GSD W37M2510 Wi-Fi Module Mode d'emploi

W37M2510 Wi-Fi Module
Marque
GSD
Modèle
W37M2510 Wi-Fi Module
Taper
Mode d'emploi

Ce manuel convient également à

Hui Zhou Gaoshengda Technology Co., LTD W37M2510
PAGE 1 OF 4 Version 1.0
WIFI Module
IEEE 802.11 b/g/n 2T/2R
Model Number: W37M2510
Product Descrition
The W37M2510 is a 2.4GHz WIFI 2×2 MIMO module. This module provides a high level of integration with a
dual-stream IEEE 802.11n MAC/ base band /radio.The WLAN operation supports 20MHz,40MHz channels for data
rates up to 300Mbps. It fully complies with IEEE 802.11 b/g/n feature rich wireless connectivity at high
standards,delivers reliable,cost-effective, throughput from an extended distance.
Product Features
Product Specification
Model WIFI Module
Product Name W37M2510
Standard 802.11 b/g/n
Interface USB
Data Transfer Rate 1,2,5.5,6,11,12,18,22,24,30,36,48,54,60,90 and maximum of 300Mbps
Modulation Method DQPSK,DBPSK,CCK(802.11b)
QPSK,BPSK,16QAM,64QAM with OFDM (802.11g)
QPSK,BPSK,16QAM,64QAM with OFDM (802.11n)
Frequency Band 2412~2462 MHz
Operation Mode Infrastructure
Security WEP, TKIP, AES, WPA, WPA2
Operating Voltage 5V±10%
Current Consumption ＜750mA
Antenna Type PIFA
Operating
Temperature 0 ~ 60°C ambient temperature
Storage Temperature -40 ~ 80°C ambient temperature
Humidity 5 to 95 % maximum (non-condensing)
NOTICE:
◆please keep this product and accessories attached to the places which children can't touch;
◆do not splash water or other liquid onto this product, otherwise it may cause damage;
◆do not put this product near the heat source or direct sunlight, otherwise it may cause
deformation or malfunction;
◆please keep this product away from flammable or naked flame;
◆please do not repair this product by yourself. Only qualified personnel can be repaired.
◆ Complies with IEEE 802.11b/g/n for 2.4GHz Wireless LAN.
◆ Two transmit and Two receive path(2T2R)
◆ Works with all existing network nfrastructure.
◆ Capable of up to 128-Bit WEP Encryption.
◆ Freedom to roam while staying connected.
◆ UP to 300 Mbps High-Speed Transfer Rate in 802.11n mode of operation.
◆ Operating Systems：Linux,Win7, Win8, Win10,XP
◆ Low power consumption.
◆ Easy to install and configure.
◆ High speed USB 2.0 interface
◆ROHS com
p
liant
Hui Zhou Gaoshengda Technology Co., LTD W37M2510
PAGE 2 OF 4 Version 1.0
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Please notice that if the FCC identification number is not visible when the module is
installed inside another device, then the outside of the device into which the module is
installed must also display a label referring to the enclosed module. This exterior label
can use wording such as the following: “Contains FCC ID:2AC23-W37”Or
“Contains Transmitter Module FCC ID:2AC23-W37”any similar wording that expresses the same
meaning may be used.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of
20cm between the radiator & your body. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
- Information on test modes and additional testing requirements
Any final host product with the modular transmitter installed should be under test according
to guidance given in KDB 996369 D04. To enter test mode for module, MT7603 QA V0.0.185 software
and command is necessary. When something wrong happens in configuring test modes for host product
with module, host product manufacturer should coordinate with module manufacturer for technical
support. It is recommended that some investigative measurements should be taken to confirm that
host product with module installed does not exceed the spurious emissions limits or band edge
limits.
Hui Zhou Gaoshengda Technology Co., LTD W37M2510
PAGE 3 OF 4 Version 1.0
The module is limited to OEM installation ONLY.
The OEM integrator is responsible for ensuring that the end-user has no manual instruction
to remove or install module.
