70mm
1523 26th St.
Santa Monica, CA 90404
Models: Ring Motion Sensor (5SM1S8), Ring Spotlight (5B11S8), Ring Steplight (5LD1S8),
Ring Pathlight (5LP1Y8), Ring Floodlight Battery (5B21S8), Ring Floodlight Wired
(5W21S8-A), Ring Transformer (5AT1S9)
Canada
CAN ICES-3 (B)/NMB-3(B)
Innovation, Science and Economic Development Canada (ISED) Compliance. This device
contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science
and Economic Development Canada’s license-exempt RSS(s). Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired
operation of the device.
Conformité Innovation Sciences et Développement Économique Canada (ISDE)
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme
aux CNR d’Innovation, Sciences et Développement économique Canada applicables
aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de
l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement
Caution: Any changes or modifications to this device not explicitly approved by
manufacturer could void your authority to operate this equipment.
Information Regarding Exposure to Radio Frequency Energy: This equipment complies
with IC RSS-102 RF exposure limits set forth for an uncontrolled environment.
Informations concernant l’exposition aux radiofréquences: Cet équipement est conforme
aux limites d’exposition aux rayonnements IC établies pour un environnement non
contrôlé.
MPE Reminding
This equipment should be installed and operated with minimum distance 20 cm between
the radiator and your body.
Cet équipement doit être installé et utilisé avec un minimum de 20 cm de distance entre
la source de rayonnement et votre corps.
United States
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment. Information on
this device is on file with the FCC and can be found by inputting the device’s FCC ID into
the FCC ID Search form available at https://www.fcc.gov/oet/ea/fccid.
The output power of the radio technology used in the Products is below the radio
frequency exposure limits set by the FCC. Nevertheless, it is advised to use the Products
in such a manner that minimizes the potential for human contact during normal
operation. This device should be installed and operated with at least 20 cm between the
radiator and your body.
General
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications.