Aosom 370-233V80BK Assembly Instructions

ASSEMBLY INSTRUCTION

IN230900135V01_US_CA

370-233V80

IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY

CHILDREN'S ELECTRONIC

MOTORCYCLE

EN

3-6

3-8

100-240V 50/60Hz 0.3A

35W #550*2

12V 1000mA

About your new vehicle

On the purchase of your new ride-on.

To ensure the user rides safely, please read these instructions carefully. Keep this manual for

future reference.

●Do not recharge non-rechargeable batteries.

●Before charging rechargeable batteries, remove them from the vehicle.

●Batteries must be charged under adult supervision.

●Different types of batteries or new and used batteries must not be mixed.

●Insert batteries with the correct polarity.

●Remove dead batteries from the ride-on.

●Do not short-circuit the supply terminals.

18

PREVENTING POSSIBLE INJURY OR DEATH:

● NEVER LEAVE CHILDREN UNATTENDED. ADULT SUPERVISION IS

ALWAYS REQUIRED. Keep children in your view when they use this vehicle.

● A certain amount of skill is required when using this vehicle, preventing falls or

collisions. This ride-on must be used with caution.

● Protective equipment must be worn.

● Never use on roads, steep slopes or steps, or near swimming pools.

● Always wear shoes and sit on the seat.

● Do not use in trafﬁc.

● Not for children under three years because of its maximum speed. Maximum

load is 30kg.

● This ride-on has no brake.

● Keep children in safe riding areas:

● Never use on roads, near motor vehicles, on lawns or on steep slopes and steps.

Do not use near swimming pools.

● Only use on ﬂat surfaces. Safe locations include inside your house, garden or

playground.

● Never use in the dark – children could collide with obstacles. Only use this ride-on

in the daytime or in a properly lit area.

● It is prohibited to change the circuit or add other electric parts.

● Regularly inspect wires and connections of the vehicle.

● When the vehicle is moving, ensure children do not touch or get near the wheels.

● This ride-on has adjustable seatbelts. Teach children how to properly fasten the

seatbelt before using.

1. Insert the connecter on foot pedal R into the connector on the

vehicle body.

2. Inert the tabs on foot pedal R into the groove on the right side of

the body.

3. Insert the tabs on foot pedal L into the groove on the left side of

the body.

Turn the ride-on upside down.

1. Place the wide wheel onto the vehicle body.

2. Insert Ø4x12 screws *6 and Ø4x30 screws *3, then tighten with

a screwdriver.

Place the ride-on upright.

3. Fit the rear foot pedal into the hole on the body – push until you

hear it 'click' into place. Repeat for the other rear pedal.

1. Remove a lock from the front axle with two spanners.

2. Place a Ø10 washer onto the front axle.

3. Slide the front axle through the hole on the right side of the front

fender, and out of the hole on the right side of the handlebar fork.

4. Place a Ø12 washer onto the front axle.

5. Place the front wheel onto the front axle.

6. Place a Ø12 washer onto the front axle.

7. Keep pushing the front axle, until it passes through the hole on the

left side of the handlebar fork, and out through the hole on the right

side of the front fender.

8. Place a Ø10 washer onto the front axle.

9. Tighten a locknut onto the end of the front Axle. Tip: An extra

spanner has been provided to hole the locknut, which is on the

other side of the front axle, while tightening the locknut on the

other side.

10. Fit the hub caps to both sides of the front fender.

1. Plug the connector on the faceguard into the connector on the vehicle

body.

2. Fit the tabs on the faceguard into the grooves on the vehicle body, then

push until it is in place.

3. Insert two Ø4x16 screws and tighten.

Attach the faceguard and handlebar

1. Remove the screw on the top of the seat with a screwdriver, then

remove the seat.

2. Plug the red connector on the vehicle body into the red connector

from the battery,

3. Put the seat back.

1.Power button:

Turn the unit on and off.

2. Foot pedal:

●To move the vehicle, press the pedal

down.

●To brake or slow down, release

pressure from the pedal.

3. Lights switch:

Turn the front lights on and off.

4. Forward/reverse lever:

●To move the vehicle forward at high

speed, shift the lever to top position.

●To move the vehicle forward at

normal speed, shift the level to middle

position.

●To move the vehicle backward, shift

the lever to middle position.

