Global Industrial 320821 Manuel utilisateur

320821
Global Industrial
Marque
Global Industrial
Modèle
320821
Taper
Manuel utilisateur
1
User's manual Manual del usuario Manuel de l'utilisateur
Customer Service
US: 1-800-645-2986
Servicio de atención al Cliente
US: 1-800-645-2986
Service à la clientèle
Canada: 888-645-2986
Cantilever Rack
Starter Sets
Models: 320821, 320822, 320823, 320824, 320825, 320826, 320827, 320828, 320829, 320830
248371, 248372, 248373
298900, 298901, 298902, 298903, 298904, 298905, 298906, 298907, 298908, 298909
L, 248374 L, 248383 L, 248384 L, 248385, 248385 L, 248386 L, 248387 L
Components
• (2) Cantilever Upright Kit
• (2) Cantilever Base Kit (with 5 M16x101)
• (1) Cantilever Bracket Brace Kit
• (4) M12x75 Bolts
• (6, 8, 12, or 16) Cantilever Arms
• (8, 12, or 16) Lock Pins
1. Using the M16x101bolts
included with the base, secure
the post to the base using all 5
bolts. Repeat for other base and
post
FOR SINGLE SIDED:
Secure posts to end of base
FOR DOUBLE SIDED:
Secure posts to middle of base
(10)
M16x101
2.(a) Using hardware included in X brace kit, lay out two H
braces and connect the X brace to each corner, forming the
"X" with the H bars across the top and bottom.
(b) Connect the HX Brace to the posts using remaining
hardware included in brace kit. Connect to one side post
completely before connecting to the other.
FOR 120" UNITS: Connect third H post to side
posts for added structural security
2a
HX Brace
2b.
Bolts
3.
position. Use 2 per base M12x75
Anchors to bolt the cantilever to the
ground. Once all four bolts are secure,
move to next step.
Anchors
4. Lift each arm into position and
secure arm with M16x87 bolt.
Repeat for each arm.
4.
M16x87 Bolts
2
Heavy Duty Cantilever Rack
• MAXIMUM CAPACITY FOR EACH ARM IS 1200lbs. DO NOT
OVERLOAD. Check the label on each arm.
• Do not load arms in a way that the load exceed the length of
the arm. Leave at least 4" unloaded from the end of the arm.
• Be cautious of tipping. The center of mass of the load must
be located less than halfway up the length of the arm.
• The width of the cargo must not exceed 2 times the width of
the cantilever rack.
BEST LOADING PRACTICE
WARNINGS
User Manual
  • Page 1 1
  • Page 2 2

Global Industrial 320821 Manuel utilisateur

320821
Global Industrial
Marque
Global Industrial
Modèle
320821
Taper
Manuel utilisateur
Télécharger le PDF
rapport

dans d''autres langues

Documents connexes

Autres documents