Motorola PSS-3CR01 Quick Reference Manual

Marque: Motorola

Modèle: PSS-3CR01

Taper: Quick Reference Manual

PSS-3CR01 Charging Cradle

Quick Reference Guide

2 PSS-3CR01 Charging Cradle

Motorola reserves the right to make changes to any product to improve reliability,

function, or design.

Motorola does not assume any product liability arising out of, or in connection

with, the application or use of any product, circuit, or application described herein.

No license is granted, either expressly or by implication, estoppel, or otherwise

under any patent right or patent, covering or relating to any combination, system,

apparatus, machine, material, method, or process in which Motorola products

might be used. An implied license exists only for equipment, circuits, and

subsystems contained in Motorola products.

MOTOROLA, the Stylized M Logo and Symbol and the Symbol logo are

registered trademarks of Motorola, Inc. Other product names mentioned in this

manual may be trademarks or registered trademarks of their respective

companies and are hereby acknowledged.

Motorola, Inc.

One Motorola Plaza

Holtsville, N.Y. 11742-1300

http://www.motorola.com

Warranty

For the complete Motorola hardware product warranty statement, go to:

http://www.symbol.com/warranty

Patents

This product is covered by one or more patents. For patent information go to:

http://www.symbol.com/patents

Quick Reference Guide 3

Introduction

The PSS-3CR01 Charging cradle is used to charge the MC17 mobile computer.

There are two configurations available: The PSS-3C01-01R contains a locking

mechanism that locks the mobile computer in the cradle and the PSS-3C01-NLR

that does not contain the locking mechanism.

Mounting the Cradle

The cradle contains mounting holes in the back housing so that it can be secured

to supporting furniture. In addition, it come with plugs and a variety of cable

routing outlets. Cable outlets not used can be concealed with the plugs provided.

Refer to the Product Reference Guide for information required to design correct

mounting holes for the charge cradle.

Wiring

1. Install power supply, including AC

line cord and power cable, into

Decorative Housing.

2. Insert power cable through a cable

outlet of cradle back housing.

3. Plug connector into power

connector on printed circuit board.

4. If more than one cradle, connect the

interconnect cable from the first

cradle to the second cradle.

5. Use plugs to cover un-used cable

outlets.

There are some general limitations that

must be taken into account when

designing a system:

NOTE During installation

ensure all interconnect

cables are fully

enclosed within the

power supply or cradle

enclosure.

Power Cable

25-66420-01R

Interconnect Cable 25-66431-01R

Power Supply

50-14000-241R (inside

Decorative Housing)

4 PSS-3CR01 Charging Cradle

• No more than six cradles can be powered off of one power supply and power

cable 25-66420-01R.

• No more than 12 cradles can be powered off of one power supply and “Y”

power cable 25-67592-01R.

• No more than six cradles can be powered off each leg of the “Y” power cable.

• A power supply cable runs from the power supply to one or two cradles.

• Cradle interconnection cables run between each successive cradle in the

chain.

The illustration below shows how the maximum number of cradles can be cabled

to a power supply using power cable 25-66420-01R.

The illustration below shows how the maximum number of cradles can be cabled

to a power supply using the “Y” power cable 25-67592-01R. Note that there are

only six cradles per leg of the power supply cable, and only 12 cradles in total.

Quick Reference Guide 5

Assembly

1. Replace cover.

2. Secure the two captive screws.

3. Insert bar code target cover.

4. Push target cover into front cover until it snaps into place.

Removing the Front Cover

To remove the front cover:

1. Squeeze the top and bottom of the target cover to remove.

NOTE Do not install the target cover until you are sure that you do not

need to remove the front cover again.

Place cradle ID bar code on target cover prior to installing the

target cover.

6 PSS-3CR01 Charging Cradle

2. Loosen two captive screws securing the front cover to the back housing.

3. Pull front cover away from back housing and then lift out of the back housing.

Battery Charging

• The Li-Ion battery recharges when

the mobile computer is inserted in

the cradle.

• The cradle charge LED turns red

when the mobile computer is

inserted in the cradle, then turns

green when charging is complete.

CAUTION The temperature range for charging the battery is 0°C to

40°C (32°F to 104°F).

