Aosom 370-233V80BK Assembly Instructions

Taper
Assembly Instructions

Ce manuel convient également à

ASSEMBLY INSTRUCTION
IN230900135V01_US_CA
370-233V80
IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY
CHILDREN'S ELECTRONIC
MOTORCYCLE
EN
3-6
3-8
100-240V 50/60Hz 0.3A
35W #550*2
12V 1000mA
About your new vehicle
On the purchase of your new ride-on.
To ensure the user rides safely, please read these instructions carefully. Keep this manual for
future reference.
Do not recharge non-rechargeable batteries.
Before charging rechargeable batteries, remove them from the vehicle.
Batteries must be charged under adult supervision.
Different types of batteries or new and used batteries must not be mixed.
Insert batteries with the correct polarity.
Remove dead batteries from the ride-on.
Do not short-circuit the supply terminals.
18
18
PREVENTING POSSIBLE INJURY OR DEATH:
NEVER LEAVE CHILDREN UNATTENDED. ADULT SUPERVISION IS
ALWAYS REQUIRED. Keep children in your view when they use this vehicle.
A certain amount of skill is required when using this vehicle, preventing falls or
collisions. This ride-on must be used with caution.
Protective equipment must be worn.
Never use on roads, steep slopes or steps, or near swimming pools.
Always wear shoes and sit on the seat.
Do not use in trafc.
Not for children under three years because of its maximum speed. Maximum
load is 30kg.
This ride-on has no brake.
● Keep children in safe riding areas:
● Never use on roads, near motor vehicles, on lawns or on steep slopes and steps.
Do not use near swimming pools.
● Only use on flat surfaces. Safe locations include inside your house, garden or
playground.
● Never use in the dark – children could collide with obstacles. Only use this ride-on
in the daytime or in a properly lit area.
● It is prohibited to change the circuit or add other electric parts.
● Regularly inspect wires and connections of the vehicle.
● When the vehicle is moving, ensure children do not touch or get near the wheels.
● This ride-on has adjustable seatbelts. Teach children how to properly fasten the
seatbelt before using.
1. Insert the connecter on foot pedal R into the connector on the
vehicle body.
2. Inert the tabs on foot pedal R into the groove on the right side of
the body.
3. Insert the tabs on foot pedal L into the groove on the left side of
the body.
Turn the ride-on upside down.
1. Place the wide wheel onto the vehicle body.
2. Insert Ø4x12 screws *6 and Ø4x30 screws *3, then tighten with
a screwdriver.
Place the ride-on upright.
3. Fit the rear foot pedal into the hole on the body – push until you
hear it 'click' into place. Repeat for the other rear pedal.
1. Remove a lock from the front axle with two spanners.
2. Place a Ø10 washer onto the front axle.
3. Slide the front axle through the hole on the right side of the front
fender, and out of the hole on the right side of the handlebar fork.
4. Place a Ø12 washer onto the front axle.
5. Place the front wheel onto the front axle.
6. Place a Ø12 washer onto the front axle.
7. Keep pushing the front axle, until it passes through the hole on the
left side of the handlebar fork, and out through the hole on the right
side of the front fender.
8. Place a Ø10 washer onto the front axle.
9. Tighten a locknut onto the end of the front Axle. Tip: An extra
spanner has been provided to hole the locknut, which is on the
other side of the front axle, while tightening the locknut on the
other side.
10. Fit the hub caps to both sides of the front fender.
1. Plug the connector on the faceguard into the connector on the vehicle
body.
2. Fit the tabs on the faceguard into the grooves on the vehicle body, then
push until it is in place.
3. Insert two Ø4x16 screws and tighten.
Attach the faceguard and handlebar
1. Remove the screw on the top of the seat with a screwdriver, then
remove the seat.
2. Plug the red connector on the vehicle body into the red connector
from the battery,
3. Put the seat back.
1.Power button:
Turn the unit on and off.
2. Foot pedal:
To move the vehicle, press the pedal
down.
To brake or slow down, release
pressure from the pedal.
