Extron SMK F SF 10C Plus Manuel utilisateur
- Taper
- Manuel utilisateur
1
SMK F SF 10C Plus Kit • Setup Guide
This guide provides instructions for an experienced installer to install the Extron SMK F SF 10C Plus
oor mount kit for the SF 10C SUB subwoofer. The SMK F SF 10C Plus kit consists of four long legs
for mounting the speaker vertically, and four short legs for mounting the speaker horizontally. Each
kit includes 12 screws and locking nuts, and 24 washers.
NOTE: See the SF 10C SUB User Guide or SF 10C SUB Setup Guide for detailed instructions regarding the SF 10C SUB subwoofer.
ATTENTION:
• The SF 10C SUB must have rebreaks installed in the wall, above and below it, when it is protruding through a wall, to meet UL
requirements.
• Le SF 10C SUB doit disposer de systèmes coupe-feu installés au mur, au-dessus et au-dessous de l’unité, lorsqu’elle est placée
en saillie du mur, an de satisfaire les exigences de l’UL.
• The subwoofer must be securely fastened to the stud or other stationary surface when mounted in one of the vertical positions.
• Le caisson de grave doit être solidement xé au montant ou à une autre surface stationnaire lorsqu’il est monté dans l’une des
positions verticales.
NOTES:
• Remember that the sound from the unit is directed out the port. Therefore, the port needs to be pointed into the listening space.
• To ensure that the Extron grille ts fully into any masking wall or other partition, the center of the port tube must be at least
5-3/16 inches (132 mm) from the edge of the wall.
• The grille does not t if you install the legs on the subwoofer with the port tube down. Consider fabricating a small platform to lift
the subwoofer (see figure 2 on the next page), or otherwise design your own way to dress your installation to give it a nished
look.
• Steps 3, 4, 5, and 8 are necessary only if you are installing the subwoofer in an adjoining space.
Installing Long Legs for Vertical Installation
The subwoofer can be set vertically on a oor using the included long legs as follows:
1. Determine where the subwoofer is to be placed and its orientation (port tube on top or port tube on the bottom).
2. Remove the grommets from the holes in the installation bracket.
3. Fasten two legs to each installation bracket using the three provided screws and locking nuts, two on one side of the foot (see
figure 1,
1
) and one on the other side (
2
).
11
2
2
2
2
1
1
Figure 1. Long Leg Installation
IMPORTANT:
Go to www.extron.com for the complete
user guide, installation instructions, and
specifications before connecting the
product to the power source.
2
SMK F SF 10C Plus Kit • Setup Guide (Continued)
4. When installing in an adjoining space — On the far side of the wall (outside the listening space), remove enough wall material so
that the subwoofer port tube can be placed as close as possible to the wall (facing the listening space).
5. When installing in an adjoining space — On the near side of the wall (inside the listening space), mark where the center of the
port tube faces the installation surface. The center mark must be at least 5-3/16 inches (132 mm) from the edge of the installation
surface.
6. When installing in an adjoining space — On the near side of the wall (inside the listening space), using the included grille cut-out
template, mark and cut the hole in the surface.
7. Place the subwoofer in the desired location.
8. Use the included nylon straps and included accessories, or locally-obtained perforated metal hanger straps, to secure two of the
mounting holes on the top bracket to the nearest stud or other stationary surface (see figure 2,
1
). Use locally obtained hardware
suitable for the material to which the unit is being secured.
9. When installing in an adjoining space — Ensure that there are fire breaks above and below the port tube (
2
) to meet UL
requirements. If necessary, fabricate them.
111
Listening Space
Installation Location
(Adjoining Space)
222
Nylon
Strap
Screw
Lock
Nut
Washers (2)
Bracket
Figure 2. Securing the Floor-mounted Subwoofer and Installing Fire Breaks
3
Installing Short Legs for Horizontal Installation
The subwoofer can be set horizontally on a oor using the included short legs as follows:
1. Fasten a foot to each installation bracket using the provided screws and locking nuts (see figure 3).
SF 10C SUB End View
Figure 3. Short Leg Installtion
2. Place the subwoofer in the desired location.
4
68-3432-50 Rev. A
09 19
SMK F SF 10C Plus Kit • Setup Guide (Continued)
© 2019 Extron Electronics — All rights reserved. www.extron.com
All trademarks mentioned are the property of their respective owners.
Worldwide Headquarters: Extron USA West, 1025 E. Ball Road, Anaheim, CA 92805, 800.633.9876
For information on safety guidelines, regulatory compliances, EMI/EMF compatibility, accessibility, and related topics, see the
Extron Safety and Regulatory Compliance Guide on the Extron website.
-
1
-
2
-
3
-
4
Extron SMK F SF 10C Plus Manuel utilisateur
- Taper
- Manuel utilisateur
dans d''autres langues
- English: Extron SMK F SF 10C Plus User manual