LG Electronics TM03LNNAHD0 Manuel utilisateur

LG Electronics
Marque
LG Electronics
Modèle
TM03LNNAHD0
Taper
Manuel utilisateur
LGE Confidential
User Manual
TM03LNNAHD0 as telematics module device equipped in the vehicles.
In charge of wireless communications in LTE/WCDMA network
Platform for Telematics Virtual Machine (VM) and other VMs based on Hypervisor
TM03LNNAHD0 supports WCDMA B2/5, LTE B2/4/5/12network
There will be perform some use-case to demonstrate LTE/WCDMA performances targeted
1. High throughput features
2. Low Latency features. below is just for example.
User Manual
•High throughput features
Demonstrate high-throughput, high
-quality image by hotspot.
•Low Latency features
Images and file uploaded from the
car are displayed without delay to
other devices
Cellular Network
Frequency Band
Item Uplink Downlink WCDMA FDD-LTE
Band2 1850-1910 1930-1990 V V
Band4 1710-1755 2110-2155 V
Band5 824-849 869-894 V V
Band12 699-716 729-746 V
LGE Confidential
Telematics NAD Module installation guide and information
NAD Module as TM03LNNAHD0 Module is mounted with solder ball on the main TSU
board.
The strength of the RF field produced by the wireless module or modules embedded in th
e TSU is well within all international RF exposure limits known at this time. Because the wir
eless modules embedded in the TSU emit less than the maximum amount of energy permi
tted in radio frequency safety standards and recommendations, the manufacturer believes
these modules are safe for use.
Regardless of the power levels, care should be taken to minimize human contact during n
ormal operation. This module should be remain more than 20 cm (8 inches) from the body
when wireless devices are on and transmitting.
This transmitter must not be collocated or operated in conjunction with any other antenn
a or transmitter. Operation is subject to the following two conditions: (1) this module does
not cause interference , (2) this module accepts any interference that may cause undesired
operation.
Information for the integrator
The integrator must not provide information to the end user regarding how to install or re
move this RF module in the user manual of the end product. The user manual that is provi
ded by the integrator for end users must include the following information in a prominent l
ocation. To comply with FCC RF and IC RSS-102 exposure requirements, the antenna used f
or this transmitter must be installed to provide a separation distance of at least 20 cm fro
m all persons and must not be collocated or operated in conjunction with any other anten
na or transmitter. The label for the end product must include FCC ID: BEJTM03LNNAHD0 or
A RF transmitter inside, IC: 2703H-TM03LNNAHD0.
LGE Confidential
Telematics NAD Module installation guide and information
This module complies with FCC/IC rules.
FCC : Part 22, Part 24, Part 27
ISED : RSS-130, RSS-132, RSS-133, RSS-139
Furthermore, this device complies with FCC radiation exposure limits set forth for uncontr
olled environments.
This module must be installed and operated with minimum distance of 20 cm between th
e radiating element and the user. This module must not be co-located with any other trans
mitters or antennas. To comply with FCC regulations limiting both the maximum RF output
power and human exposure to RF radiation, the maximum antenna gain including cable lo
ss in a mobile-only exposure condition must not exceed the values listed in the following t
able.
To satisfy the FCC’s exterior labeling requirements, the following text must appear on the e
xterior of the end product. Contains transmitter module FCC ID: BEJTM03LNNAHD0 Contai
ns transmitter module IC: 2703H-TM03LNNAHD0
Changes or modifications to this equipment may cause harmful interference unless the mo
difications are expressly approved in the instruction manual. Users may lose the authority
to operate this equipment if an unauthorized change or codification is made.
Note: If this module is intended for use in a portable device, additional testing will be requ
ired to satisfy the RF exposure and SAR requirements of FCC Part 2.1093 and RSS-102.
LGE Confidential
Notice
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
The OEM integrator is responsible for ensuring that the host product which is installed and
operating with the module is in compliant with Part 15B unintentional Radiator
requirements, please note that For a Class B digital device or peripheral, the instructions
furnished the user manual of the end-user product shall include the following or similar
statement, placed in a prominent location in the text of the host product manual:
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This device complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This device should be installed and operated with minimum distance 20cm
between the radiating element of this device and the user.
LGE Confidential
Notice
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme
aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes :(1)L’appareil ne doit pas produire de brouillage; (2)L’appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement.
L’étiquette d’homologation d’un module d’Innovation, Sciences et Développement
économique Canada devra être posée sur le produit hôte à un endroit bien en vue, en tout
temps. En l’absence d’étiquette, le produit hôte doit porter une étiquette sur laquelle
figure le numéro d’homologation du module d’Innovation, Sciences et Développement
économique Canada, précédé du mot « contient », ou d’une formulation similaire allant
dans le même sens et qui va comme suit :Contient IC : 2703H-TM03LNNAHD0 est le
numéro d’homologation du module.
Cet équipement est conforme aux limites d'exposition aux radiations IC CNR-102 établies
pour un environnement non contrôlé. Cet équipement doit être installé et utilisé avec une
distance minimale de 20 cm entre le radiateur et votre corps.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5

LG Electronics TM03LNNAHD0 Manuel utilisateur

LG Electronics
Marque
LG Electronics
Modèle
TM03LNNAHD0
Taper
Manuel utilisateur
Télécharger le PDF
rapport

dans d''autres langues

Documents connexes

Autres documents