ROOMS TO GO 25024908 Assembly Instructions
- Taper
- Assembly Instructions
ASSEMBLY INSTRUCTIONS
MODEL No. CAN349-124/25024908
Important:
Be sure to check all packing material carefully for small parts which may come loose
inside carton during shipment. Separate, identify and count all parts and metal hardware.
Compare with part list and hardware illustrations to be sure all parts are present. If any part(s)
is missing or damaged contact your dealer's customer services deparment. For efficient and
fast service, please indicate the model number and the part needed.
ATTENTION:
Some lettered parts listed on the instruction sheets may not be in
the parts bag, they may already be assembled.
TOOLS REQUIRED
(Not included)
Phillips Screwdriver
HARDWARE:
BOLT 8 x 32 x 1/2" Part No.
HCPP-12A
(16 Pcs)
INSTALLED
RAIL
Part No. HCS-6250BK
(1 Pc)
INSTALLED
ANTI-TIP
Part No. HB-488 (1 Pc)
WHEEL AND PLATE
Part No. HHC-BAR149-BKTG
(4 Pcs)
INSTALLED
TUBE INSERT
Part No. HCPH-SB
(2 Pc)
INSTALLED
PULL
Part No. HBJ-BAR149-23
(4 Pcs)
INSTALLED
PAGE 1 OF 8
66" FIREPLACE TV CONSOLE
BACK PANEL
SHELF
FIREPLACE NOT INCLUDED
Step 1
.
Remove the central
back panel
and detach the
shelf
using a screwdriver as shown in
page 3.
PAGE 2 OF 8
FIRE PLACE INSTALLATION
Step 2
.
Place the fireplace inside the cabinet
Slide the panel back in.
J
K
J
K
STEP 1.
STEP 2.
STEP 3.
INSTRUCTIONS SHEET
ADJUSTABLE WOOD SHELF
PAGE 3 OF 8
Back View
ANTI-TIP
PART No HB-488
ANTI-TIP
Installation instructions:
This tip restraint must be attached to wall stub using 2” screw enclosed
1.Attach a bracket securely to the back top rail of the furniture using the 5/8” screw provided through the smaller hole.
2. Locate the other bracket on the wall over the wall stud and 2 inches below the mounting bracket secure to the back of
your unit. Attach to the wall stud using the 2’’ screw provided, through the smaller hole.
3. Place the furniture into position so both mounting brackets are vertically in line
4. Laces the end of the restraint strap though the larger hole in each mounting bracket. Bring both ends together and
slide the flat end through the looking end and flat draw it through until all slack is removed.
5. Confirm that the strap in securely laced and lacked.
Instrucciones de instalacion:
Este seguro contra volcado debe fijarse a un taco de pared con el tornillo de 2” que se incluye.
1. Coloque un soporte firmemente en la parte superior trasera del mueble ,usando el tornillo 5/8” que se proporciona y el
agujero mas pequeño
2. Ubique el otro soporte en la pared sobre un taco y 5cm (2pulg.) por debajo del soporte de montaje asegurado en la
parte bracera de la unidad .Fije al taco de pared usando el taco de 2’’ que incluye y el agujero mas pequeño .
3. Coloque el mueble en el sitio, de modo de modo que los dos soportes estén en una línea vertical.
4. Pase el extremo de una cinta de sujeción por el agujero más grande en cada soporte de montaje, una los dos
extremos y deslice el extremo plano por el lado del cierre, hasta que quede tenso.
5. Confirme que la cinta este bien asegurada.
Instructions d` installation:
Ce dispositif de sécurité doit être fixé au montai d` un mur a` l` aide de la vis de 5cm (2 po) fournie
1. fixer solidement un support a`la traversé supérieure du meuble, en passant la vis de 1,6cm (5/8 po) dans le plus petit
trou.
2. placer I` autre support sur un montant du mur, a` environ 5cm (po) plus bas, par rapport au premier support de fixation,
fixer ce support en passant la vis de 5cm (2 po) fournie dans le plus petit trou.
3. positionner le meuble afin d`aligner verticalement les deux supports de fixation
4. passer l`extrémité de i`attache dans les plus grands trous des deux supports. Joindre les extrémités insérer l`extrémité
plate dans le dispositif de blocage puis tirer au maximum pour desserrer.
5. vérifier que l`attache est solidement fixée et bloquée.
Warning Advertencia Avertissement
WARNING INSTALL FURNITURE TIPPING RESTRAINT KIT
PAGE 4 OF 8
WARNING
THIS UNIT IS NOT INTENDED FOR USE WITH CRT TVs.
