R-Go r-go RGOHBRSWLBL HE Break Mouse Manuel utilisateur

Marque: R-Go

Modèle: r-go RGOHBRSWLBL HE Break Mouse

Taper: Manuel utilisateur

7.RGB indicator light，Charging red LED on，

Fully charged and extinguished，Bluetooth

code matching blue LED on

4.forward

5.retreat

6.Lamp control indicator

1.Left click

2.Middle key

3.Right click

8. DPI Shift：DPI 400/800/1200/1600/2400 ，

Startup default1600

9. Long press and hold for 3 seconds for

Bluetooth pairing，Bluetooth code matching

blue LED on

DPI

10. 2.4GDongle storage bin（Magnetic suction type）

RF exposure statement

This equipment complies with the FCC and ISED radiation exposure limits set forth for an uncontrolled

environment. This transmitter must not be co-located or operating in conjunction with any other antenna or

transmitter.

Cet équipement est conforme aux limites d'exposition aux rayonnements de la FCC et de l'ISED établies pour un

environnement non contrôlé. Cet émetteur ne doit pas être co-localisé ou fonctionner en conjonction avec une

autre antenne ou un autre émetteur.

FCC Warning

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment.

IC WARNING

This device contains licence-exempt transmitter(s) that comply with Innovation, Science and Economic

Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

(1) This device may not cause interference.

(2) This device must accept any interference, including interference that may cause undesired operation of the

device.

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation,

Sciences et Développement économique Canada applicables aux appareils radio exempts de licence.

L’exploitation est autorisée aux deux conditions suivantes:

1. L’appareil ne doit pas produire de brouillage;

2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en

compromettre le fonctionnement.

R-Go r-go RGOHBRSWLBL HE Break Mouse Manuel utilisateur

Marque: R-Go

Modèle: r-go RGOHBRSWLBL HE Break Mouse

Taper: Manuel utilisateur

Télécharger le PDF

rapport

dans d''autres langues

English: R-Go r-go RGOHBRSWLBL HE Break Mouse User manual

R-Go r-go RGOHBRSWLBL HE Break Mouse Manuel utilisateur

R-Go r-go RGOHBRSWLBL HE Break Mouse Manuel utilisateur

dans d''autres langues

Autres documents