Kodak Advantix T40 Manuel utilisateur

Taper
Manuel utilisateur
T40 Auto Camera
Consumer Imaging
EASTMAN KODAK COMPANY
Rochester, NY 14650
Kodak
ENGLISH/ESPAÑOL/FRANÇAIS
© Eastman Kodak Company, 2002
User’s Manual
Pt. No. 20230095
New 11/02
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
NOTE: Your model camera has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits provide
reasonable protection against interference in residential use. The camera generates, uses
and can radiate radio frequency energy and, if not used in accordance with the instructions,
may cause interference to radio communications. There is no guarantee that interference
will not occur. If this camera does cause interference to radio or television reception, which
can be determined by turning the camera off and on, you may reduce the interference by
the following:
— Reorient or relocate the receiving antenna.
— Increase the separation between the camera and the receiver.
— Consult the dealer or an experienced radio/television technician for help.
Changes or modifications not approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
This Class B digital apparatus meets all requirements of the Canadian Interference-
Causing Equipment Regulations.
1
KODAK ADVANTIX
ENGLISH
T40 Auto Camera
NEED HELP WITH YOUR CAMERA OR MORE
INFORMATION ABOUT THE ADVANCED PHOTO SYSTEM?
Visit our Web site at http://www.kodak.com (for US) or
http www.kodak.ca (for Canada) or call: Kodak (US only) from
9:00 a.m. to 7:00 p.m. (Eastern time) Monday through Friday
at 1-800-242-2424.
Kodak (Canada only) from 8:00 a.m. to 5:00 p.m. (Eastern time)
Monday through Friday at 1-800-465-6325, ext. 36100; for the
Toronto area, call 416-766-8233, ext. 36100.
Have your camera available when you call.
For warranty purposes, keep your sales receipt as
proof of the date of purchase.
2
CONTENTS
CAMERA IDENTIFICATION..... 3
CAMERA FEATURES .............. 6
ATTACHING THE STRAP ....... 8
LOADING THE BATTERY........ 9
Low-battery indicator ......... 10
Battery tips......................... 10
Power shutdown ................ 12
LOADING THE FILM.............. 12
TAKING PICTURES .............. 14
Typical print sizes
(formats).......................... 16
Tips for better pictures ....... 17
TAKING FLASH PICTURES .. 18
Flash-to-subject distance ... 19
USING THE SELF-TIMER ..... 19
UNLOADING THE FILM ........ 20
Automatic rewind ............... 20
Manual rewind ................... 21
CARING FOR
YOUR CAMERA .................. 22
TROUBLESHOOTING ........... 23
SPECIFICATIONS ................. 25
3
1 shutter button
2 film-rewind button
3 self-timer button
4 LCD panel
5 self-timer bulb
6 viewfinder
7 flash
8 lens
9 lens-cover switch
10 strap post
11 film-door lever
1
10
11
7
9
2
3
8
4
5
6
CAMERA IDENTIFICATION
4
12 print-format
switch
13 viewfinder
eyepiece
14 flash-ready lamp
12
14
13
5
15 tripod socket
16 battery door
17 film door
18 film chamber
19 self-timer
indicator
20 picture counter
21 battery symbol
15
16
17
20
19
21
18
6
CAMERA FEATURES
Three Print Formats
Choose from 3 picture sizes:
Classic (C), Group/HDTV (H),
or Panoramic (P). The masking
inside the viewfinder changes to
match each format selection.
Double Exposure Protection (DEP)
Dont worry about accidentally
re-exposing your film. Your
camera reads the Film Status
Indicator (FSI) on the film
cassette to prevent double
exposures.
Pop-up Flash
The extension of the flash helps
to reduce red eyes in flash
pictures and hand obstruction in
front of the lens.
Flash-recycle Time
Long life and quick flash recharge
times with the lithium battery.
Easy, Drop-in Loading
Easy, drop-in loading is fast and
virtually error-free. The camera
uses KODAK ADVANTIX Film.
The film cassette communicates
the status of film and becomes
the carrier and storage container
for the processed film.
