Denver GSP-120 Manuel utilisateur

Senior Phone

GSP-120

www.facebook.com/denverelectronics

User Guide

English, Deutsch, Dansk, Suomalainen,

Svenska, Français, Nederlands,

Español, Italiano

1

Start to Use--------------------------------------------------2

Put in/Take out battery----------------------------------2

Insert/Take out SIM card-------------------------------5

Battery Charging-----------------------------------------6

Your Phone--------------------------------------------------8

Stand by Mode--------------------------------------------8

Key Functions-------------------------------------------10

Voice Dial---------------------------------------------------13

Make an International Call---------------------------13

Dial extension No. of a Fixed line------------------13

Speed Dial------------------------------------------------13

2

Start to Use

Put in/Take out battery

Put in battery

1.Open the battery cover

2. Put battery into the battery slot. Keep three metal

points of battery facing downward and matching

with the three metal connection points on phone.

3

3. Put on battery cover. Make sure that cover is

completely matched and the cover matching sound

could be heard.

Take battery out

1. Open battery cover.

2. Press the battery side and lift it up to take it out

from battery slot.

4

3. Close the cover. Make sure that cover is

completely matched and the cover matching sound

could be heard.

5

Remark：Shut down all devices and cut the

connection with charger when removing battery.

Please use battery which is matched with this phone

only.

Insert/Take out SIM card

1. Insert SIM card：Remove battery cover； Insert

and slide the SIM card with the metal part facing

downward by following below arrow direction at

battery slot until SIM card is completely inserted in

right position.

2. Take out SIM card：Hold the notch of SIM card

and lift it slightly up by the other hand to take card

out.

6

Remark：Please note that you should use GSM

SIM card only, because it doesn’t support 3G.

Remark：Phone must be power off when put in and

take out battery.

SIM card and the contact point will be easily

damaged due to scratch and bending. Please be

careful when inserting and taking out the SIM card.

Battery Charging

Phone could be charged when phone is

power off or power

7

Make sure that battery is inserted in

phone before charging.

1. Plug in the charger.

2. Plug out the charger from power jack first after it

is charged. Then unplug charger from phone.

8

Remark：Battery indication will be displayed after

several minutes if battery is over-discharged.

Battery Level Indication Bar

Not enough battery alert

Phone will give alert when battery is not enough and

display a message of low battery on screen. Please

charge battery. Please charge battery when you

receive the alert of low battery during calling in order

to keep the calling.

Your Phone

Stand by Mode

When phone is ready to use but no operation is

done on phone, then phone is under stand by mode.

Charging

Charged

9

10

Icons on Screen

Icons might be displayed on screen.

Battery status

Signal status

Alarm

Message

Silent mode

General mode

Missed call

Key Functions

Key Key Name Functions

3

Navigation

Up key

Standby mode：press

to enter main menu

Operating ： press to

move cursor up

11

4

Answer Key

(Green key)

Press to make outgoing

call or press to pick up

phone when there is

incoming call.

Standby mode：press to

enter call list

5

Navigation

Down key

Standby mode：press

to enter phonebook

Operating ： press to

move cursor down

6

End Key

(Red Key)

Phone Off：

Long press to

switch on;

Phone On：

Long press to

switch off;

Operating：Press to go

back to idle screen

7

Numeric key

Press to

input numbers

or letters

12

8

* key

Standby mode：Long

press to lock the

keypad.Short press to

type in *，+,P.

Editing mode: Press to

use normal symbol.

9

# key

Standby mode

：

Long

press to set phone silent

mode, short press to type

in #.

Editing mode ：Press

to switch typing method.

10

Turn on/off

flashlight

Input digit 0 or long

press to open/Close

flashlight.

11

SOS

BUTTON

Insert SIM card and Long

press to dial emergency

call

13

Voice Dial

Make an International Call

1. Press 0 key for twice times and sign “+ ” will

come out. Then enter country code, area code and

phone number (without a zero in front of mobile

phone number) Press Send key to enter voice dial

to call out.

2. Dial a fixed line: “＋”country code +

entire

phone number + Send key.