USE ONLY WITH FLAT PANEL TVs AND AUDIO/VIDEO EQUIPMENT
MEETING THE RECOMMENDED WEIGHT AND SIZE LIMITS. NEVER USE
WITH LARGER/HEAVIER TV'S OR EQUIPMENT THAN RECOMMENDED.
TO AVOID INSTABILITY, PLACE FLAT PANEL TV IN THE CENTER OF THE
UNIT. THE BASE OF THE TELEVISION MUST BE ABLE TO REST ON THE
SUPPORTING SURFACE OF THE UNIT WITHOUT OVER-HANGING THE
EDGES. IMPROPERY POSITIONED FLAT PANEL TVs OR FLAT PANEL TVs
INCLUDING OTHER EQUIPMENT THAT EXCEED THE RECOMMEND SIZE
AND WEIGHT LIMITS COULD FALL OFF OR BREAK THE UNIT, CAUSING
POSSIBLE SERIOUS INJURY. FOR USE WITH TVs WEIGHING LESS THAN
90 LBS (40KG)
OR LESS. USE WITH HEAVIER TELEVISIONS MAY RESULT
IN INSTABILITY CAUSING A TIP OVER RESULTING IN DEATH OR SERIOUS
INJURY.
MAXIMUM RECOMMENDED WEIGHT LOADS
MANUFACTURER: Oak Furniture West
ADRESS: Otay Mesa Ca. 92154
CATALOG: TV CONSOLE
MODEL: CAN349-124/25024908
Fits most 70" flat panel tvs. Maximum load 90 lbs.
Maximum shelf load 25 lbs.
PAGE 5 OF 8
WARNING
THIS UNIT IS NOT INTENDED FOR USE WITH CRT TVs.
USE ONLY WITH FLAT PANEL TVs AND AUDIO/VIDEO EQUIPMENT
MEETING THE RECOMMENDED WEIGHT AND SIZE LIMITS. NEVER USE
WITH LARGER/HEAVIER TV'S OR EQUIPMENT THAN RECOMMENDED.
TO AVOID INSTABILITY, PLACE FLAT PANEL TV IN THE CENTER OF THE
UNIT. THE BASE OF THE TELEVISION MUST BE ABLE TO REST ON THE
SUPPORTING SURFACE OF THE UNIT WITHOUT OVER-HANGING THE
EDGES. IMPROPERY POSITIONED FLAT PANEL TVs OR FLAT PANEL TVs
INCLUDING OTHER EQUIPMENT THAT EXCEED THE RECOMMEND SIZE
AND WEIGHT LIMITS COULD FALL OFF OR BREAK THE UNIT, CAUSING
POSSIBLE SERIOUS INJURY. FOR USE WITH TVs WEIGHING LESS THAN
90 LBS (40KG)
OR LESS. USE WITH HEAVIER TELEVISIONS MAY RESULT
IN INSTABILITY CAUSING A TIP OVER RESULTING IN DEATH OR SERIOUS
INJURY.
MAXIMUM RECOMMENDED WEIGHT LOADS
MANUFACTURER: Oak Furniture West
ADRESS: Otay Mesa Ca. 92154
CATALOG: TV CONSOLE
MODEL: CAN349-220/25034909
Fits most 70" flat panel tvs. Maximum load 90 lbs.
Maximum shelf load 25 lbs.
PAGE 5 OF 8
TV Placement on the console:
"Always place TV no more than two inches from the back edge of the console.
Placing TV more than two inches from the back edge may increase the risk
that the console will tip over'
Safety Alert Information:
Moving furniture that is not designed to be moved or equipped with casters may
result in injury or damage to furnishings and/or personal property.
Always
unload shelves and drawers, starting with top surfaces, before moving.
Never
push or pull furniture on carpet. Have a second person help lift properly to
move and/or reposition furniture.
MANUFACTURER: Oak Furniture West
ADRESS: Otay Mesa Ca. 92154
CATALOG: TV CONSOLE
MODEL: CAN349-124/25024908
PAGE 8 OF 8
-
1
-
2
-
3
-
4
-
5
-
6
-
7
ROOMS TO GO 25024908 Assembly Instructions
- Taper
- Assembly Instructions
dans d''autres langues
- English: ROOMS TO GO 25024908
Documents connexes
-
ROOMS TO GO 26325008 Assembly Instructions
-
-
-
-
-
-
-
-
-