7
Film Status Indicator (FSI)
An indicator advances from
one symbol to another to
identify the status of the film
inside the cassette.
4
3
2
1
Processed negatives
Unexposed
Partially exposed
Fully
exposed
Look for this logo to be certain
that the film you buy is made
for this camera.
Look for this logo to select
a certified photofinisher for
developing your film and to
assure that you get all the
features of the Advanced
Photo System.
Safety-locked Film Door
The safety interlock on the film
door prevents the door from
opening before the film is
completely rewound.
8
ATTACHING THE STRAP
Thread the straps shorter looped
end under the strap post (10). Pull
the longer end through the shorter
loop and pull it tight.
NOTE: You can use the knob on
the clasp of the camera strap to
actuate the buttons on the camera.
9
LOADING THE BATTERY
This camera uses one 3 V lithium
KODAK KCR2 Battery (or CR2
equivalent) that supplies power for
all camera operations.
NOTE: Insert the battery before
you load the film.
1. Open the battery door (16).
2. Place the battery over the
battery-pull strap and insert into
the chamber.
3. Close the battery door.
NOTE: Before you remove the
old battery, slide the lens-cover
switch (9) to turn off the camera.
10
Battery tips
Dispose of the battery according
to local and national regulations.
Keep a spare battery with you
at all times.
Keep batteries away from
children.
Store the battery in its original
packaging prior to use.
Remove the battery when you
store the camera for an
extended time.
Do not use rechargeable
batteries.
Low-battery indicator
Replace the battery when the
battery symbol (21) appears in the
LCD panel (4) or when the flash-
ready lamp (14) takes longer than
15 seconds to turn on.
11
CAUTION: Do not put the battery
in your pocket or in a container that
contains coins or metal objects.
If the battery touches the metal
objects, the battery may short
circuit, dis-charge energy, become
hot, or leak.
CAUTION: Do not try to take
apart, recharge or short circuit
the battery, or subject it to high
temperature or fire.
WARNING: In the unlikely event
that battery fluid leaks onto your
skin, rinse immediately with plenty
of water. For additional information,
contact Kodak Health, Safety and
Environment Information in the U.S.
at 1-585-722-5151. Customers
outside the U.S. can contact their
local health care provider.
WARNING: In the unlikely event
that battery fluid leaks inside the
camera, U.S. customers can
contact the Kodak Information
Center (KIC) at 1-800-242-2424.
Customers outside the U.S. can
contact their local Kodak Customer
Service representative.
12
LOADING THE FILM
You can load film with the camera
on or off.
NOTE: Insert the battery before
you load the film.
1. Push the film-door lever (11)
to open the film door (17).
Power shutdown
To conserve battery power, the
camera automatically goes to sleep
after 4 minutes of nonuse. To wake
up the camera, take a picture or
close and reopen the lens cover.
Turn off the camera when it is not
in use to further extend the
battery life.
13
3. Close the film door to start the
automatic film prewind.
The picture counter (20) in the
LCD panel (4) displays the
number of pictures remaining
on the film.
After you close the safety-
interlocked film door and the
film starts to prewind, you
cannot open the door until the
film is completely rewound
into the film cassette.
2. Insert the film cassette completely
into the film chamber (18).
Make sure the Film Status
Indicator (FSI) on the film
cassette is at
(#1 position)
for a new cassette.
Do not force the film cassette
into the film chamber.
14
TAKING PICTURES
You can take Classic (C), Group/
HDTV (H)*, and Panoramic (P)
pictures on the same film cassette.
Your photofinishing costs are based
on the format used.
1. Slide the lens-
cover switch (9)
to uncover
the lens (8),
raise the
flash (7),
and turn on
the camera.
* High Definition Television (HDTV) prints
are the same aspect ratio as the TV for
CD interface capabilities.
2. Slide the print-format switch (12)
to C, H, or P. The viewfinder
changes to show the selected
field of view.
P
H
C
C
H
P
15
4. Press the shutter button (1)
to take the picture.
3. Frame your subject within the
viewfinder eyepiece (13).
For a sharp picture, stand at
least 3.3 ft (1.0 m) from
your subject.
