Aev Spol WSBRC001 Manuel utilisateur

Marque
Aev Spol
Modèle
WSBRC001
Taper
Manuel utilisateur
Manual wSBR 2K7959760
Date: 08/04/2020 version 0.4 page1 of 2
1. Technical description
1.1 System Description
1.1.1 Frequencies
Bluetooth Low Energy f=2402MHz ÷ 2480MHz
1.1.2 Functional description
Wireless Seat Belt Reminder is a system which allows in vehicle wireless data collection of car seats
with respect to seat occupation and seat belt buckle state. The system is able to collect data from a
position up to 6 seats, with a possible future extension to a higher number of seats is possible.
Wireless data transmission is performed with low energy Bluetooth.
Image1 F-SG
The device connected to the vehicle F-SG 2K7959760 is firmly connected to the power supply
terminal 30. The data on the vehicle are transmitted via LIN communication. If the LIN
communication is enabled, the current status of the S-SG in the seats are sent to the vehicle. F-SG
works in a continuous scan mode and receiving dates. The dates are received only from registered S-
SG in the car seats. Registration is done via the LIN diagnostic protocol. If the LIN communication is
inactive, the vehicle is in the idle state, the processor is in the sleep mode, the receiver is in a
continuous scan mode and receiving dates.
Manual wSBR 2K7959760
Date: 08/04/2020 version 0.4 page2 of 2
1.1.3 Temparature or voltage operating range
temperature: -40C ÷ +80C
voltage: 9V - 16V
The manufacturer of this radio equipment declare that devicecomply with the
ISED regulation:
IC: 25953-WSBRC001
NOTICE:
This device complies with Part 15 of the FCC Rules [and contains license-exempt
transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development
Canada’s licence-exempt RSS standard(s)].
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux
CNR d’Innovation, Sciences et Développement économique Canada applicables aux
appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
NOTICE:
Changes or modifications made to this equipment not expressly approved by (manufacturer
name) may void the FCC authorization to operate this equipment.
  • Page 1 1
  • Page 2 2

Aev Spol WSBRC001 Manuel utilisateur

Marque
Aev Spol
Modèle
WSBRC001
Taper
Manuel utilisateur
Télécharger le PDF
rapport

dans d''autres langues

Autres documents