TIP: The vehicle will operate at low

speed in reverse.

A. USB slot

B. TF card slot (reads Mp3 format only)

C. AUX input

D. Previous/decrease volume

E. Play/pause

F. Next/increase volume

G. Change the audio input (if you insert two or more audio input devices). It also

controls the Bluetooth (if equipped) and FM functions (if equipped).

H. Display screen: Shows power level of the battery when the vehicle stops. When it is at

less than 12, recharge the battery.

AN ADULT MUST CHARGE THE BATTERY!

This product has a charging protection: when charging, all

functions will cut oﬀ.

● The power switch must be turned oﬀ when charging.

● Before ﬁrst use, charge the battery for 4-6 hours. Do not recharge

the battery for more than 10 hours to avoid overheating.

● When the vehicle starts running slowly, charge the battery.

1. Plug the charger port into the input socket (above the right foot

pedal).

2. Plug the charger plug into a wall outlet – the battery will begin

charging.

Battery is not fully charged.

The maximum load has been

exceeded.

Loose wires or connectors.

'Dead spot' means the electric power is not being

delivered to the terminal connection, which means

the ride-on needs repairing. Please contact the

distributor.

Check the battery connectors are ﬁrmly plugged

into each other. If wires are loose around the

motor, please contact the distributor.

Ensure the vehicle is completely stopped,

then shift. See 'Use your new ride-on'.

Check the battery connectors are ﬁrmly plugged

into each other.

Check the charger is plugged into a working wall

outlet.

Please contact the distributor.

● It is the adult's responsibility to check main parts of this ride-on before

using. It is important to regularly inspect the battery, charger, cable or

cord and plug. Ensure screws are tightened. If any damages occur, do

not use this ride-on until properly ﬁxed.

● Ensure plastic parts of the vehicle are not cracked or broken.

● Occasionally use a lightweight oil to lubricate moving parts, such as the

wheels.

● Park the vehicle indoors or cover with a tarp, so it is protected from wet

weather.

● Keep this ride-on away from sources of heat, such as stoves and

heaters – plastic parts could melt.

● Charge the battery after each use. Only an adult can handle the

battery. When not being used, ensure the battery is charged at least

once a month.

●Do not wash this ride-on with a hose or with soap and water. Do not

drive in rainy or snowy conditions. Water will damage the motor,

electric system and battery.

● Clean the vehicle with a soft, dry cloth. To keep plastic parts looking

pristine, use a non-wax furniture polish. Do not use car wax or abrasive

cleaners.

● Do not drive the vehicle in mud, sand or ﬁne gravel – this could damage

moving parts, motors or the electric system.

● When not using, ensure the ride-on is turned oﬀ and unplugged.

The battery has a thermal fuse with a rest fuse, which automatically cuts all

power to the vehicle if the motor, electric system or battery overloads. The

fuse will reset and power will be restored after the unit has been oﬀ for 20

seconds, the turned on. If the fuse trips repeatedly during normal use, the

ride-on may need to be repaired. Please contact the distributer.

To avoid losing power, follow these guidelines:

● Do not overload the vehicle.

● Do not tow anything behind the vehicle.

● Do not drive up steep slopes.

● Do not drive into ﬁxed objects, which may cause the wheels to spin,

causing the motor to overheat.

● Do not drive in very hot weather, components may overheat.

● Keep water and other liquids away from the battery and other electrical

components.

● Do not tamper with the electric system – this could trip the fuse.

Assemblage & manuel d’instructions

IMPORTANT : LIRE ATTENTIVEMENT ET CONSERVEZ CE MANUEL

POUR VOUS Y REFERER ULTERIEUREMENT

MOTOCYCLETTE

ÉLECTRONIQUE POUR ENFANTS

Lisez et comprenez tout ce manuel avant utilisation !

Veuillez conserver ce manuel pour référence ultérieure car il contient des informations

importantes.

Avant la première utilisation, chargez la batterie pendant au moins 8 à 12 heures.

FR

L'assemblage doit être réalisé par

un adulte.

●Destiné aux enfants de plus de 3+ ans

●Poids maximum de l'utilisateur : 30 kg

370-233V80

IN230900135V01_US_CA

100-240V 50/60Hz 0.3A

35W #550*2

12V 1000mA

À propos de votre nouveau véhicule.

Lors de l'achat de votre nouveau véhicule.

Pour vous assurer que l'utilisateur roule en toute sécurité, veuillez lire attentivement ces

instructions. Conservez ce manuel pour référence ultérieure.

À propos de votre nouveau véhicule

SPÉCIFICATIONS:

Batterie

Chargeur

Entrée

Moteur

Âge approprié:

Temps de charge:

Capacité de charge:

Taille de la voiture:

Vitesse:

3 à 8 ans

8 à12 heures

Moins de 30 Kg

●Ne rechargez pas les batteries non rechargeables.

●Avant de charger les batteries rechargeables, retirez-les du véhicule.

● Les batteries doivent être chargées sous la surveillance d'un adulte.

● Il ne faut pas mélanger différents types de batteries ou des batteries neuves

et usagées.

● Insérez des batteries avec la polarité correcte.

● Retirez les batteries mortes du manège.

● Ne court-circuitez pas les bornes d'alimentation.

INFORMATIONS SUR LA BATTERIE

Liste des pièces

NO. NOM DE PIÈCE QTÉ (PCS) OBSERVATIONS

Carrosserie

Pédale avant L

Pédale avant R

Protège-visage

Vis Φ4 * 16

Siège

Vis Φ4 * 12

Vis Φ4 * 30

Roue latérale

Clé

Contre-écrou

Enjoliveur de roue

Roue avant

Rondelle Φ12

Essieu

Pied avant arrière

Chargeur

Rondelle Φ10

● Outils d'assemblage requis (non inclus) :

Tournevis

18

Schéma des pièces

PRÉVENIR LES BLESSURES ET LES DÉCÈS :

● NE JAMAIS LAISSER L'ENFANT SANS SURVEILLANCE. LA SURVEILLANCE

DIRECTE D'UN ADULTE EST IMPÉRATIVE. Gardez toujours toujours l'enfant en vue

lorsqu'il est dans un véhicule.

● Ce jouet doit être utilisé avec précaution dans la mesure où une certaine habileté est

nécessaire pour éviter les chutes ou les collisions pouvant causer des blessures à

l'utilisateur ou à des tiers.

● Il convient de porter un équipement de protection.

● Ne jamais l'utiliser sur la chaussée, près des voitures, ou à proximité de pentes raides

ou de marches, de piscines ou d'autres plans d'eau.

● Portez toujours des chaussures, asseyez-vous toujours sur le siège.

● À ne pas utiliser dans la circulation.

● Ce jouet ne convient pas aux enfants de moins de 36 mois en raison de sa vitesse

maximale ; le poids maximal de l'utilisateur est de 30 kg.

● Ce jouet n'a pas de frein.

Sécurité

AVERTISSEMENT :

• RISQUE D'ÉTOUFFEMENT ! Ne convient pas aux enfants de moins de 36 mois.

• Doit être assemblé par un adulte.

● Gardez les enfants à l'intérieur de zones d'utilisation sûres; Ne jamais utiliser sur la

chaussée, à proximité de véhicules à moteur, sur une pelouse, sur ou à proximité de

pentes raides ou de marches, de piscines ou d'autres plans d'eau ;portez toujours des

chaussures et n'autorisez jamais plus d'un cavalier.

● Utilisez le jouet uniquement sur des surfaces planes, comme à l'intérieur de votre maison,

dans votre jardin ou sur votre terrain de jeu;

● Ne jamais utiliser dans l'obscurité. Un enfant pourrait rencontrer des obstacles inattendus

et avoir un accident. N'utilisez le véhicule que de jour ou dans un endroit bien éclairé ;

● Il est interdit de modiﬁer le circuit ou d'ajouter d'autres pièces électriques ;

● Inspectez périodiquement les ﬁls et les connexions du véhicule ;

● Ne pas laisser un enfant toucher les roues ou être près d'elles lorsque le véhicule est en

mouvement ;

● Ce véhicule est équipé de ceintures de sécurité de jeu réglables. Veuillez apprendre aux

enfants à attacher la ceinture de sécurité avant de l'utiliser, aﬁn de garantir leur sécurité.

Règles pour une conduite en toute sécurité

La page charge ...

Aosom 370-233V80BK Assembly Instructions

Ce manuel convient également à

Aosom 370-233V80BK Assembly Instructions

dans d''autres langues

Documents connexes

Autres documents