Winegard WF2-5G1 Manuel utilisateur

Taper
Manuel utilisateur
1
Specifications:
Specifications
Wireless Standard: 802.11a/b/g/n/ac
Frequency Band: 2.4GHz/5GHz
Wireless Speed:2.4GHz 432Mbps(Tx), 5Ghz
757Mbps
Amplifiers: 2x2 MIMO
Antennas: (2) 2.4GHz/5GHz, (4) 5G LTE Antennas
Wireless Security: WEP, WPA, WPAA2, WPA mixed
Sim Card Port: 3xStandard SIM (25mm x 15mm
x .076mm), 2 internal, 1 internal
Power Rating: DC12V, 1.5A
WARNINGS:
Read this manual carefully and completely before
attempting to assemble, install or operate this
product. Winegard® recommends the installation of
this equipment be done by a professional technician.
Save these instructions.
Do not paint any portion of the Winegard Connect® Home.
Painting the system could damage the system and will void the warranty.
When first setting up the Winegard ConnecT it is
recommended to check for software updates the first
time the system is connected to an internet signal.
It is also recommended to check for updates every
couple months for fixes and added features.
WINEGARD
WF2-5G1
2
3
4
5
6
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following methods:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and devices.
Connect the equipment into an electrical outlet on a circuit different from that which the radio receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this
equipment.
Only channels 111 can be operated, and channels 1-11 can only be operated in the 2.4GHz band. Selection of other channels is not possible.
This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or
transmitter.
The band 5150-5350 MHz for this device are restricted to indoor use.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed
and operated with a minimum distance of 20 cm between the radiator and your body.
This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter except in accordance
with FCC multi-transmitter product procedures.
IC Regulatory Compliance
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canadas licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR dInnovation, Sciences
et Développement économique Canada applicables aux appareils radio exempts de licence. Lexploitation est autorisée
aux deux conditions suivantes :
(1) Lappareil ne doit pas produire de brouillage;
(2) Lappareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible den compromettre
le fonctionnement.
RF Exposure Compliance
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20 cm between the radiator and your body.
Cet équipement est conforme aux limites d'exposition aux radiations IC CNR-102 établies pour un environnement non
contrôlé. Cet équipement doit être installé et utilisé avec une distance minimale de 20 cm entre le radiateur et votre
corps.
WF2-5G1
FCC ID: C3D-AZ15G222200
Contains FCC ID: C3D-2020RM502QAE
IC: 22428-AZ15G222200
Contains IC: 22428-2020RM502AE
HVIN: WF2-5G1
Disclaimer: Although every effort has been made to ensure that the information in this manual is correct and complete, no company shall be held
liable for any errors or omissions in this manual. Information provided in this manual was accurate at time of printing. If the antenna does not
function as expected, please contact Winegard Co. Winegard is a registered trademark of Winegard Company. LLC. Apple & the Apple logo are
trademarks of Apple Inc., registered in the U.S. and other countries. App Store is a service mark of Apple Inc., registered in the U.S. and other
countries. Google Play & the Google Play logo are trademarks of Google LLC. All trademarks, registered trademarks and logos are the property
of their respective owners and are not affiliated with Winegard Company
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

Winegard WF2-5G1 Manuel utilisateur

Taper
Manuel utilisateur

dans d''autres langues