Emotron DSV15-35 Mounting Instruction

Marque: Emotron

Modèle: DSV15-35

Taper: Mounting Instruction

Control unit

For Emotron DSV15-35 AC drives

Mounting instruc

tion

4

1 General information

First read, then start

1 General information

1.1 First read, then start

Information

and tools with regard to the Emotron products can be found on the Internet:

http://www.emotron.com

à File-archive

You will

find

information

on wiring and commissioning in the

mounting

and switch-on

instructions

of the inverter.

Read this

documentation

thoroughly before carrying out the

installation

and commissioning.

Please observe the safety

instructions!

5

Mounting 2

Important notes

2 Mounting

2.1 Important notes

Dangerous electrical voltage

Possible consequence: death or severe injuries

▶ All works on the inverter must only be carried out in the deenergised state.

▶ After switching off the mains voltage, wait for at least 3 minutes before you start working.

DANGER!

6

2 Mounting

Mounting steps

2.2 Mounting steps

You need:

•

Torx screwdriver TX20

1. Preparation:

1. Insert the shield sheet into the slot on the back side until it engages.

2. Mounting:

1. Hook the control unit into the upper mounting slots.

2. Turn it downwards until it engages into the lower mounting slots.

7

Mounting 2

Mounting steps

3. Fix it with a securing screw.

The control unit is mounted.

© 01/2016 | 13492598 | 1.0 / 01-6409-01R1

CG DRIVES & AUTOMATION

Mörsaregatan 12,

Box 222 25

SE- 250 24 Helsingborg,

Sweden

+46 42 16 99 00

Info:

info.se@cgglobal.com

Order:

order.se@cgglobal.com

1
2
3
4
5
6
7
8

Emotron DSV15-35 Mounting Instruction

Marque: Emotron

Modèle: DSV15-35

Taper: Mounting Instruction

Télécharger le PDF

dans d''autres langues

English: Emotron DSV15-35

Autres documents