Denso UR40-H-ERU Manuel utilisateur

UR40-H-ERU
Denso
Marque
Denso
Modèle
UR40-H-ERU
Taper
Manuel utilisateur
1
Regulatory Information
Fixed Type RFID Scanner
UR40-H-ERU
FCC Regulation (for United States of America)
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
This transmitter must not be co-located or operated in conjunction with any other antenna or
transmitter.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment
and meets the FCC radio frequency (RF) Exposure Guidelines. This equipment should be installed
and operated keeping the radiator at least 20cm or more away from person's body.
Supplier's Declaration of Conformity
47 CFR § 2.1077 Compliance Information
・Unique Identifier: UR40-H-ERU
・Responsible Party – U.S. Contact Information
Company Name: DENSO PRODUCTS AND SERVICES AMERICAS, INC.
Address: 3900 Via Oro Avenue, Long Beach, California 90810, U.S.A.
Tel: +1-310-834-6352
・FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
466144-4300
2
ISED Regulation (for Canada)
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science
and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following
two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired
operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d’en compromettre le fonctionnement.
This radio transmitter 1551C-UR40HERU has been approved by ISED to operate with the antenna
types listed below with the maximum permissible gain indicated. Antenna types not included in this
list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use
with this device.
Antenna type: URAN-40H1 Gain: 6 dBi Max
Le présent émetteur radio 1551C-UR40HERU a été approuvé par ISDE pour fonctionner avec les
types d’antenne énumérés ci‑dessous et ayant un gain admissible maximal. Les types d’antenne non
inclus dans cette liste, et dont le gain est supérieur au gain maximal indiqué, sont strictement interdits
pour l’exploitation de l’émetteur.
Type d’antenne: URAN-40H1 Gain : 6 dBi Max
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment
and meets RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment should be
installed and operated keeping the radiator at least 27cm or more away from person’s body.
Cet équipement est conforme aux limites d’exposition aux rayonnements énoncées pour un
environnement non contrôlé et respecte les règles d’exposition aux fréquences radioélectriques (RF)
CNR-102 de l’IC. Cet équipement doit être installé et utilisé en gardant une distance de 27 cm ou
plus entre le radiateur et le corps humain.
https://www.denso-wave.com/
1 Yoshiike Kusagi Agui-cho, Chita-gun, Aichi 470-2297, Japan
This manual uses recycled paper.
  • Page 1 1
  • Page 2 2

Denso UR40-H-ERU Manuel utilisateur

UR40-H-ERU
Denso
Marque
Denso
Modèle
UR40-H-ERU
Taper
Manuel utilisateur
Télécharger le PDF
rapport

dans d''autres langues

Autres documents