TensCare UNIWAND Manuel utilisateur

1

Contents

01. Introduction 2

02. Intended Use 2

03. Microcurrent 3

04. Contents 4

05. Safety Guidelines 5

06. Before Use 8

07. Facial Strokes 9

08. Using Uniwand 15

09. Disposal 17

10. Troubleshooting 18

11. Warranty 19

12. Technical Specification 20

13. Symbols Table 21

2

01. Introduction

Uniwand brings the professional beauty therapy

treatment to your home. Uniwand is a non-invasive

facial toning tool to be used alongside microcurrent

facial toning devices, such as the Uniglo, to reduce

visible signs of ageing. Uniwand works by delivering

low-level electrical impulses via the dual sphere

treatment head to the facial muscles. The wand

offers precise and flexible control, allowing users

to target the specific areas of need. Microcurrent

therapy should be completely pain-free. The current

delivered during the stimulation is so small that in

most cases, no sensation will be felt.

02. Intended Use

Uniwand is an accessory designed to be used with

TensCare beauty products in the home environment

to reduce signs of ageing. It is suitable for use by

all who can control the device and understand the

instructions.

Do not use the device for any purpose other than this

intended use. This device is intended for cosmetic

use on the face only.

Warning: Not suitable for use by children without

adult supervision.

Important: The device should only be used with

microcurrent programmes such as Uniglo FACE 2.

Only use Uniwand with microcurrent parameters

recommended in this manual.

Warning: If using Uniwand with the Uniglo Face and

3

Body Toning device, do not use FACE 1 programme or

any other programme than FACE 2.

03. Microcurrent

Microcurrent stimulation delivers low current into the

cells of the body. Microcurrent has been regularly

used by beauty professionals to offer a non-invasive

and safe face lift alternative to their clients. By

stimulating the facial muscles, regular microcurrent

treatments can positively impact the appearance of

your skin.

Microcurrent can have preventative and corrective

effects. The stimulation can help tighten skin and

soften fine lines and wrinkles. The stimulation can

also help muscle and tissue to be in a better state

of repair to receive the body’s own natural bio-

electrical impulses; hence a preventative result can

also be achieved.

Benefits of Microcurrent

• Encourages collagen production to plump out

the tissue

• Helps to tighten and soften lines and wrinkles

• Boosts sagging muscles

• Reduces oedema: puffiness under the eyes is

reduced as is dark circles under the eyes.

• Gives a youthful appearance to the skin

• Tightens and reduces open pores

• Enhances colours and texture of the skin

4

04. Contents

1 x Uniwand

1 x Unigel Hyaluronic Conductive Gel

1 x Instructions for Use

5

05. Safety Guidelines

Contraindications

• Do not use if you have a pacemaker (or if you

have a heart rhythm problem) or with any

electronic devices. Using this unit with electronic

devices may cause erroneous operation of the

device. Stimulation in the direct vicinity of an

implanted device may affect some models.

• Do not use during the first three months of

pregnancy.

Warnings

• Uniwand is designed to be used with

Microcurrent programmes only. Do not use

with programmes that exceed the parameters

detailed in the technical specification.

• Do not use when driving, operating machinery,

or similar actions needing muscular control.

Damaged leads, or sudden changes in

contact may cause brief involuntary muscle

movements.

• Do not use if you have, in the area being treated:

active or suspected cancer or undiagnosed

pain with a history of cancer. Stimulation directly

through a confirmed or suspected malignancy

should be avoided as it may stimulate growth

and promote spread of cancer cells.

• Do not use while simultaneously connected to

high frequency surgical equipment as it may

result in burns at the site of stimulator electrodes

6

and possible damage to the stimulator.

• Do not use if you have metal implants in the

head or neck area.

• Do not use if you have Botox injections in the

application area.

• Do not use for 6-8 weeks following collagen

injections.

• Do not use for 1 year following a Retin A or Ro-

Accuntaine treatment. This medication used in

the treatment of acne can cause thinning of the

skin.

• Ensure the device is switched off before inserting

the Uniwand lead.

Cautions

• Uniwand is intended for single patient use only.

Do not share your Uniwand. Improper treatment

or cross-infection may occur.

