Insignia NS-MWPC15K Guide d'installation rapide

Taper
Guide d'installation rapide
PACKAGE CONTENTS
15 W Qi Charging Pad
DC power adapter with
3 ft. (0.9 m) cable
Quick Setup Guide
FEATURES
• 15 W
output designed to fast charge demanding next-generation devices
Wireless design charges devices without cumbersome cords
Blue LED shows that your device is charging
DC power adapter with 3 ft. (0.9 m) charging cable
PRODUCT OVERVIEW
Before using your new product, please read these instructions to prevent any damage.
USING YOUR CHARGING PAD
1 Plug the power adapter into your charging pad and into a power
outlet.
2 Place your Qi-enabled device on the center of your charging pad
with the screen facing up. The LED is blue when your device is
charging. If your pad is quick charging, both the blue and red
LED light.
Note: If the LED is red, your device is not charging.
CAUTION: Do not place a credit or debit card on your charging pad.
See TROUBLESHOOTING” for more information
.
LED INDICATOR STATUS
TROUBLESHOOTING
Device not charging/LED is red
Make sure that your device is Qi-enabled.
Make sure that your charging pad is connected to a
working power outlet.
Make sure that your device is positioned correctly
on your charging pad.
Make sure that there are no other objects on the charging pad.
Remove your devices case. It may be blocking the wireless signal.
QUICK SETUP GUIDE
15 Watt Qi
Charging Pad
NS-MWPC15K / NS-MWPC15K-C
COMPATIBILITY
Any Qi-enabled devices up
to 15 W, including
smartphones, headphones,
smart watches.
LED
Blinking blue
Solid blue
Blue and red both on
Solid red
Blinking red
STATUS
Standby
Charging
Quick charging
Insucient input power
Charging error
DC port
LED indicator
Back
Front
DC
charging
cable
NS-MWPC15K_C_20-0034_QSG_V1_EN_Final.ai 1 4/27/2020 9:31:32 AM
V1 ENGLISH 20-0034
LEGAL NOTICES
FCC Information
FCC Caution:
Changes or modications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
FCC Statement: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment o and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC statement: This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator
and your body. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
RSS-Gen statement:
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two
conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of
the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux conditions suivantes :
(1) L’appareil ne doit pas produire de brouillage;
(2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
This equipment complies with IC RSS‐102 radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm between the
radiator and your body.
Cet équipement est conforme aux limites d'exposition aux radiations IC CNR‐102 établies pour un
environnement non contrôlé. Cet équipement doit être installé et utilisé avec une distance minimale de 20
cm entre le radiateur et votre corps.
SAFETY INFORMATION
• Avoid dropping.
• Do not disassemble.
Do not place metal objects between devices and the wireless
charging pads.
Thick protective case (≥ .2 in. [5 mm]) or a case that includes a
magnet or metallic material, may not allow proper charging function.
Keep wireless charging pad away from any liquid or moisture.
The maximum ambient temperature during use of this product
must not exceed 113° F (45° C).
Do not place this device in re or other excessively hot environments.
Must use provided adapter for proper function, if not it may be
malfunction.
ONEYEAR LIMITED WARRANTY
Visit www.insigniaproducts.com for details.
CONTACT INSIGNIA:
1-877-467-4289 (U.S. and Canada)
1-800-926-3000 (Mexico)
www.insigniaproducts.com
INSIGNIA is a trademark of Best Buy and its aliated companies
Distributed by Best Buy Purchasing, LLC
7601 Penn Ave South, Richeld, MN 55423 U.S.A.
©2020 Best Buy. All rights reserved.
Device charges slowly
Your device may charge more slowly with the charging pad than a
charging cable. This is normal behavior.
Make sure that your device is positioned in the center of your
charging pad.
CAUTION: Only use the cable with the attached power adapter that
came with your charger. Using a dierent cable and adapter can
decrease charging performance or damage your charger.
SPECIFICATIONS
Qi Wireless Charging Pad:
Input: DC 15 V/1.8 A
Output: 15 W max.
Dimensions: 3.9 x 3.9 x 0.4 in.(100 x 100 x 10.6 mm)
AC power adapter:
Input: 100-240 V ~ 50/60 Hz 0.7 A
Output: DC 15 V/1.8 A
DC Charging cable: 3 ft. (0.9 m)
NS-MWPC15K_C_20-0034_QSG_V1_EN_Final.ai 2 4/27/2020 9:31:32 AM
  • Page 1 1
  • Page 2 2

Insignia NS-MWPC15K Guide d'installation rapide

Taper
Guide d'installation rapide

dans d''autres langues