device as follows:
1 Start the device
To power the device, a 12V adapter is plugged directly into the DC female head of the test line.
The green light of the device will flash to represent the power on.
Page | 2
2 SIM card (4FF micro SIM size) installation
a. Open the top plasticThen unscrew the three screws and take the machine out and
turn it around.
as shown below
Page | 3
6
FCCStatement
Thisdevicecomplieswithpart15oftheFCCRules.Operationissubjecttothefollowingtwoconditions:(1)
Thisdevicemaynotcauseharmfulinterference,and(2)thisdevicemustacceptanyinterferencereceived,
includinginterferencethatmaycauseundesiredoperation.Thisequipmenthasbeentestedandfoundto
complywiththelimitsforaClassBdigitaldevice,pursuanttopart15oftheFCCRules.Theselimitsare
designedtoprovidereasonableprotectionagainstharmfulinterferenceinaresidentialinstallation.This
equipmentgenerates,usesandcanradiateradiofrequencyenergyand,ifnotinstalledandusedin
accordancewiththeinstructions,maycauseharmfulinterferencetoradiocommunications.However,there
isnoguaranteethatinterferencewillnotoccurinaparticularinstallation.Ifthisequipmentdoescause
harmfulinterferencetoradioortelevisionreception,whichcanbedeterminedbyturningtheequipmentoff
andon,theuserisencouragedtotrytocorrecttheinterferencebyoneormoreofthefollowingmeasures:
Reorientorrelocatethereceivingantenna.
Increasetheseparationbetweentheequipmentandreceiver.
Connecttheequipmentintoanoutletonacircuitdifferentfromthattowhichthereceiverisconnected.
Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
 Changesormodificationsnotexpresslyapprovedbythemanufacturercouldvoidtheuser’sauthorityto
operatetheequipment.
FCC RF Radiation Exposure Statement
ThisequipmentcomplieswithFCCradiationexposurelimitssetforthforanuncontrolledenvironment.To
complywithFCCRFExposurecompliancerequirements,thisgrantisapplicabletoonlyMobile
Configurations.Theantennasusedforthetransmittermustbeinstalledtoprovideaseparationdistanceof
atleast20cmfromallpersonsandmustnotbecolocatedoroperatinginconjunctionwithanyother
antennaortransmitter.
ISED Warning statements
This device complies with Canada's licence-exempt RSSs. Operation is subject to the following
two conditions:
(l) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Le présentappareilestconforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence.
L'exploitationestautorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de
brouillage, et (2) l'utilisateur de
l'appareildoit accepter tout brouillageradioélectriquesubi, mêmesi le brouillageest susceptible
d'encompromettre le fonctionnement.
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled
environment. This equipment should be
installed and operated with a minimum distance of 20cm between the radiator and any part of
your body.
Pour se conformer aux exigences de conformité CNR 102 RF exposition, une distance de
séparationd'aumoins 20 cm doitêtremaintenue
entre l'antenne de cetappareilettoutes les personnes.
This Class B digital apparatus complies with Canadian ICES-003.
Cetappareilnumeriquede la classe B estconforme a la norme NMB-003 du Canada.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5

Atel FJ1510MA Manuel utilisateur

Taper
Manuel utilisateur

dans d''autres langues