Philips S3134/51 Manuel utilisateur

S3000 Series

2

1

3

9

12

13

11

5 6

4

7

10

8

empty page before TOC

English 6

Français (Canada) 25

English

Contents

General description (Fig. 1)_______________________________________ 6

Introduction_______________________________________________________ 7

Important safety information_____________________________________ 7

The display________________________________________________________ 9

Charging___________________________________________________________ 10

Using the appliance______________________________________________ 12

Shaving____________________________________________________________ 13

Trimming__________________________________________________________ 15

Cleaning and maintenance_______________________________________ 15

Replacement______________________________________________________ 19

Storage____________________________________________________________ 21

Ordering accessories_____________________________________________ 21

Recycling__________________________________________________________ 21

Removing the rechargeable shaver battery_____________________ 22

Warranty and support____________________________________________ 24

General description (Fig. 1)

1 Protection cap

2 Shaving unit

3 Shaving unit release button

4 On/off button

5 1-Level battery status indicator (S3133,

S3134only)

6 3-Level battery status indicator (S3233, S3332,

S3333 only)

7 Socket for small plug

8 Charging stand (S3332, S3333 only)

9 Pop-up trimmer

10 Trimmer release slide

11 Supply unit

12 Small plug

13 Storage pouch (S3232, S3332, S3333 only)

6

English

Introduction

Congratulations on your purchase and welcome to

Philips! To fully benefit from the support that

Philips offers, register your product at

www.philips.com/welcome.

Important safety information

Read this important information carefully before

you use the appliance and save it for future

reference.

Danger

- Keep the supply unit dry.

Warning

- To charge the battery, only use the detachable

supply unit (type HQ8505) provided with the

appliance.

- The supply unit contains a transformer. Do not

cut off the supply unit to replace it with another

plug, as this causes a hazardous situation.

- This appliance can be used by children aged

from 8 years and above and persons with

reduced physical, sensory or mental capabilities

or lack of experience and knowledge if they

have been given supervision or instruction

concerning use of the appliance in a safe way

and understand the hazards involved. Children

shall not play with the appliance. Cleaning and

user maintenance shall not be made by

children without supervision.

7

English

- Always unplug the shaver before you clean it

under the tap.

- Always check the appliance before you use it.

Do not use the appliance if it is damaged, as

this may cause injury. Always replace a

damaged part with one of the original type.

- Do not open the appliance to replace the

rechargeable battery.

Caution

- This appliance contains batteries that are non-

replaceable.

- Never immerse the charging stand in water and

do not rinse it under the tap.

- Never use water hotter than 60°C to rinse the

shaver.

- Only use this appliance for its intended purpose

as shown in the user manual.

- For hygienic reasons, the appliance should only

be used by one person.

- Never use compressed air, scouring pads,

abrasive cleaning agents or aggressive liquids

such as petrol or acetone to clean the

appliance.

- Water may drip from the socket at the bottom

of the shaver when you rinse it. This is normal

and not dangerous because all electronics are

enclosed in a sealed power unit inside the

shaver.

- Do not use the supply unit in or near wall

sockets that contain an electric air freshener to

prevent irreparable damage to the supply unit.

Electromagnetic fields (EMF)

This Philips appliance complies with all applicable

standards and regulations regarding exposure to

electromagnetic fields.

8

English

General

- This shaver is waterproof. It is suitable for use in

the bath or shower and for cleaning under the

tap. For safety reasons, the shaver can

therefore only be used without cord.

- The supply unit is suitable for mains voltages

ranging from 100 to 240 volts.

- The supply unit transforms 100-240 volts to a

safe low voltage of less than 24 volts.

The display

S3133, S3134

Battery fully charged

When the battery is fully charged, the charging

light lights up white continuously.

Note: After approx. 30 minutes, the charging light

goes out to save energy.

Battery low

=

When the battery is almost empty, the charging

light flashes orange.

When you switch off the appliance, the charging

light continues to flash orange for a few seconds.

Charging

When the shaver is charging, the charging light

flashes white.

9

English

S3232, S3332, S3333

Battery fully charged

When the battery is fully charged, all charging

lights light up white continuously.

Note: After approx. 30 minutes, the charging lights

go out to save energy.