Dial extension No. of a Fixed line

Some extension numbers of fixed line couldn’t be

dialed directly. You need to dial

telephone exchange first and then dial the extension

number. Type in a P symbol between telephone

exchange number and extension number, this

phone will dial the extension number automatically.

Follow below method to make a symbol P: short

press * key for twice times. Then it will display a P

symbol on screen.

Speed Dial

If you already set the speed dial numbers, then you

can long press number key 2 to 9 key to dial set

numbers out under standby mode. Long pressing

number key 1 is to dial to voice mailbox if you

already set the mailbox number.

14

Radio frequency (RF) exposure and SAR THIS

DEVICE MEETS INTERNATIONAL GUIDELINES

FOR EXPOSURE TO RADIO WAVES

Your mobile device is a radio transmitter and

receiver. It is designed and manufactured not to

exceed the limits for exposure to radio frequency

(RF) recommended by international guidelines

(ICNIRP). These limits are part of comprehensive

guidelines and establish permitted levels of RF

energy for the general population. The guidelines

were developed by independent scientific

organizations through periodic and thorough

evaluation of scientific studies. The guidelines

include a substantial safety margin designed to

assure the safety of all persons, regardless of age

and health.

The exposure standard for mobile devices employs

a unit of measurement known as the Specific

Absorption Rate, or SAR. The SAR limit stated in

the international guidelines is 2.0 watts/kilogram

(W/kg)*. Tests for SAR are conducted using

standard operating positions with the device

transmitting at its highest certified well below the

maximum value. This is because the device is

designed to operate at multiple power levels

so as to use only the power required to reach the

network. In general, the closer you are to a base

15

station, the lower the power output of the device.

power level in all tested frequency bands.

Although the SAR is determined at the highest

certified power level, the actual SAR of the device

while operating can be well below the maximum

value. This is because the device is designed to

operate at multiple power levels so as to use only

the power required to reach the network. In general,

the closer you are to a base station, the lower the

power output of the device.

SAR values may vary depending on national

reporting and testing requirements and the network

band. Use of device accessories and enhancements

may result in different SAR values.

The SAR limit for mobile devices used by the public

is 2.0 W/kg averaged over 10 grams of body tissue.

The guidelines incorporate a substantial margin of

safety to give additional protection for the public and

to account for any variations in measurements.

SAR values may vary depending on

national reporting requirements and the network

band.

The highest SAR value for this model phone tested

for use is 0.743 mW/g

Electric and electronic equipment and included

batteries contains materials, components and

substances that can be hazardous to your health

16

and the environment, if the waste material

(discarded electric and electronic equipment and

batteries) is not handled correctly.

Electric and electronic equipment and batteries is

marked with the crossed out trash can symbol, seen

below. This symbol signifies that electric

and electronic equipment and batteries should not

be disposed of with other household waste, but

should be disposed of separately.

As the end user it is important that you submit your

used batteries to the approriate and designated

facility. In this manner you make sure that the

batteries are recycled in accordance with legislature

and will not harm the environment.

All cities have established collection points, where

electric and electronic equipment and batteries can

either be submitted free of charge at recycling

stations and other collection sites, or be collected

from the households. Additional information is

available at the technical department of your city

17

DENVER ELECTRONICS A/S

WWW.DENVER-ELECTRONICS.COM

Importer:

DENVER ELECTRONICS A/S

Stavneagervej 22

DK-8250 EGAA

DENMARK

Hereby, Inter Sales A/S, declares that this senior

mobile phone DENVER GSP-120 is in

compliance with the essential requirements and

other relevant provisions of Directive 1999/5/EC. A

copy of the Declaration of Conformity may be

obtained at

Inter Sales A/S, Stavneagervej 22, DK-8250 Egaa,

Danmark

Code for factory default:1234

Code for security password:1234

18

Senior Telefon

GSP-120

www.facebook.com/denverelectronics

Bedienungsanleitung

Deutsch

La page est en cours de chargement...

Denver GSP-120 Manuel utilisateur

Denver GSP-120 Manuel utilisateur

dans d''autres langues

Documents connexes

Autres documents