3. Lights switch:
Turn the front lights on and off.
4. Forward/reverse lever:
To move the vehicle forward at high
speed, shift the lever to top position.
To move the vehicle forward at
normal speed, shift the level to middle
position.
To move the vehicle backward, shift
the lever to middle position.
TIP: The vehicle will operate at low
speed in reverse.
A. USB slot
B. TF card slot (reads Mp3 format only)
C. AUX input
D. Previous/decrease volume
E. Play/pause
F. Next/increase volume
G. Change the audio input (if you insert two or more audio input devices). It also
controls the Bluetooth (if equipped) and FM functions (if equipped).
H. Display screen: Shows power level of the battery when the vehicle stops. When it is at
less than 12, recharge the battery.
AN ADULT MUST CHARGE THE BATTERY!
This product has a charging protection: when charging, all
functions will cut off.
The power switch must be turned off when charging.
Before first use, charge the battery for 4-6 hours. Do not recharge
the battery for more than 10 hours to avoid overheating.
When the vehicle starts running slowly, charge the battery.
1. Plug the charger port into the input socket (above the right foot
pedal).
2. Plug the charger plug into a wall outlet – the battery will begin
charging.
Battery is not fully charged.
The maximum load has been
exceeded.
Loose wires or connectors.
'Dead spot' means the electric power is not being
delivered to the terminal connection, which means
the ride-on needs repairing. Please contact the
distributor.
Check the battery connectors are firmly plugged
into each other. If wires are loose around the
motor, please contact the distributor.
Ensure the vehicle is completely stopped,
then shift. See 'Use your new ride-on'.
Check the battery connectors are firmly plugged
into each other.
Check the charger is plugged into a working wall
outlet.
Please contact the distributor.
● It is the adult's responsibility to check main parts of this ride-on before
using. It is important to regularly inspect the battery, charger, cable or
cord and plug. Ensure screws are tightened. If any damages occur, do
not use this ride-on until properly fixed.
● Ensure plastic parts of the vehicle are not cracked or broken.
● Occasionally use a lightweight oil to lubricate moving parts, such as the
wheels.
● Park the vehicle indoors or cover with a tarp, so it is protected from wet
weather.
● Keep this ride-on away from sources of heat, such as stoves and
heaters – plastic parts could melt.
● Charge the battery after each use. Only an adult can handle the
battery. When not being used, ensure the battery is charged at least
once a month.
Do not wash this ride-on with a hose or with soap and water. Do not
drive in rainy or snowy conditions. Water will damage the motor,
electric system and battery.
● Clean the vehicle with a soft, dry cloth. To keep plastic parts looking
pristine, use a non-wax furniture polish. Do not use car wax or abrasive
cleaners.
● Do not drive the vehicle in mud, sand or fine gravel – this could damage
moving parts, motors or the electric system.
● When not using, ensure the ride-on is turned off and unplugged.
The battery has a thermal fuse with a rest fuse, which automatically cuts all
power to the vehicle if the motor, electric system or battery overloads. The
fuse will reset and power will be restored after the unit has been off for 20
seconds, the turned on. If the fuse trips repeatedly during normal use, the
ride-on may need to be repaired. Please contact the distributer.
To avoid losing power, follow these guidelines:
● Do not overload the vehicle.
● Do not tow anything behind the vehicle.
● Do not drive up steep slopes.
● Do not drive into fixed objects, which may cause the wheels to spin,
causing the motor to overheat.
● Do not drive in very hot weather, components may overheat.
● Keep water and other liquids away from the battery and other electrical
components.
● Do not tamper with the electric system – this could trip the fuse.
Assemblage & manuel dinstructions
IMPORTANT : LIRE ATTENTIVEMENT ET CONSERVEZ CE MANUEL
POUR VOUS Y REFERER ULTERIEUREMENT