Battery low

=

When the battery is almost empty, the bottom

charging light flashes orange.

When you switch off the appliance, the bottom

charging light continues to flash orange for a few

seconds.

Charging

When the shaver is charging, first the bottom light

of the battery charge indicator flashes, then the

second light, and so on until the shaver is fully

charged.

When the appliance is charging, first the bottom

light flashes, then the middle light, and so on until

the appliance is fully charged.

Charging

Charge the shaver before you use it for the first

time and when the display indicates that the

battery is almost empty.

10

English

Charging takes approx. 1 hour. A fully charged

shaver has a shaving time of up to 60 minutes.

This shaver is suitable for use in the bath or

shower. For safety reasons, it is therefore

not possible to use the shaver while it is

connected to the power outlet for charging.

Note: Depending on your shaving/styling behavior

and beard type, the operating time may vary over

time.

Charging with the supply unit

1 Put the small plug in the appliance.

2 Put the supply unit in the wall socket.

- The charging light shows the charging status of

the appliance.

3 After charging, remove the supply unit from the

wall socket and pull the small plug out of the

appliance.

Charging with charging stand (S3332, S3333 only)

1 Connect the small plug of the cord into the

charging stand. Connect the supply unit into

any 100V to 240V outlet. Use only the power

cord provided.

2 Place the shaver in the stand in an upright

position making sure charging contacts in the

bottom of stand fit into recess in bottom of the

shaver.

- The display on the shaver will indicate the

shaver is charging.

3 After charging, remove the shaver from the

stand by lifting straight up. Do not tilt the

shaver.

11

English

Quick charge

When you start charging the empty battery, the

charging light flashes white quickly. After approx. 5

minutes the charging light flashes white slowly. The

shaver now contains enough energy for a

5-minute shave.

Using the appliance

Note: This appliance is waterproof. It is suitable for

use in the bath or shower and for cleaning under

the tap. For safety reasons, this appliance can

therefore only be used without cord.

This symbol indicates that the shaver can be used

in the bath or shower.

Shaving tips and tricks

- Make circular movements during use. Circular

movements provide better shaving results than

straight movements.

- Your skin may need 2 or 3 weeks to get

accustomed to the Philips shaving system.

Switching the appliance on and off

To switch the appliance on or off, press the on/off

button once.

12

English

Shaving

Dry shaving

Note: For the best results on skin comfort, pre-

trim your beard if you have not shaved for 3

days or longer.

1 Switch on the appliance.

2 Move the shaving heads over your skin in

circular movements to catch all hairs growing in

different directions.

3 Stretch your skin with your free hand so the

blades can lift and cut hair. Gently press the

shaver onto you skin so the floating heads can

follow the contours of your face.

Note: Do not press too hard as too much

pressure can cause shaving heads to pinch the

skin.

4 Switch off and clean the appliance after each

use.

5 Put the protective cap on the appliance to

protect the shaving heads during storage and

travel.

Wet shaving

For a more comfortable shave, you can also use

this appliance on a wet face with shaving foam or

shaving gel.

13

English

1 Apply some water to your skin.

2 Apply shaving foam or gel to your skin.

3 Rinse the shaving unit under the tap to ensure

that it glides smoothly over your skin.

4 Switch on the appliance.

5 Move the shaving heads over your skin in

circular movements to catch all hairs growing in

different directions. Make sure each shaving

head is fully in contact with the skin. Exert

gentle pressure for a close, comfortable shave.

Note: Do not press too hard, this can cause skin

irritation.

Note: Rinse the shaving unit regularly to ensure

that it continues to glide smoothly over your

skin.

6 Switch off and clean the appliance after each

use.

7 Dry your face.

Note: Make sure that you rinse all foam or

shaving gel off the appliance with warm water.

14

English

8 Put the protective cap on the appliance to

protect the shaving heads during storage and

travel.

Trimming

You can use the trimmer to groom your sideburns

and moustache.

1 Push the trimmer release slide downwards to

open the trimmer.

2 Switch on the appliance.

3 Hold the trimmer perpendicular to the skin and

move the appliance downwards while you exert

gentle pressure.

