AIPER Seagull 800B Manuel utilisateur

封面

Seagull 800B

User Manual

ROBOTIC POOL CLEANER

EN

封面内页

Thank you for choosing AIPER robotic pool cleaner.

You have joined millions of people to enjoy the convenience of

robotic pool cleaning.

This user manual helps you to keep your robot performing at its best.

Please take a few moments to read it through.

If you have any questions, please contact our customer service for

assistance or visit www.aiper.com for more information.

封面内页

US Toll Free: 1-866-850-0666

Email: service@aiper.com

Facebook: @AiperOfﬁcial

Aiper Customer Service:

1. Introduction

2. Structure

3. Speciﬁcations & Working Conditions

4. Use The Pool Cleaner

5. Clean The Filter Tray

6. Maintenance & Storage

7. Light Indicator

8. Packing List

IMPORTANT SAFETY INSTRUCTIONS

CONTENTS

1

3

4

5

9

10

14

15

3

--------------------------------------

-----------------------------------------

-----------

----------------------------

-----------------------------

--------------------------

-----------------------------------

-------------------------------------

-----------------------------------------

9. Warranty

-------------

Read the manual carefully, and use the cleaner according to the manual.

We are not liable for any losses or injuries caused by improper use.

READ AND FOLLOW ALL INSTRUCTIONS

1. Do not operate the cleaner when people or animals are in the pool.

2. Turn off the cleaner when maintaining, cleaning or when it is not in use.

3. Do not allow children to ride on the cleaner, or play with it without

supervision or instruction.

4. Use the original and authorized power adapter only.

5. The adapter cord should only be replaced by a qualiﬁed electrician.

6. The charging adapter must be connected to a leakage protected and

earthed socket when charging.

7. Make sure the charging socket is dried before charging.

8. While charging, the cleaner should be kept in a cool place, and not

covered with anything to prevent the damage of internal electrical

components by overheating.

9. Do not run the cleaner when it is out of water, as it may damage the

cleaner by overheating.

10. Only certiﬁed professionals can disassemble the sealed driving kit of

the cleaner.

11. Do not operate the cleaner while pool ﬁlter is running.

12. Oil sealing for motor contains grease, which may cause water pollution

if grease leaks.

13. Do not use or store the cleaner near any heat source.

14. Do not pierce the shell of the cleaner with nails or other sharp objects.

Do not hammer, impact, or throw the cleaner.

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS

1

FCC Statement

NOTE: This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

Compliance Declaration

This device complies with Part 15 of the FCC Rules. Operation is subject

to the following two conditions: (1) this device may not cause harmful

interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

Importer: Aiper Intelligent, LLC.

Address: 2700 Cumberland Parkway, Suite 350, Atlanta, Georgia 30339

Telephone: +1 866-850-0666

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Please note that changes or modiﬁcations of this product is not

expressly approved by the party responsible for compliance (Aiper)

could void the user's authority to operate the equipment.

2

Handle

BrushesChargerRetrieving Hook

Top Cover

Filter Tray

Chassis

This environment-friendly robotic pool cleaner Seagull 800B is a new

type of rechargeable automatic cleaner that ﬁlters the pool water with-

out replacing the pool water.

Please read this user manual carefully before using it.

1. Introduction

2. Structure

3

3. Speciﬁcations & Working Conditions

5. Run Time: up to 90 Minutes

6. IP Grade: IPX8 Waterproof

7. Max Water Depth: 10ft (3m)

2. Charger Input: 100~240V, 50/60Hz

3. Charger Output: 12.6V/1.8A

4. Charging Time: 2.5 Hours

1. Pool Size: 800sq.ft/80m², flat floor only

CAUTION:

Use the cleaner in the water conditions below:

pH Value: 7.0-7.4

ChlorineMaximum 4 ppm

NaCl: Maximum 5000 ppm

Temperature: 50-95°F (10-35°C)

4

4.1 Important Precautions

4. Use The Pool Cleaner

a

A. This model only applies to swimming pools with a flat floor with no

slopes, up to 800sq.ft/80m².

800sq.ft / 80m²

B. Insert the included 2 brushes tightly to the bottom slots of the cleaner

and you will hear a click sound.

5

C. Power off the cleaner after use.

b

6

D. Put into or lift out of the pool with the cleaner bottom towards the wall

to avoid any possible scratches to the pool or the machine.

d

Fully charge the cleaner before cleaning your pool.