Tar ge t Co ve r

Charge LED

(behind front panel)

Quick Reference Guide 7

LED Indications

Troubleshooting

Regulatory Information

This device is approved under the Symbol Technologies brand; Symbol

Technologies, Inc., is the Enterprise Mobility business of Motorola, Inc

(“Motorola”)

All Symbol devices are designed to be compliant with rules and regulations in

locations they are sold and will be labeled as required.

Local language translations are available at the following website:

http://support.symbol.com

Condition Cradle Charge LED

Red Mobile computer is inserted in the cradle and the battery

is charging.

Green Battery is fully charged.

Off Mobile computer is not properly inserted in the cradle.

Symptom Possible Cause Action

Cradle red Charge

LED indicator does

not light when

mobile computer is

inserted in cradle.

Mobile computer is

not seated firmly in

cradle.

Replace mobile computer

securely in cradle.

Battery is not

installed in the

mobile computer.

Install battery.

Battery in the

mobile computer did

not recharge.

Battery failed. Replace battery.

Mobile computer

was removed from

cradle too soon.

Replace mobile computer in the

cradle. Approximately 5 hours

are required to recharge a fully

discharged battery.

8 PSS-3CR01 Charging Cradle

Any changes or modifications to Symbol Technologies equipment, not expressly

approved by Symbol Technologies, could void the user's authority to operate the

equipment.

Power Supply

Use only a Symbol approved power supply output rated at 12Vdc and minimum

9A. The power supply shall be Listed to UL/CSA 60950-1; and certified to

IEC60950-1 and EN60950-1 with SELV outputs. Use of alternative power supply

will invalidate any approval given to this device and may be dangerous.

Radio Frequency Interference Requirements-FCC

Note: This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 15 of the

FCC rules. These limits are designed to provide reasonable

protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However there is no

guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to

try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and receiver

• Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected

• Consult the dealer or an experienced radio/TV technician for help.

Radio Frequency Interference Requirements - Canada

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du

Canada.

Quick Reference Guide 9

Marking and European Economic Area (EEA)

Statement of Compliance

Symbol Technologies, Inc. hereby declares that this device is in compliance with

all the applicable Directives, 2004/108/EC and 2006/95/EC. A Declaration of

Conformity may be obtained from http://www2.symbol.com/doc/.

Japan (VCCI) - Voluntary Control Council for Interference

この装置は、情報処理装置等電波障害自主規制協議会（ＶＣＣＩ）の基準に基

づくクラス B 情報技術装置です。この装置は、家庭環境で使用することを目的

としていますが、この装置がラジオやテレビジョン受信機に近接して使用される

と、受信障害を引き起こすことがあります。取扱説明書に従って正しい取り扱

いをして下さい。

This is a Class B product based on the standard of the Voluntary Control Council

for Interference from Information Technology Equipment (VCCI). If this is used

near a radio or television receiver in a domestic environment, it may cause radio

interference. Install and use the equipment according to the instruction manual.

Korea Warning Statement for Class B ITE

Waste Electrical and Electronic Equipment (WEEE)

English: For EU Customers: All products at the end of their life must be returned

to Motorola for recycling. For information on how to return product, please go to:

http://www.symbol.com/environmental_compliance.

Bulgarish: За клиенти от ЕС: След края на полезния им живот всички

продукти трябва да се връщат на Motorola за рециклиране. За информация

기 종 별 사용자 안내문

B 급 기기 이 기기는 가정용으로 전자파 적합등록을 한 기기이오니

주거지역에서는 물론 모든 지역에서 사용할 수 있습니다 .

Class User’s Guide

B class As this equipment has obtained EMC registration for

household use, it can be used in any area including

residential areas.

10 PSS-3CR01 Charging Cradle

относно връщането на продукти, моля отидете на адрес:

http://www.symbol.com/environmental_compliance

Dansk: Til kunder i EU: Alle produkter skal returneres til Motorola til recirkulering,

når de er udtjent. Læs oplysningerne om returnering af produkter på:

http://www.symbol.com/environmental_compliance.

