ADEMCO 2C2BHTRAN Remote Control Manuel utilisateur

ADEMCO
Marque
ADEMCO
Modèle
2C2BHTRAN Remote Control
Taper
Manuel utilisateur
Manual of Remote Control
Parameter
⚫ Frequency：315MHZ；
⚫ Work Voltage：7～12V
⚫ Work current：14ma±1ma
⚫ Quiescent current：0uA
⚫ Code：rolling code HCS301；
⚫ Work distance ：80m in the open area with Receiver ；
Learning code(Match the remote with
receiver ):
When the receiver connects with power, the LED of the receiver
light on. Then you press the learn button on the receiver,
receiver LED starts to flash. Press the remote control button
within the 30s, and the receiver LED flashes faster and light
on, it’s mean matching the receiver and remote successfully.
Note: When you press the remote control, the LED of the remote
control will light on. If you keep pressing, the LED keeps
light.
O
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
- English:
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not cause interference,
and (2) This device must accept any interference, including interference that may cause undesired
operation of the device.
- French:
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
  • Page 1 1
  • Page 2 2

ADEMCO 2C2BHTRAN Remote Control Manuel utilisateur

ADEMCO
Marque
ADEMCO
Modèle
2C2BHTRAN Remote Control
Taper
Manuel utilisateur
Télécharger le PDF
rapport

dans d''autres langues

Autres documents