Initially Pairing the headset

The headset will automatically enter the phone pairing mode

when you initially turn on the headset or in the following

Play or pause music: Press the TAP Button for I second.

Track back: Press the (-) Button for I second.

Track forward: Press the (+) Button for I second.

Mobile Phone Call Making and Answering

Answering a call: Tap the TAP Button

Ending a call: Press the TAP Button for 2 seconds.

Voice dial: Press the TAP Button for 3 seconds.

Speed dial: Press the (+) Button for 3 seconds.

Rejecting a call: Press the (+) Button for 2 seconds.

Intercom

Configuration Menu: Press the TAP Button for 10 seconds.

Using the Sena Device Manager

Connect the headset to your computer via a USB cable. Launch the Sena Device Manager and click

DEVICE SETTING to configure the headset settings.

For details about downloading the Sena Device Manager, please refer to the leaflet included in the

package.

Troubleshooting

Factory Reset

If you want to restore the headset to factory default settings, use the Factory Reset in the configuration

(2) This device must accept any interference received, including interference that may cause

undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device

pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment on

and off, the user is encouraged to try to correct the interference by one or more of the following

FCC RF Exposure Statement

This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled

environment. End users must follow the specific operating instructions for satisfying RF exposure

compliance.

When equipped, the distance between antenna and one’s head surface is 45mm.

FCC Caution

Any changes or modifications to the equipment not expressly approved by the party responsible

for compliance could void user’s authority to operate the equipment.

operation of the device.

Le present appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio

exempts de licence. L’exploitation est autorisee aux deux conditions suivantes :

(1) l’appareil ne doit pas produire de brouillage, et

(2) l’utilisateur de l’appareil doit accepter tout brouillage radioelectrique subi, meme si le brouillage

est susceptible d’en compromettre le fonctionnement.

environnement non contrôlé. Les utilisateurs finaux doivent suivre les instructions d'utilisation

spécifiques pour satisfaire à la conformité d'exposition RF.

Lorsque équipé, la distance entre l’antenne et la surface de la tête est de 45mm.