For low-light conditions, wait
until the flash-ready lamp (14)
glows green.
16
Typical print sizes (formats)
CH P
Classic Group (HDTV) Panoramic
3.5 x 5 in. or 4 x 6 in. 3.5 x 6 or 4 x 7 in. 3.5 x 8.5 in. to 4 x 11.5 in.
(88.9 x 127 mm or (88.9 x 152 mm or (88.9 x 216 mm to
102 x 152 mm) 102 x 178 mm) 102 x 292.7 mm)
NOTE: Your photofinisher generally provides 4 x 6, 4 x 7 and 4 x 11.5 in.
(102 x 152, 102 x 178 and 102 x 292.7 mm) sizes. Some local printers may
offer 3.5 x 5, 3.5 x 6, and 3.5 x 8.5 in. (88.9 x 127, 88.9 x 152 and
88.9 x 216 mm) sizes.
17
Hold your camera vertically with
the flash positioned upward to
capture tall, narrow subjects,
such as a waterfall, skyscraper,
or a person.
Add interest to your picture by
framing it with a tree branch,
a window, or even the rails of
a fence.
Stand at an angle to shiny
surfaces like windows or mirrors
to avoid flash reflection
and bright spots in your pictures.
Turn on all the room lights and
have your subject look at the
lights to reduce red eyes in
flash pictures.
Tips for better pictures
Hold your camera steady
by keeping your elbows close
to your body when you press
the shutter button to avoid
blurry pictures.
Keep your pictures simple.
Move close enough to your
subject so that it fills the
viewfinder but not closer
than 3.3 ft (1.0 m).
Take pictures at the subjects
level. Kneel down to take
pictures of children and pets.
Keep the sun behind you to
provide the best subject
illumination.
18
TAKING FLASH PICTURES
In dim light, such as indoors or
outdoors in heavy shade, or on
dark overcast days, you need
flash. Your camera has an
automatic pop-up flash that fires
when needed. The pop-up flash
helps to minimize red eyes in flash
pictures (see Tips for better
pictures on page 17 ).
1. Slide the lens-cover switch (9)
to uncover the lens (8),
raise the
FLASH
(7), and turn on
the camera.
2. Frame your subject within the
viewfinder eyepiece (13).
3. Keep the subject within the
distance range for the speed of
film in your camera (see Flash-
to-subject distance table).
Dont take pictures beyond
the maximum distance or your
pictures will be dark.
4. Wait for the flash-ready
lamp (14) to glow green.
5. Press the shutter button (1)
to take a picture.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28
  • Page 29 29
  • Page 30 30
  • Page 31 31
  • Page 32 32
  • Page 33 33
  • Page 34 34
  • Page 35 35
  • Page 36 36
  • Page 37 37
  • Page 38 38
  • Page 39 39
  • Page 40 40
  • Page 41 41
  • Page 42 42
  • Page 43 43
  • Page 44 44
  • Page 45 45
  • Page 46 46
  • Page 47 47
  • Page 48 48
  • Page 49 49
  • Page 50 50
  • Page 51 51
  • Page 52 52
  • Page 53 53
  • Page 54 54
  • Page 55 55
  • Page 56 56
  • Page 57 57
  • Page 58 58
  • Page 59 59
  • Page 60 60
  • Page 61 61
  • Page 62 62
  • Page 63 63
  • Page 64 64
  • Page 65 65
  • Page 66 66
  • Page 67 67
  • Page 68 68
  • Page 69 69
  • Page 70 70
  • Page 71 71
  • Page 72 72
  • Page 73 73
  • Page 74 74
  • Page 75 75
  • Page 76 76
  • Page 77 77
  • Page 78 78
  • Page 79 79
  • Page 80 80
  • Page 81 81
  • Page 82 82
  • Page 83 83
  • Page 84 84
  • Page 85 85
  • Page 86 86
  • Page 87 87
  • Page 88 88
  • Page 89 89
  • Page 90 90

Kodak Advantix T40 Manuel utilisateur

Taper
Manuel utilisateur

dans d''autres langues