ClimateMaster AST014 - Remote Wireless Sensor Le manuel du propriétaire

Marque: ClimateMaster

Modèle: AST014 - Remote Wireless Sensor

Taper: Le manuel du propriétaire

model: AST014

Wireless Temperature Sensor

Installation Instructions

Before you begin the installation:

The ClimateMaster Congurator App is needed to congure this

sensor. This App may be downloaded from your mobile device store.

Select a suitable location for the ACC-TSENWIFIMINI sensor. Please

note that the sensor must have good Wi-Fi reception with the access

point it is intended to join. Do not mount in direct sun or direct rain.

Please have handy the Owner’s Manual for the thermostat that will be

paired with the sensor. ClimateMaster thermostats have unique pairing

procedures.

OVERVIEW

This wireless temperature sensor may be used as a room remote temperature sensor or an outdoor temperature sensor.

Thermostats vary by model in the way they can use remote sensors. This includes averaging, control to, or monitoring features.

Please consult the Owner’s Manual of the thermostat that you are going to pair this sensor with to understand its capabilities and

pairing procedure.

Note: This sensor must be connected to the same local network as the thermostat(s) that will use the sensor data.

Congurator

app icon

g. 1

Unit ID

Legend

g. 2

To Connect the Sensor to an Access Point:

1. Remove sensor cover.

2. Congure the Sensor. (use g. 2 as a guide)

A Set the Type:

1. Indoor temperature is sampled and transmitted once every minute.

2. Outdoor temperature is sampled and transmitted once every 5 minutes.

B Set the Unit ID:

If more than one sensor is joined to an access point

each sensor must have a unique UNIT ID# to operate properly.

Add all of the ID ’ON’ switches together to arrive at the Unit ID#.

If all the ID number switches are set to ‘OFF’ then the Unit ID# is 0 (zero).

Up to 8 sensors may be joined to one access point.

OFF

124

Example: Unit ID# 5

1 + 4 = 5

Specications

Operational Temperature

• with alkaline batteries: 0° F - 120° F

• with lithium batteries: -20° F - 130° F

• temperature measurement range: -20˚F - 120˚F

Expected Battery Life

• Indoor Sensor sample rate of 1per minute: > 1 year*

*Assumes strong, constant Wi-Fi signal strength and connection

3. Install 2 AAA batteries with the polarity as indicated on the sensor housing. (see g. 3).

a. Alkaline batteries are acceptable for operation in the temperature range

of 0˚F to 120˚F.

b. When operating between -20˚F to 130˚F it is recommended to use

good quality Lithium AAA batteries.

4. Press and hold the Link button (see g. 3) until the Link LED starts to ash.

5. Use the ClimateMaster Congurator App to setup the Wi-Fi connection.

a. Select the Wi-Fi Temperature Sensor Mini. in the Congurator App.

b. Select “Setup Wi-Fi”

c. Follow the Wi-Fi setup instructions on the Congurator App.

Notes:

• The LED will stay solid while connecting to the access point.

• If the connection is successful the LED will turn off.

• IftheconnectionisunsuccessfultheLEDwillash5times.

• If the App detects that the sensor rmware is not up to date, then the user

will be prompted and instructed how to update the sensor’s rmware.

(continued from page 1)

g. 3

When mounting outdoors (g 4)

· Install gasket as shown between wall and sensor

· Keep out of direct sunlight

· Keep out of direct rain

An ideal outdoor mounting location would be in a covered outdoor patio or

protected by an awning or eave from the elements.

Use the included screw to secure the cover to the sensor.

sensor

gasket

wall

g. 4

Link

button

Link

LED

P/N 88-1391 11/19 Rev. 1 - Patents Pending Wireless Temperature Sensor AST014

FCC Compliance Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one

or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that of the receiver.

• Consult the dealer or an experienced radio or TV technician for help.

Notice: Only peripherals complying with FCC limits may be attached to this equipment. Operation with noncompliant peripherals or peripherals not recommended by ClimateMaster, is

likely to result in interference to radio and TV reception. Changes or modications to the product, not expressly approved by ClimateMaster could void the user’s authority to operate the

equipment.

FCC - INDOOR Mobile Radio Information:

To comply with FCC/IC RF exposure limits for general population / uncontrolled exposure, the antenna(s) used for this transmitter must be installed to provide a separation distance of at

least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.

