- 14 -
COMPONENTS OF THE ITEM
Check the contents of the packaging and if you have any complaints please contact the Assistance Service.
_ High chair with washable and removable padding, front bar, double tray and 4 wheels.
INSTRUCTIONS FOR USE
1 OPENING: Before opening the high chair, fit the wheels by pressing them in the direction of the arrow (fig. a).
Open the high chair by lowering the two supporting bases (fig. b) and check the green rectangle to make
sure it is properly open (fig_c). WARNING: If the red rectangle is visible, the base has not been opened
properly.
2 Before using the high chair, raise the seat (fig_a), completely recline the backrest until it clicks into position
(b) and make sure the pin is properly locked in place (fig_c).
3 FIVE POINT SAFETY HARNESS: To fasten the harness, insert the two waist strap buckles (with shoulder straps
attached) into the leg divider strap until you hear a click (fig. a). To release it, press the sides of the buckle
and simultaneously pull the waist strap outwards (fig. b). To tighten the waist strap, pull from both sides in
the direction of the arrow (fig. c). To loosen it, do the opposite. The waist strap can be tightened as far as the
safety stop (fig. d).
4 The shoulder straps of the harness can be set at two different heights. Partially remove the sack (fig_a),
release the shoulder straps from the backrest (fig_b) and pull them out from the sack (fig_c).
5 Insert the ends of the shoulder straps in the other slots in the sack (fig_d) and the backrest (fig_e), then put
the sack back into the right position on the backrest.
6 BRAKE: The brake on the seat is always applied. To move the seat, keep both buttons held down.
RECLINER-SWING
7 FOOTREST FOR EARLY MONTHS: The high chair is fitted with a footrest for use when it is in the recliner-swing
mode. Raise the footrest by rotating it upwards (fig. a). Fold it away by pressing the two side buttons (fig. b)
and rotating it downwards (fig. c).
8 RECLINER-SWING: Before placing the high chair in the recliner-swing mode, remove the tray (fig. a) and
insert the front bar (fig. b). To remove the protective front bar, press the two buttons at its base and pull it
out (fig_c).
9 SWING: To transform the chair into a swing, place the seat in the lowest position (fig. a) and press the red
buttons on the inner part of the uprights, pushing them upwards (fig. b). Swing mode (fig. c).
10 To put it back in recliner or high chair mode, make sure that the side uprights of the seat are parallel with
those of the frame (fig_a) (refer to the printed line on the uprights), then press the red buttons and push
them downwards (fig_b).
HIGH CHAIR
11 FOOTREST: Lower the footrest (fig. a), press the two side buttons (fig. b) and select one of the three available
heights.
12 TRAY: To fit the tray, pull the side levers underneath it outwards and at the same time insert it into the
armrests, pushing all the way down (fig. a). To move the tray outwards, pull the central lever underneath
it towards you (fig. b) and change the position of the tray (fig. c). To remove the tray, pull the side levers
outwards and pull the tray towards you. The high chair has a double tray. The top tray can be easily washed
in a dishwasher. To remove it, detach it from the lower tray and lift it up (fig. d).
13 USE WITHOUT THE TRAY: to use the seat at the table, remove the tray.
14 ADJUSTING THE HEIGHT: The seat can be set at 9 different heights. To raise or lower the seat, pull the two
levers upwards (fig. a) and move it to the required position. This can also be done with the child in the high
chair.
15 RECLINING BACKREST: The seat can be reclined in four positions: for eating, playing, relaxing or sleeping. To
adjust it, raise the handle behind the backrest (fig. a) and lock it in the required position (fig. b). This can also
be done with the child in the high chair.
16 CLOSING AND REOPENING THE TRAY: Pull the side levers outwards (fig. a) and move the tray outwards as far
as the red reference points (fig. b). Next rotate it upwards until it is locked in place (fig. c). To reopen the tray,
rotate it downwards while pulling the side levers outwards and move it into one of the positions for use.
17 COMPACT CLOSURE: before closing the high chair, it is necessary to fold up the tray. Put the backrest in
the vertical position, then pull the two red levers on the sides of the seat outwards (Arrow_a). Rotate it
downwards (Arrow_b), lower the seat to the bottom position and fold away the footrest. To raise the support
bases, press the red levers on the sides of the uprights (Arrow_c) and at the same time lift the grey levers
(Arrow_d). The bases will lift up automatically (Arrow_e). The high chair is freestanding when folded up.