Regulatory Notices
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
2. Changes or modications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device
can be used in portable exposure condition without restriction.
FCC ID: 2AF6U-F3728A
EU (European Union) Declaration of Conformity with Regard to the EU Directive
1999/5/EC
Fitness Cubed Inc is authorized to apply the CE Mark on Cubii, Model F3A1, thereby
declaring conformity to the essential requirements and other relevant provisions of
Directive 1999/5/EC.
Compliant with the standard R&TTE 99/CE/05
® Trademark of Fitness Cubed Inc. Registered in the US.
Patent No. D793,494 U.S. 9713739 B2
14
IV. General Information
Version: JR2OMRD1