Power off the cleaner before charging.

4.2 Charging

Clean and dry the charging port before charging.

When charging, do not make the bottom up to prevent the handle from

being crushed.

Do not make

the bottom up Handle facing up

Blue light flashing slowly indicates the battery is charging.

Blue light staying ON indicates that charging is completed.

a. Press and hold the power button till the blue light stays ON with a beep.

Drop the cleaner into the water in 30 seconds. The cleaner will work

after 5 seconds, with the white light staying ON.

4.3 Working

a

2. Stay Blue

1. Beep

7

b

c. Attach the included hook to your pool pole and hook up the handle of

the cleaner to lift it out of the water.

c

b. When the battery is low, the red light flashes slowly and automatically

stops alongside the pool wall. The red light will flash for 60 seconds

and power OFF, to be retrieved back.

8

b

b. Take off the top cover of the machine and take the ﬁlter tray out.

c

c. Dump the dirt and debris in the bottom shell. Wash the shell and ﬁlter

tray with water.

a. Open the two small buckles in the front and back of the machine, then

slightly open the two big buckles at the sides of the machine.

5. Clean The Filter Tray

a

Open

9

a

Wash now

Not cleaned for a long time

a. Always wash the ﬁlter tray IMMEDIATELY after use. The ﬁlter tray will be

blocked by dried debris and hard to remove if it’s not washed in time.

6. Maintenance & Storage

d. After all is cleaned, put the ﬁlter tray back and lock the top cover with

buckles.

d

Close

10

3) Press the two locking bars down and get the brush out;

4) Insert your new brush (not included) to the bottom slot of the

cleaner.

Push

b2

b. Replace a Brush:

If a brush is worn out, please take the brush off with the steps below.

1) Take off the top cover of the machine and ﬁnd the brush position;

2) Use your ﬁnger or a small tool to push the two small locking bars

aside, as the arrows show below;

Push

b1

11

c2

c. Replace a Wheel:

If a wheel breaks, please see the steps below for replacing it.

1) Take off the top cover of the machine and ﬁnd the broken wheel

position;

2) Use your ﬁnger or a small tool to push the wheel buckle till it bends

a little and push down the top of the black wheel stem and keep

the white wheel stem catch part, as the arrows show below;

c1

12

d. The cleaner should be stored in a cool and ventilated place, away from

direct sunshine.

e. If the cleaner needs to be stored for a long period of time, it should

be charged every three months to maintain battery life between

40%-60%. Please use the original and authorized power adapter

only. If the cleaner is not charged for a long time, the battery voltage

will be lower than the over-discharge protection voltage due to the

self-discharge of the battery, which may cause fatal damage.

3) Insert the included new spare wheels to the white wheel stem

catch, and align it with either of the two small holes of the wheel

position; lock it up and you will hear a click sound.

No charging

for a long time Recharge every

three months

e

c3

13

Charging

Charging Completed

Low Battery Warning

Power ON/Battery Level

Power OFF

Working (Motors Running)

Impeller Blocked

Power Failure

Filter Tray Blocked

Water Immersed

Working Status

Blue light flashes slowly

Blue light stays on

Red light flashes slowly

Blue light stays on/Blue light numbers

Lights OFF

White light stays on

Red and green lights flash in turn

Blue light flashes fast

Green and blue lights flash in turn

Red and blue lights flash in turn

Light Indicator

5

6

1

2

3

4

8

10

7

9

NO.

7. Light Indicator

Retrieving Hook

User Manual

Brushes

Cleaner

Charger

Name

5

1

2

3

4

NO.

8. Packing List

Seagull 800B

Model

1

2

Spare Wheels

62

1

QTY(pc)

14

1. The warranty is covered for 12 months (only for battery and motor)

from the date of its original purchase.

2. This warranty is voided if the product has been altered, misused, or has

been repaired by unauthorized personnels.

3. The warranty extends only to manufacturing defects and does not

cover any damage resulting from mishandling of the product by the

owner.

4. The order number or record must be presented for any claim or repair

during the warranty period.

This product has passed all quality control and safety tests, conducted by

the technical department of the factory.

9. Warranty

15

CONFORMS TO UL STD. 1081

CERTIFIED TO CSA STD.

C22.2 NO. 108

5023983

La page est en cours de chargement...

AIPER Seagull 800B Manuel utilisateur

AIPER Seagull 800B Manuel utilisateur

dans d''autres langues

Autres documents