Lifefitness SMARTconnect RF Module Manuel utilisateur

Taper
Manuel utilisateur
LifeFitness
10601W.BelmontAve
FranklinPark,IL60131
1
Life Fitness SMARTconnect RF Module Manual
FCC ID of this product is as follows:
FCC ID: LM6-LFSCRF
IC Number of this product is as follows:
IC: 23315-LFSCRF
1. Description / Theory of Operation
LFSCRF is a powerful, generic Wi-Fi MCU module that has a rich set of peripherals. This module
is an ideal choice for a wide variety of application scenarios relating to Internet of Things (IoT),
wearable electronics and smart home.
LFSCRF integrates a rich set of peripherals, ranging from SPI, I²S, UART, I²C,LED PWM, ADC,
DAC, touch sensor, temperature sensor, as well as up to 43 GPIOs. It also includes a full-speed
USB On-The-Go (OTG) interface to enable USB communication.
LifeFitness
10601W.BelmontAve
FranklinPark,IL60131
2
2. Pin Layout
LifeFitness
10601W.BelmontAve
FranklinPark,IL60131
3
3. Pin Definitions
LifeFitness
10601W.BelmontAve
FranklinPark,IL60131
4
4. Power Ratings
5. Operating Condition
6. DC Characteristics
LifeFitness
10601W.BelmontAve
FranklinPark,IL60131
5
7. WiFi RF Standards
8. Physical Dimensions
LifeFitness
10601W.BelmontAve
FranklinPark,IL60131
6
9. PCB Land Pattern
LifeFitness
10601W.BelmontAve
FranklinPark,IL60131
7
10. Compliance Statements & Guidelines
FCC Statements
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that may cause
undesired operation.
Cet appareil est conforme à la section 15 des réglementations de la FCC. Le fonctionnement de
l’appareil est sujetaux deux conditions suivantes :
1) cet appareil ne doit pas provoquer d’interférences néfastes, et
2) cet appareil doit tolérer les interférences reçues, y compris celles qui risquent de provoquer un
fonctionnement indésirable.
Note: This product has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This product generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this product does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. End users must follow the specific operating instructions for satisfying RF exposure
compliance.
FCC Modular Usage Notes
LifeFitness
10601W.BelmontAve
FranklinPark,IL60131
8
Note 1: Any modifications made to the module will void the Grant of Certification, this module is
limited to OEM installation only and must not be sold to end-users, end-user shall have no
manual instructions to remove or install the device, only software or operating procedure shall
be placed in the end-user operating manual of final products.
Note 2: Additional testing and certification may be necessary when multiple modules are used.
Note 3: The module may be operated only with the integral chip antenna with which it is
authorized.
Note 4: The FCC ID label on the final system must be labeled with “Contains FCC ID: LM6-
LFSCRF” or “Contains transmitter module FCC ID:LM6-LFSCRF”.
Note 5: This modular transmitter is only FCC authorized for the specific rule parts listed on its
grant. The host product manufacturer is responsible to any other FCC rules that apply to the
host not covered by the modular.
ISED Statements
This device complies with Innovation, Science and Economic Development Canada’s license-
exempt RSS standard(s). Operation is subject to the following two conditions:
1) this device may not cause interference, and
2) this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement
Èconomique Canada applicables aux appareils radioexempts de licence. L'exploitation est
autorisée aux deux conditions suivantes :
1) l'appareil ne doit pas produire de brouillage, et
2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
Under Innovation, Science and Economic Development Canada’s regulations, this radio
transmitter may only operate using the integral antenna under which it was approved.
Conformément à la réglementation d’Innovation, Sciences et Développement Èconomique
Canada, le present émetteur radio peut fonctionner avec une antenne fonctionner qu’en utilisant
l’antenne intégrée sous laquelle il a été approuvé.
ISED Modular Usage Statement
NOTE 1: When the ISED certification number is not visible when the module is installed inside
another device,
LifeFitness
10601W.BelmontAve
FranklinPark,IL60131
9
then the outside of the device into which the module is installed must also display a label
referring to the enclosed module. This exterior label can use the wording ”Contains transmitter
module IC: 23315-LFSCRF” or “Contains IC: 23315-LFSCRF”.
NOTE 1: Lorsque le numéro de certification ISED n'est pas visible lorsque le module est installé
dans un autre appareil, l'extérieur de l'appareil dans lequel le module est installé doit également
afficher une étiquette faisant référence au module inclus. Cette étiquette extérieure peut être
libellée Contient le module émetteur IC: 23315-LFSCRF ou Contient IC: 23315-LFSCRF.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9

Lifefitness SMARTconnect RF Module Manuel utilisateur

Taper
Manuel utilisateur

dans d''autres langues