![](//vs1.manuzoid.fr/store/data-gzf/bbcf9d8eb0d32fe1dc131849ff3f7296/2/000568864.htmlex.zip/bga.jpg)
Safety Information LTN 6C
10 wc_si000225gb.fm
1.2 Machine Description and Intended Use
This machine is a mobile, trailer-mounted light tower. The Wacker
Neuson Light Tower consists of a trailer with a cabinet containing a
diesel engine, a fuel tank, a control panel, and an electric alternator. A
telescoping tower with four metal halide lights is mounted to the top of
the cabinet. Dual winches tilt, raise, and lower the telescoping tower.
As the engine runs, the generator converts mechanical energy into
electric power. The metal halide lights run off this power.
Receptacle(s) are also present to power auxiliary loads. The operator
uses the control panel to operate and monitor the machine.
This machine is intended for the illumination of outdoor areas. This
machine is also intended for the purpose of supplying electrical power
to connected loads. Refer to the product specifications for the output
voltage and frequency of this Light Tower, and for the maximum
output power limit of this Light Tower.
This machine has been designed and built strictly for the intended use
described above. Using the machine for any other purpose could
permanently damage the machine or seriously injure the operator or
other persons in the area. Machine damage caused by misuse is not
covered under warranty.
• The following are some examples of misuse:
• Connecting a load that has voltage and frequency requirements
that are incompatible with the machine output
• Overloading the machine with a device that draws excessive
power during either continuous running or start-up
• Operating the machine in a manner that is inconsistent with all
federal, state and local codes and regulations
• Using the machine as a ladder, support, or work surface
• Using the machine to carry or transport passengers or equipment
• Using the machine to tow other machines (unless factory
equipped)
• Using the machine as a hoist or hanging items from the tower
• Operating the machine outside of factory specifications
• Operating the machine in a manner inconsistent with all warnings
found on the machine and in the Operator’s Manual
This machine has been designed and built in accordance with the
latest global safety standards. It has been carefully engineered to
eliminate hazards as far as practicable and to increase operator
safety through protective guards and labeling. However, some risks
may remain even after protective measures have been taken. They