4 Switch off and clean the trimmer after each use.

5 Close the pop-up trimmer (‘click’).

Cleaning and maintenance

Cleaning the shaver

Caution: Never use compressed air, scouring

pads, abrasive cleaning agents or aggressive

liquids such as petrol or acetone to clean the

appliance.

Clean the shaver after every use for optimal

performance (see 'Cleaning and maintenance').

15

English

Caution: While rinsing the shaving heads, water

may drip out of the base of the appliance. This is

a normal occurrence. Internal electric parts are in

a waterproof compartment so the appliance will

be protected against water damage.

1 Switch off the appliance and make sure it is

disconnected from the wall socket.

2 Press the release button to open the shaving

unit.

3 Rinse the shaving unit and hair chamber with

lukewarm water.

4 Rinse the outside of the shaving unit with

lukewarm water.

Never dry the shaving unit with a towel or

tissue, as this may damage the shaving heads.

5 Carefully shake off excess water and let air dry

completely.

6 Close the shaving unit.

Cleaning the pop-up trimmer

Clean the pop-up trimmer after each use.

Never dry the trimmer teeth with a towel or

tissue, as this may damage the trimmer teeth.

1 Switch off the appliance and make sure it is

disconnected from the wall socket.

16

English

2 Push the trimmer release slide downwards to

open the trimmer.

3 Switch on the appliance and rinse the pop-up

trimmer with warm water.

4 After cleaning, switch off the appliance.

5 Carefully shake off excess water and let the

pop-up trimmer air dry.

6 Close the pop-up trimmer (‘click’).

Tip: For optimal performance, lubricate the teeth

of the pop-up trimmer with a drop of mineral oil

every six months (oil not included).

Thorough cleaning

Clean the shaving heads thoroughly once a month

for optimal performance.

1 Switch off the appliance and make sure it is

disconnected from the wall socket.

2 Press the release button to open the shaving

unit. Pull the shaving unit off the appliance.

2

1

3 Turn the lock anticlockwise (1) and remove the

retaining frame (2). Place it aside in a safe place.

17

English

4 Remove and clean one shaving head at a time.

Each shaving head consists of a cutter and a

guard.

Note: Do not clean more than one cutter and

guard at a time, since they are all matching sets.

If you accidentally mix up the cutters and

guards, it may take several weeks before

optimal shaving performance is restored.

5 Remove the cutter from the shaving guard and

clean both parts under the tap.

6 Put the cutter back into the guard.

7 Put the shaving heads back into the shaving

unit.

18

English

1

2

8 Put the retaining frame back into the shaving

unit (1) and turn the lock clockwise (2).

9 Insert the hinge of the shaving unit into the slot

in the top of the shaver. Then close the shaving

unit.

Note: If the shaving unit does not close

smoothly, check if you have inserted the

shaving heads properly and if the retaining

frame is locked.

Replacement

Replacing the shaving heads

For maximum shaving performance, we advise you

to replace the shaving heads every two years.

Replace damaged shaving heads immediately.

Always replace the shaving heads with original

Philips shaving heads (see 'Ordering accessories').

1 Switch off the appliance and make sure it is

disconnected from the wall socket.

2 Press the shaving unit release button to open

the shaving unit. Pull the shaving unit off the

appliance.

2

1

3 Turn the lock anticlockwise (1) and remove the

retaining frame (2). Place it aside in a safe place.

19

English

4 Remove the shaving heads from the shaving

unit.

Discard the used shaving heads immediately to

avoid mixing them with the new shaving heads.

5 Place new shaving heads in the shaving unit.

Note: Make sure that the shaving heads with

the projections fit exactly onto the hooks of the

shaving head holder when placing them. The

shaving heads supplied with the shaver either

have notches or projections. Both shaving

systems are the same.

1

2

6 Put the retaining frame back into the shaving

unit (1) and turn the lock clockwise (2).

7 Insert the hinge of the shaving unit into the slot

in the top of the shaver. Then close the shaving

unit.

Note: If the shaving unit does not close

smoothly, check if you have inserted the

shaving heads properly and if the retaining

frame is locked.

20

English

La page est en cours de chargement...

Philips S3134/51 Manuel utilisateur

Philips S3134/51 Manuel utilisateur

dans d''autres langues

Documents connexes

Autres documents