This Device complies with Industry Canada License-exempt RSS standard(s). Operation is subject to the following two conditions: 1) this device may not cause interference, and 2) this

device must accept any interference, including interference that may cause undesired operation of the device.

Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada.

To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that

necessary for successful communication.

Cet appareil est conforme avec Industrie Canada, exempts de licence standard RSS(s). Son fonctionnement est soumis aux deux conditions suivantes: 1) ce dispositif ne doit pas causer

d’interférences, et 2) ce dispositif doit accepter toute interférence, y compris les interférences qui peuvent causer un mauvais fonctionnement de l’appareil.

En vertu des règlements d’Industrie Canada, cet émetteur de radio ne peut fonctionner en utilisant une antenne d’un type et maximale (ou moins) Gain approuvé pour l’émetteur par

Industrie Canada. Pour réduire les interférences radio potentielles aux autres utilisateurs, le type d’antenne et son gain doivent être choisis an que la puissance isotrope rayonnée

équivalente (PIRE) ne est pas plus de ce qui est nécessaire pour une communication réussie.

We, ClimateMaster, declare under our sole responsibility that the device to which this declaration relates: Complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

FCC ID: MUH-SEN7

IC: 12547A-SEN7

Warranty

One-Year Warranty - This Product is warranted to be free from defects in material and workmanship. If it appears within one year from the date of original installation, whether or not actual use

begins on that date, that the product does not meet this warranty, a new or remanufactured part, at the manufacturer’s sole option to replace any defective part, will be provided without charge

for the part itself provided the defective part is returned to the distributor through a qualied servicing dealer.

THIS WARRANTY DOES NOT INCLUDE LABOR OR OTHER COSTS incurred for diagnosing, repairing, removing, installing, shipping, servicing or handling of either defective parts or

replacement parts. Such costs may be covered by a separate warranty provided by the installer.

THIS WARRANTY APPLIES ONLY TO PRODUCTS IN THEIR ORIGINAL INSTALLATION LOCATION AND BECOMES VOID UPON REINSTALLATION.

LIMITATIONS OF WARRANTIES – ALL IMPLIED WARRANTIES (INCLUDING IMPLIED WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE AND MERCHANTABILITY) ARE HEREBY

LIMITED IN DURATION TO THE PERIOD FOR WHICH THE LIMITED WARRANTY IS GIVEN. SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY

LASTS, SO THE ABOVE MAY NOT APPLY TO YOU. THE EXPRESSED WARRANTIES MADE IN THIS WARRANTY ARE EXCLUSIVE AND MAY NOT BE ALTERED, ENLARGED, OR CHANGED

BY ANY DISTRIBUTOR, DEALER, OR OTHER PERSON WHATSOEVER.

ALL WORK UNDER THE TERMS OF THIS WARRANTY SHALL BE PERFORMED DURING NORMAL WORKING HOURS. ALL REPLACEMENT PARTS, WHETHER NEW OR

REMANUFACTURED, ASSUME AS THEIR WARRANTY PERIOD ONLY THE REMAINING TIME PERIOD OF THIS WARRANTY.

THE MANUFACTURER WILL NOT BE RESPONSIBLE FOR:

1. Normal maintenance as outlined in the installation and servicing instructions or owner’s manual, including lter cleaning and/or replacement and lubrication.

2. Damage or repairs required as a consequence of faulty installation, misapplication, abuse, improper servicing, unauthorized alteration or improper operation.

3. Failure to start due to voltage conditions, blown fuses, open circuit breakers or other damages due to the inadequacy or interruption of electrical service.

4. Damage as a result of oods, winds, res, lightning, accidents, corrosive environments or other conditions beyond the control of the Manufacturer.

5. Parts not supplied or designated by the Manufacturer, or damages resulting from their use.

6. Manufacturer products installed outside the continental U.S.A., Alaska, Hawaii, and Canada.

7. Electricity or fuel costs or increases in electricity or fuel costs for any reason whatsoever including additional or unusual use of supplemental electric heat.

8. ANY SPECIAL INDIRECT OR CONSEQUENTIAL PROPERTY OR COMMERCIAL DAMAGE OF ANY NATURE WHATSOEVER. Some states do not allow the exclusion of incidental or

consequential damages, so the above may not apply to you.

This warranty gives you specic legal rights and you may also have other rights which may vary from state to state.

Innovation, Science and Economic Development Canada

ICES-003 Compliance Label: CAN ICES-3 (B)/NM8-3(B)