6
STYG 2000 A2
GB
IE
Assembly and setting up
WARNING! RISK OF FIRE!
► Never place the appliance underneath wall
cupboards or next to curtains, cupboard
walls or other fl ammable objects.
► Place the appliance only on a heat-resistant
surface.
1) Take all the parts out of the box and remove
the packaging material and any protective
wrapping.
2) Clean all of the components as described in
the section “Cleaning and care”. Ensure that
all parts are completely dry.
3) Place the appliance on a heat-resistant, clean
and level surface. Ensure that you do not
place the appliance directly next to a wall or
a cupboard.
4) Push the fat drip tray 3 into the guide rails on
the underside of the appliance.
5) Push the thermostat 5 into the socket 1 on
the appliance. Ensure that the temperature
regulator 7 is always set to “0” before you
connect the thermostat to the socket 1.
6) Insert the plug into a mains power socket.
Before fi rst use
1) Lightly grease the griddle 4 with fat or oil that
is suitable for baking/grilling.
This allows any cooking residues on the griddle 4
to be more easily removed.
2) Set the thermostat 5 to level 5 and allow
the appliance to heat up for 5 minutes.
3) After 5 minutes,turn the temperature regulator 7
back to level 0.
4) Then disconnect the plug and allow the appli-
ance to cool down.
NOTE
►
The fi rst time the appliance heats up a small
amount of smoke and smell may be gener-
ated, caused by production residues. This
is completely normal and is not dangerous.
Ensure suffi cient ventilation; for example,
open a window.
5) Wipe the griddle 4 with a moist cloth. Ensure
that all parts are completely dry before operating
the appliance.
The appliance is now ready for use.
Thermostat settings
Level 0: Grill switched off
Level > 0 - 1: grill switched on;
low temperature
Level 1 - 3: grill switched on; medium
temperature (e.g. vegetables)
Level 3 - 5: grill switched on;
high temperature (e.g. meat)
Operation
WARNING!
THERE IS A RISK OF INJURY!
► Once the appliance is in operation, touch
it only using the handles or the temperature
regulator 7. There is a risk of burns!
Once the fat drip tray 3 has been pushed in, the
thermostat 5 has been connected to the socket 1
and the mains plug has been connected to the
power supply:
1) Adjust the temperature regulator 7 to the de-
sired temperature level. The indicator lamp 6
illuminates. When the set temperature has been
reached, the temperature indicator lamp 6
goes out.
IB_109176_STYG2000A1_SE_DK_BE_NL.indb 6 07.01.15 13:01