• Caution should be used if you have a bleeding

disorder as stimulation may increase blood flow

to the stimulated region.

• Caution should be used if you have suspected

or diagnosed epilepsy as electrical stimulation

may affect seizure threshold.

• Do not permit use by children unable to

understand the instructions or persons with

cognitive disabilities, i.e., Alzheimer’s disease or

dementia.

• Keep out of reach from children. Lead wire is a

long cord - risk of strangulation in infants.

7

• Do not use on broken skin.

• Some patients may experience skin irritation or

hypersensitivity due to the electrical stimulation

or electrically conductive medium (e.g., the

Unigel). The irritation can usually be reduced

by using an alternate conductive medium. If a

skin irritation continues, discontinue treatment

immediately.

• Do not immerse your device in water or place it

close to excessive heat.

• Keep the device away from sunlight, as long-

term exposure may affect the rubber causing it

to become less elastic and crack.

• Keep the device away from lint and dust, as

long-term exposure may affect the sockets or

cause the battery connector to develop a bad

contact.

• There are no user serviceable parts. Do not

attempt to open or modify the unit. This may

affect the safe operation of the unit and will

invalidate the warranty.

Adverse Reactions

If you experience skin irritation or burning,

discontinue use. If you experience any persistent

painful sensations during or following the use of the

Uniwand device, you should stop using the device

and consult your healthcare professional.

8

06. Before Use

Uniwand has designed to be used with Uniglo’s FACE

2 programme.

Important: Observe all the Contraindications,

Cautions and Warnings included with the device that

you are using the Uniwand with.

Programme Information

Uniglo’s FACE 2 programme has been designed to

provide three phases of treatment.

Phase 1 – Circulation: This part of the treatment

stimulates the epidermal and dermal blood

circulation. It also has an activating effect on the

lymph circulation.

Phase 2 – Superficial lift: This part of the programme

lifts the superficial facial muscles.

Phase 3 – Deep facial toning: This phase gives a lift to

deep facial muscles.

The programme phases are indicated on the Uniglo

display by the central bar (illustration below).

9

The intensity levels are preset for each phase. These

can be reduced by pressing the ▼ button.

First Use

Before using for the first time, test the Unigel with your

skin. Apply a generous amount of gel onto any part

of your body and leave for 30 minutes. After this time,

clean off the gel and check the area of skin. If there is

any irritation or if an allergic reaction develops within

24 hours, please discontinue use and seek advice

from your healthcare professional.

Preparation

Before use ensure your skin is clean and dry. Remove

facial hair as hair can reduce the conductivity

between the spheres and the skin and have a

negative impact on performance. Use Uniwand in

front of a mirror to allow for accurate completion of

the facial strokes.

07. Facial Strokes

The following pages detail microcurrent facial

techniques. Each area of the face has several

different strokes and starting positions.

Each facial stroke should take 5 seconds to perform.

The user should focus on one area of the face at a

time.

10

Jaw and Cheeks

• Position 1 (Jaw) – Position the bottom sphere on

your jawline. Slowly glide the wand towards your

lower ear.

• Position 2 (Lower Cheeks) - Position the bottom

sphere under your cheekbone. Slowly glide the

wand to your mid-ear.

• Position 3 (Upper Cheeks) – Position the bottom

sphere on your cheekbone. Slowly glide the

wand to your upper ear.

• Repeat for the opposite side of the face.

11

Forehead

• Position the wand at position 1, above the thick

of your eyebrow. Slowly glide the wand toward

your hairline.

• Repeat for position 2 and 3.

• Repeat for the opposite side of the face.

12

Eye

• Position the Uniwand at position 1, with the

spheres positioned horizontally. Slowly glide

the wand towards the inner corner of your eye,

maintaining the same orientation.

• Repeat for position 2 and 3.

• Repeat for the opposite side of the face.

13

Lip

• Position the Uniwand above the upper lip. Push

the Uniwand up towards your ear and hold the

Uniwand in this position for 5 seconds.

• Repeat at position 2.

• Repeat for the opposite side of the face.

14

Cheek Contour

• Position the Uniwand under the apple of the

cheek close to the nose. Lift the cheek contour

by pushing the Uniwand upwards. Hold the

Uniwand in this position for 5 seconds.

