Insignia NS-MQP15W22K Mode d'emploi

NS-MQP15W22K
Insignia
Marque
Insignia
Modèle
NS-MQP15W22K
Taper
Mode d'emploi
PACKAGE CONTENTS
• 15 W Qi Charging Pad
• DC power adapter with
6 ft. (1.8 m) cable
• Quick Setup Guide
FEATURES
• 15 W output designed to fast charge demanding next-generation
devices
• Wireless design charges devices without cumbersome cords
• Blue LED shows that your device is charging
• DC power adapter with 6 ft. (1.8 m) charging cable
PRODUCT OVERVIEW
Before using your new product, please read these instructions to prevent any damage.
USING YOUR CHARGING PAD
1 Plug the power adapter into your charging pad and into a power
outlet.
2 Place your Qi-enabled device on the center of your charging pad
with the screen facing up. If your device is quick charging, the
purple LED lights.
Note: If the LED is red only, your device is not charging.
CAUTION: Do not place objects between your device and the charging pad.
See “TROUBLESHOOTING” for more information.
LED INDICATOR STATUS
TROUBLESHOOTING
Device not charging/LED is red only
• Make sure that your device is Qi-enabled.
• Make sure that your charging pad is connected to a working
power outlet.
• Make sure that your device is positioned correctly on your
charging pad.
• Make sure there are no objects between your device and the
charging pad.
• Remove your device’s case. It may be blocking the wireless signal.
QUICK SETUP GUIDE
15 Watt Qi Wireless
Charging Pad
NS-MQP15W22K / NS-MQP15W22K-C
Flat size (W×H): 12 × 2.75 in. (304.8 × 69.85 mm)
Final folded size: 3 × 2.75 in. (76.2 × 69.85 mm)
COMPATIBILITY
Any Qi-enabled devices up to
15 W, including smartphones,
headphones, and smart
watches.
DC portLED indicator
Back
Front
LED
Blinking blue
Solid blue
Purple on
Solid red
Blinking red
STATUS
Standby
Charging
Quick charging
Insucient input power
Charging error
DC charging
cable
NS-MQP15W22K_-C_21-1105_QSG_V2_EN.ai 1 12/17/2021 6:07:44 PMNS-MQP15W22K_-C_21-1105_QSG_V2_EN.ai 1 12/17/2021 6:07:44 PM
V2
FINAL
FOR PRINT
LEGAL NOTICES
FCC Information
FCC Caution: Changes or modications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
FCC Statement: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC statement: This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20 cm between the radiator and your
body. This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
RSS-Gen statement:
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two
conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation
of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux conditions suivantes :
(1) L’appareil ne doit pas produire de brouillage;
(2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d’en compromettre le fonctionnement.
This equipment complies with IC RSS‐102 radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm between
the radiator and your body.
Cet équipement est conforme aux limites d'exposition aux radiations IC CNR‐102 établies pour un
environnement non contrôlé. Cet équipement doit être installé et utilisé avec une distance minimale de
20 cm entre le radiateur et votre corps.
SAFETY INFORMATION
• Avoid dropping.
• Do not disassemble.
• Do not place metal objects between devices and the wireless charging pads.
• Thick protective case (≥ .2 in. [5 mm]) or a case that includes a magnet or metallic material, may not
allow proper charging function.
• Keep wireless charging pad away from any liquid or moisture.
• The maximum ambient temperature during use of this product must not exceed 113° F (45° C).
• Do not place this device in re or other excessively hot environments.
• Must use provided adapter for proper function, if not it may malfunction.
ONEYEAR LIMITED WARRANTY
Visit www.insigniaproducts.com for details.
CONTACT INSIGNIA:
1-877-467-4289 (U.S. and Canada)
www.insigniaproducts.com
INSIGNIA is a trademark of Best Buy and its aliated companies
Distributed by Best Buy Purchasing, LLC
7601 Penn Ave South, Richeld, MN 55423 U.S.A.
©2022 Best Buy. All rights reserved.
Device charges slowly
• Your device may charge more slowly with the charging pad than
a charging cable. This is normal behavior.
• Make sure that your device is positioned in the center of your
charging pad.
• Make sure there are no objects between your device and the
charging pad.
CAUTION: Only use the cable with the attached power adapter that came with
your charger. Using a dierent cable and adapter can decrease charging
performance or damage your charger.
SPECIFICATIONS
Qi Wireless Charging Pad:
Dimensions: 3.9 × 3.9 × 0.4 in. (10 × 10 × 1.1 cm)
Input: DC 15 V/1.8 A
Output: 15 W max.
AC power adapter:
Input: 100-240 V ~ 50/60 Hz 0.7 A
Output: DC 15 V/1.8 A
DC charging cable: 6 ft. (1.8 m) V2 ENGLISH 21-1105
NS-MQP15W22K_-C_21-1105_QSG_V2_EN.ai 2 12/17/2021 6:07:49 PMNS-MQP15W22K_-C_21-1105_QSG_V2_EN.ai 2 12/17/2021 6:07:49 PM
  • Page 1 1
  • Page 2 2

Insignia NS-MQP15W22K Mode d'emploi

NS-MQP15W22K
Insignia
Marque
Insignia
Modèle
NS-MQP15W22K
Taper
Mode d'emploi
Télécharger le PDF
rapport

dans d''autres langues

Documents connexes

Autres documents