Deutsch: Für Kunden innerhalb der EU: Alle Produkte müssen am Ende ihrer

Lebensdauer zum Recycling an Motorola zurückgesandt werden. Informationen

zur Rücksendung von Produkten finden Sie unter

http://www.symbol.com/environmental_compliance.

Eesti: EL klientidele: kõik tooted tuleb nende eluea lõppedes tagastada

taaskasutamise eesmärgil Motorola'ile. Lisainformatsiooni saamiseks toote

tagastamise kohta külastage palun aadressi:

http://www.symbol.com/environmental_compliance.

Español: Para clientes en la Unión Europea: todos los productos deberán

entregarse a Motorola al final de su ciclo de vida para que sean reciclados. Si

desea más información sobre cómo devolver un producto, visite:

http://www.symbol.com/environmental_compliance.

Français : Clients de l'Union Européenne : Tous les produits en fin de cycle de vie

doivent être retournés à Motorola pour recyclage. Pour de plus amples

informations sur le retour de produits, consultez :

http://www.symbol.com/environmental_compliance.

Italiano: per i clienti dell'UE: tutti i prodotti che sono giunti al termine del rispettivo

ciclo di vita devono essere restituiti a Motorola al fine di consentirne il riciclaggio.

Per informazioni sulle modalità di restituzione, visitare il seguente sito Web:

http://www.symbol.com/environmental_compliance.

Quick Reference Guide 11

Magyar: Az EU-ban vásárlóknak: Minden tönkrement terméket a Motorola

vállalathoz kell eljuttatni újrahasznosítás céljából. A termék visszajuttatásának

módjával kapcsolatos tudnivalókért látogasson el a

http://www.symbol.com/environmental_compliance weboldalra.

Nederlands: Voor klanten in de EU: alle producten dienen aan het einde van hun

levensduur naar Motorola te worden teruggezonden voor recycling. Raadpleeg

http://www.symbol.com/environmental_compliance voor meer informatie over het

terugzenden van producten.

Português: Para clientes da UE: todos os produtos no fim de vida devem ser

devolvidos à Motorola para reciclagem. Para obter informações sobre como

devolver o produto, visite: http://www.symbol.com/environmental_compliance.

Românesc: Pentru clienţii din UE: Toate produsele, la sfârşitul duratei lor de

funcţionare, trebuie returnate la Motorola pentru reciclare. Pentru informaţii

despre returnarea produsului, accesaţi:

http://www.symbol.com/environmental_compliance.

Slovenski: Za kupce v EU: vsi izdelki se morajo po poteku življenjske dobe vrniti

podjetju Motorola za reciklažo. Za informacije o vraèilu izdelka obišèite:

http://www.symbol.com/environmental_compliance.

Suomi: Asiakkaat Euroopan unionin alueella: Kaikki tuotteet on palautettava

kierrätettäväksi Motorola-yhtiöön, kun tuotetta ei enää käytetä. Lisätietoja tuotteen

palauttamisesta on osoitteessa

http://www.symbol.com/environmental_compliance.

Svenska: För kunder inom EU: Alla produkter som uppnått sin livslängd måste

returneras till Motorola för återvinning. Information om hur du returnerar produkten

finns på http://www.symbol.com/environmental_compliance.

If you have a problem using the equipment, contact your facility’s Technical or

Systems Support. If there is a problem with the equipment, they will contact the

Motorola Enterprise Mobility Support at: http:www.symbol.com/contactsupport

For the latest version of this guide go to: http://www.symbol.com/manuals

Motorola, Inc.

One Motorola Plaza

Holtsville, New York 11742, USA

1-800-927-9626

http://www.motorola.com

MOTOROLA and the Stylized M Logo and Symbol and the Symbol logo are registered in the U.S.

Patent and Trademark Office. All other product or service names are the property of their

72-104413-02 Revision A - May 2008

Service Information

Motorola PSS-3CR01 Quick Reference Manual

Marque: Motorola

Modèle: PSS-3CR01

Taper: Quick Reference Manual

Télécharger le PDF

rapport

dans d''autres langues

English: Motorola PSS-3CR01

Motorola PSS-3CR01 Quick Reference Manual

Motorola PSS-3CR01 Quick Reference Manual

dans d''autres langues

Documents connexes

Autres documents