TECHNICAL FILE
R03.003_12/04/2016
Novoescocia® 1 Stainless steel
Page 2 of 3
Installation
Please, rst of all, clean the surface of Novoescocia® 1 Stainless steel. Then:
1. Introduce abundant x material on the back surface of Novoescocia® 1 stainless steel. This
material could be an adhesive as silicone, polyurethane mastic or other adhesives.
2. Then lean the prole lenghtwise against the angle made between the oor and the wall.
3. After this, place the wall and the oor placing them against the prole .
4. Finally, clean carefully the spare material and let it dry.
* In wet areas or places with direct contact with water it is recommended use silicone.
Materials
Stainless
steel
Novoescocia® 1 Stainless Steel is a prole made of AISI-304 stainless steel. All material batches are
tested with the composition test to determine that they fulll with the specication of the alloy. Stainless
steel used in the Emac® products has been also tested with salt spray test, exceeding 500 hours of
exposition without signs of corrosion.
Stainless steel is a highly durable and resistent material, with an excellent supercial appearance that
does not degrade along the time. Available in brushed nish. This nish is slightly porous and smooth,
making easier the hygiene of the installation.
Zamak
The complementary piece of Novoescocia® 1 Stainless steel is made of Zamak. Zamak is a non ferrous
alloy of Zinc with aluminium, magnesium and copper (UNE EN 1774). It is tough, has high hardness, high
mechanical strength and excellent plastic deformability.
*You can nd out more information by consulting the Technical les of materials in www.emac.es
Technical features and tests
Alloy
AISI-304
Composition test of each batch
AIMME
Corrosion resistance
Salt spray test
+ 504 hours without change (stainless
steel)
UNE 112017:92
AIMME
Cleaning and maintenance
The immediate cleaning of the material after its installation is necessary to avoid that remainings of
mortar, concrete or iron particles from wool or tools could cause corrosion.
For indoor applications, you can use water with detergent or liquid soap to remove dirtiness and pos-
sible ngerprints marked on the surface. In high brightness nishes, you can use a glass cleaner. There
are specic cleaners in the markets for stainless steel which clean the material and reduce possible
stains. Whenever you clean stainless steel, ensure you rinse it well and dry totally to prevent fogging.
Steel wool or similar products, are not recommended because they could scratch the surface and
create pitting corrosion. Pay special attention while using materials containing chlorides, they are not
indicated because could oxidize the material. Hydrochloric acid or iron products in a long contact with
the material are neither recommended. Do not use cleaners for common steel for the cleaning of
stainless steel.
-
1
dans d''autres langues
- English: Emac NS116X Installation guide
Documents connexes
-
Emac 4V92 Manuel utilisateur
-
Emac NRE88656 Guide d'installation
-
Unbranded SMR92 Mode d'emploi
-
-
-
-
Emac NSS12136A Manuel utilisateur
-
-
-