• Repeat at position 2 (under the apple of the

cheek, mid-way between nose and ear) and 3

(under the apple of the cheek, near the hairline).

• Repeat for the opposite side of the face.

15

08. Using Uniwand

1. Clean the area of the face you wish to treat.

2. Connect the Uniwand lead into either lead

socket on the Uniglo device.

3. Apply the Unigel Hyaluronic Conductive Gel to

the facial area. Use a similar amount as if you

are applying moisturiser to your face.

4. Turn on the Uniglo device.

5. Press the programme button until

FACE 2 programme has been selected.

Once selected, the treatment session

will automatically start.

6. Perform the facial strokes for the selected area

of the face, as indicated in the facial strokes

diagrams. Each facial stroke should take 5

seconds to perform.

For each phase of the Uniglo programme, the user

should complete a set of facial stroke cycles.

Phase 1 – 2 cycles

Phase 2 – 3 cycles

Phase 3 – 2 cycles

• 1 stroke = a facial stroke from one starting

position

• 1 cycle = facial strokes from each starting

position (see facial stroke diagrams), for both

sides of the face

• 1 phase = one part of the facial treatment with a

set number of cycles to complete.

16

For example, for the forehead, user would complete

strokes on the left side of the face at position 1, 2 and

3. They would then perform the strokes on the right

side of the face, again at position 1, 2 and 3. This would

be one complete cycle. For phase 1, the user should

complete this process twice (2 cycles), 3 times for

phase 2 (3 cycles) and twice for phase 3 (2 cycles).

Note: Each phase has a preset time (see Uniglo

manual) to perform the necessary cycles. However,

it is expected you will complete the facial cycles for

each phase within the allotted time.

7. If you have completed the number of cycles for

each phase before the end of the phase time,

unlock the device by pressing either ▼

button and hold the phase skip button

for 3 seconds to move onto the next

phase.

Note: Expected treatment time per facial area is 5

minutes.

8. Once all three phases are complete, move onto

the next area of the face you wish to treat and

complete phase 1, 2 and 3 as instructed above.

Caution: Microcurrent stimulation can be

uncomfortable or painful if insufficient conductive

gel is used. If you start to feel pain midway through a

session, apply extra conductive gel to the area of the

face you are treating.

Frequency of Use

We recommend one treatment session daily, 5 days/

week, for 12 weeks. You may notice some positive

effects after just one session, but normally it will take

17

about 6 weeks before you notice a difference.

After your session

• Turn off your Uniglo device pressing and holding

the power button on the side and disconnect

the Uniwand.

• Wash your face with warm soapy water to

remove any excess Unigel.

• It is important that the Uniwand is cleaned after

each use. Clean with either an alcohol-free

antibacterial wipe such as TensCare Wipes (see

X-WIPES) or by wiping with a damp cloth and

a solution of mild soap and water. Any excess

Unigel should be removed. Wipe dry.

• If using alongside the Uniglo device, after use

store the Uniwand in the Uniglo storage pouch.

09. Disposal

Clean thoroughly and dispose of according to local

regulations.

18

10. Troubleshooting

If your Uniwand is not working properly, please check

the following:

Problem Possible Causes Solution

Pain

during

treatment

Wrong

programme is

being used.

Uniwand should only be

used with Microcurrent

programmes. If using

with Uniglo, this should be

FACE 2.

Not enough

Unigel applied

to the face.

Evenly apply a generous

amount of Unigel to the

areas of the face you are

stimulating.

Irritation or

allergic reaction

to the Unigel

Hyaluronic

Conductive Gel.

Try alternative water-

based conductive gel.

Discontinue treatment

and seek advice

from your healthcare

professional.

No

sensation

Microcurrent

programme is

being used.

It is normal to feel no

sensation during use.

If the above review has failed to resolve your problem,

or to report unexpected operation or events, or to

provide feedback call TensCare or your local supplier

or distributor (address on back cover) for advice.

Contact TensCare customer service on +44 (0) 1372

723 434. Our staff are trained to assist you with most

issues you may have experienced, without the need

to send your product in for service.

La page charge ...

TensCare UNIWAND Manuel utilisateur

TensCare UNIWAND Manuel utilisateur

dans d''autres langues

Autres documents