User Guide
Bluetooth Connection to Club Booster V2
Power Indicator
RF Connection to Remote Controller
CB Sidekick
Power Switch
Charging Inlet(USB C)
Keypad Lock/Unlock
Follow/Unfollow
Left Turn
Power On/Off, Change Mode
Charging Inlet(USB C)
Go/Speed Up
Right Turn
Gyro On/Off
Remote Controller
Stop
Reverse/Speed Down
Remote Controller
Keypad Lock/Unlock
Sidekick Signal
Follow Mode Indicator
Remote RF Signal
Remote Battery Indicator
Club Booster V2 Status
Setting Up The First Time
StepPair the remote with Club Booster V2
1: Switch on remote - press and hold the "power" button for 3 seconds.
2: Press both the "stop" and "G" button for 3 seconds until the remote
display shows "Remote Pairing".
3: Switch on Club Booster V2, wait 5 seconds. The "RC" sign appears on
the remote display indicates the two are paired successfully.
4. Switch off both devices.
Setting Up The First Time
Step 2: Pair CB Sidekick with Club Booster V2
Switch on Sidekick by pressing and holding the power
button for 3 seconds. Once it is on, press the same
button once, the blue LED flashes rapidly. Switch on
your Club Booster V2 and wait for 10 seconds. The blue
LED then turns solid indicates the two are paired.
Blue LED
Setting Up At the Course
Step 1: Place the mounting on the handle
If you are a right handed golfer, place the mounting
on the left side of the handle. Tighten it by turning
the latch and press down on it.
Latch
Setting Up At the Course
Step 2: Place CB Sidekick onto the mounting
Place the CB sidekick onto the mounting and tighten
it with the knob. Make sure it is as level to the
ground as possible. Rotate it so that the arrow that
says "Cart Direction" points forward.
Knob
Switch on all 3 devices. Press the "FL" button on the remote.
The CB Sidekick starts rotating until it finds the remote's
direction. A slow flashing green LED indicates that it is
standing by. Press "M" to choose between following from the
left, right, or behind. Press "FL" again and the LED turns
flashing red. Walk away and it starts following. Deactivate it
by pressing "FL" or "Stop" buttons.
Green/Red LED
Setting Up At the Course
Step 3: Switch on V2, CB Sidekick, and the remote
Follow Modes
The CB Sidekick is
designed to be used on
fairways. Switch to
remote mode on cart
path and near the
green. It is set to be 6
feet away from the
remote. Place the
remote inside your
pocket or the included
belt clip. Holding the
remote on your hand
makes jerking motion
due to your arm swing.
How to Use
How to Use
When using the CB Sidekick with your friend who also has
one, set one that follows on the left and the other on the right
to avoid collision.
How to Use
Calling-in: you may
ask the cart to
come to you when
you are within the
signal range. The
range depends on
the elevation and
other factors, but it
is typically 30
yards.
Important
Practice on your backyard before using the CB
Sidekick at the golf course.
Plan your path wisely - avoid getting too close
to hazards.
Charge both the CB Sidekick and the remote
controller every time after the round.
Move the handle bar to the highest position
avoids blockage of the signal.
1.
2.
3.
4.
FCC regulatory conformance：
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-Consult the dealer or an experienced radio/TV technician for help
NOTE: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user’s
authority to operate the equipment.
RF Exposure
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
IC regulatory conformance
This device complies with CAN ICES-3 (B)/NMB-3(B).
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Cet appareil est conforme à la norme CAN ICES-3 (B)/NMB-3 (B).
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
RF Exposure
This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment.
Cet équipement est conforme aux limites d'exposition aux radiations de la IC définies pour
un environnement non contrôlé.
UWB devices may not be employed for the operation of toys. Operation onboard an aircraft, a ship or
a satellite is prohibited.
This device is approved under Part 15.519 for handheld use.
antennas mounted on the outside of a building or on a telephone pole, or any fixed outdoors
infrastructure is prohibited.
This device is Hand-held Communication Devices.
antennas mounted on the outside of a building or on a telephone pole, or any fixed outdoors
infrastructure is prohibited.
Ce dispositif est un appareil de communication portatif.
Les antennes montées à l'extérieur d'un batiment, sur un poteau téléphonique ou sur toute autre
infrastructure fixe à l'extérieur sont interdites. infrastructure extérieure fixe est interdite.
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
dans d''autres langues
- English: Alphard V2 CB Sidekick User guide
Autres documents
-
Eton mobius Manuel utilisateur
-
Porter-Cable PC600JS Manuel utilisateur
-
Porter-Cable PCE345 Manuel utilisateur
-
Porter Cable PC600D Manuel utilisateur
-
-
-
Electrolux LUX 4000 Le manuel du propriétaire
-
-