MOTOCYCLETTE
ÉLECTRONIQUE POUR ENFANTS
Lisez et comprenez tout ce manuel avant utilisation !
Veuillez conserver ce manuel pour référence ultérieure car il contient des informations
importantes.
Avant la première utilisation, chargez la batterie pendant au moins 8 à 12 heures.
FR
L'assemblage doit être réalisé par
un adulte.
Destiné aux enfants de plus de 3+ ans
Poids maximum de l'utilisateur : 30 kg
370-233V80
IN230900135V01_US_CA
100-240V 50/60Hz 0.3A
35W #550*2
12V 1000mA
À propos de votre nouveau véhicule.
Lors de l'achat de votre nouveau véhicule.
Pour vous assurer que l'utilisateur roule en toute sécurité, veuillez lire attentivement ces
instructions. Conservez ce manuel pour référence ultérieure.
À propos de votre nouveau véhicule
SPÉCIFICATIONS:
Batterie
Chargeur
Entrée
Moteur
Âge approprié:
Temps de charge:
Capacité de charge:
Taille de la voiture:
Vitesse:
3 à 8 ans
8 à12 heures
Moins de 30 Kg
Ne rechargez pas les batteries non rechargeables.
Avant de charger les batteries rechargeables, retirez-les du véhicule.
● Les batteries doivent être chargées sous la surveillance d'un adulte.
● Il ne faut pas mélanger différents types de batteries ou des batteries neuves
et usagées.
● Insérez des batteries avec la polarité correcte.
● Retirez les batteries mortes du manège.
● Ne court-circuitez pas les bornes d'alimentation.
INFORMATIONS SUR LA BATTERIE
Liste des pièces
NO. NOM DE PIÈCE QTÉ (PCS) OBSERVATIONS
Carrosserie
Pédale avant L
Pédale avant R
Protège-visage
Vis Φ4 * 16
Sge
Vis Φ4 * 12
Vis Φ4 * 30
Roue latérale
C
Contre-écrou
Enjoliveur de roue
Roue avant
Rondelle Φ12
Essieu
Pied avant arrière
Chargeur
Rondelle Φ10
● Outils d'assemblage requis (non inclus) :
Tournevis
18
18
Schéma des pièces
PRÉVENIR LES BLESSURES ET LES DÉCÈS :
NE JAMAIS LAISSER L'ENFANT SANS SURVEILLANCE. LA SURVEILLANCE
DIRECTE D'UN ADULTE EST IMPÉRATIVE. Gardez toujours toujours l'enfant en vue
lorsqu'il est dans un véhicule.
● Ce jouet doit être utilisé avec précaution dans la mesure où une certaine habileté est
cessaire pour éviter les chutes ou les collisions pouvant causer des blessures à
l'utilisateur ou à des tiers.
● Il convient de porter un équipement de protection.
● Ne jamais l'utiliser sur la chaussée, près des voitures, ou à proximité de pentes raides
ou de marches, de piscines ou d'autres plans d'eau.
● Portez toujours des chaussures, asseyez-vous toujours sur le sge.
● À ne pas utiliser dans la circulation.
● Ce jouet ne convient pas aux enfants de moins de 36 mois en raison de sa vitesse
maximale ; le poids maximal de l'utilisateur est de 30 kg.
● Ce jouet n'a pas de frein.
Sécurité
AVERTISSEMENT :
RISQUE D'ÉTOUFFEMENT ! Ne convient pas aux enfants de moins de 36 mois.
Doit être assemblé par un adulte.
● Gardez les enfants à l'intérieur de zones d'utilisation sûres; Ne jamais utiliser sur la
chaussée, à proximité de véhicules à moteur, sur une pelouse, sur ou à proximité de
pentes raides ou de marches, de piscines ou d'autres plans d'eau ;portez toujours des
chaussures et n'autorisez jamais plus d'un cavalier.
● Utilisez le jouet uniquement sur des surfaces planes, comme à l'inrieur de votre maison,
dans votre jardin ou sur votre terrain de jeu;
● Ne jamais utiliser dans l'obscuri. Un enfant pourrait rencontrer des obstacles inattendus
et avoir un accident. N'utilisez le véhicule que de jour ou dans un endroit bien éclairé ;
● Il est interdit de modier le circuit ou d'ajouter d'autres pièces électriques ;
● Inspectez périodiquement les fils et les connexions du véhicule ;
● Ne pas laisser un enfant toucher les roues ou être près d'elles lorsque le véhicule est en
mouvement ;
● Ce véhicule est équipé de ceintures de sécurité de jeu réglables. Veuillez apprendre aux
enfants à attacher la ceinture de sécurité avant de l'utiliser, afin de garantir leur sécurité.
Règles pour une conduite en toute sécurité
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28
  • Page 29 29
  • Page 30 30
  • Page 31 31
  • Page 32 32

Aosom 370-233V80BK Assembly Instructions

Taper
Assembly Instructions
Ce manuel convient également à

dans d''autres langues