The module is limited to installation in mobile application.
A separate approval is required for all other operating configurations, including portable
configurations with respect to Part 2.1093 and difference antenna configurations.
There is requirement that the grantee provide guidance to the host manufacturer for
compliance with Part 15B requirements.
The module complies with FCC Part 15.247 and apply for Single module approval.
Trace antenna designs: Not applicable.
Antennas:
2.4G
PIFA antenna & 3 dBi
The antenna is permanently attached, can’t be replaced.
Canada Statement
Thisdevicecontainslicence‐exempttransmitter(s)/receiver(s)thatcomplywithInnovation,Scienceand
EconomicDevelopmentCanada’slicence‐exemptRSS(s).Operationissubjecttothefollowingtwo
conditions:
1. Thisdevicemaynotcauseinterference.
2. Thisdevicemustacceptanyinterference,includinginterferencethatmaycauseundesired
operationofthedevice.
L’émetteur/récepteurexemptdelicencecontenudansleprésentappareilestconformeauxCNR
d’Innovation,SciencesetDéveloppementéconomiqueCanadaapplicablesauxappareilsradioexempts
delicence.L’exploitationestautoriséeauxdeuxconditionssuivantes:
1. L’appareilnedoitpasproduiredebrouillage;
2. L’appareildoitacceptertoutbrouillageradioélectriquesubi,mêmesilebrouillageest
susceptibled’encompromettrelefonctionnement.
Please notice that if the ISED certification number is not visible when the module is
installed inside another device, then the outside of the device into which the module is
installed must also display a label referring to the enclosed module. This exterior label
can use wording such as the following: “Contains IC: 12290A-W37” Or
“Contains Transmitter Module IC: 12290A-W37” any similar wording that expresses the same
meaning may be used.
l'appareil hôte doit porter une étiquette donnant le numéro de certification du module
d'Industrie Canada, précédé des mots « Contient un module d'émission », du mot «
IC:12290A-W37 » ou d'une formulation similaire exprimant le même sens, comme suit
Hui Zhou Gaoshengda Technology Co., LTD W37M2510
PAGE 4 OF 4 Version 1.0
RSS-GEN issue 5 section 6.8 requires,
This radio transmitter [IC: 12290A-W37] has been approved by Innovation, Science and
Economic Development Canada to operate with the antenna types listed below, with the maximum
permissible gain indicated. Antenna types not included in this list that have a gain greater
than the maximum gain indicated for any type listed are strictly prohibited for use with
this device.
Antennas:
2.4G
PIFA antenna & 3dBi
La section 6.8 de la version 5 du RSS - Gen exige:
Cet émetteur radio [IC: 12290A-W37] a été approuvé par la société canadienne imovation,
Science and Economic Development,et peut être exploité selon le type anterma indiqué
ci-dessous. Lorsque le gain autorisé est affiché,il est strictement interdit d'utiliser
avec le dispositif un type d' antenne dont le gain est supérieur au gain maximum de tout
type de la liste.
Antenne:
2.4 grammes.
PIFA Antenne & 3dBi
The device has been evaluated to meet general RF exposure requirement. To maintain compliance
with RSS-102 — Radio Frequency (RF) Exposure guidelines, this equipment should be installed
and operated with a minimum distance of 20cm between the radiator and your body.
le dispositif de a été évalués à répondre général rf exposition exigence. pour maintenir
la conformité avec les directives d'exposition du RSS- 102 - Radio Fréquence (RF), ce
matériel doit être installé et exploité à une distance minimale de 20 cm entre le radiateur
et votre corps.
- Limited module procedures
NotapplicableforLimitedmoduleprocedures.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

GSD W37M2510 Wi-Fi Module Mode d'emploi

W37M2510 Wi-Fi Module
Marque
GSD
Modèle
W37M2510 Wi-Fi Module
Taper
Mode d'emploi
Ce manuel convient également à
Télécharger le PDF
rapport

dans d''autres langues

Documents connexes

Autres documents