Williams AV CHG 412 Manuel utilisateur

Taper
Manuel utilisateur
12-Bay Charger
CHG 412 & CHG 412 PRO
USER MANUAL
Digi-Wave DLT 400 and DLR 400 RCH can be charged in the CHG 412. 12 DLTs or
DLRs can be charged at one time. The CHG 412 PRO comes with a case, but
otherwise operates the same as the CHG 412.
This charger cannot be used with the DLR 400 ALK.
Instructions
To ensure full battery charging, turn o the DLT /DLR when recharging the batteries.
To use the charger:
1. Plug the power supply into a wall outlet. Plug the power connector into the
rear of the unit.
2. Insert the Digi-Wave 400 series units facing forward into the charging slot. The
unit(s) must be placed in the charger facing forward to charge properly.
3. A red LEDindicator on the DLT / DLR will blink when charging has started.
When the batteries are fully charged, a green LED will illuminate.
If the LEDs do not light up, make sure the power supply is plugged into an AC outlet
and that all Digi-Wave 400 series units are facing forward.
Recycling Instructions
Help Williams AV protect the environment!
Please do not dispose of equipment or used batteries in the household trash. Take the equipment to an
electronics recycling center or return to the factory. Take batteries to a retail or community recycling location.
Safety Warnings
To reduce the risk of fire or electric shock, do not expose the system to rain or moisture. Do not use this apparatus near water. The
system should not be exposed to dripping or splashing, and objects filled with liquids such as beverages should not be placed on the
charger. Clean only with a dry cloth.
Charging batteries generates heat. The DLTs and DLRs, charger, and power supply will feel warm when charging. Do not charge
batteries in a closed enclosure, such as a carry case or brief case.
CAUTION! To prolong battery life, do not leave unit(s) in charger/dock for extended periods of time.
Servicing or attempting to service this device will void the warranty
Refer servicing to qualified personnel. Servicing is required when the system has been damaged in any way: if liquid has been spilled
or objects have fallen into the unit, if the unit has been exposed to moisture, if the unit does not operate normally, or if the unit has been
dropped.
Do not block any ventilation openings. Install in accordance with manufacturer’s instructions.
Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus that produces heat.
Use only attachments/accessories specified by the manufacturer.
Unplug the unit during lightning storms or when unused for long periods of time.
Be advised that dierent operating voltages require the use of dierent types of line cord and attachment plugs. Check the voltage in
your area and use the correct type.
Use only the power supply provided by Williams AV. Other power supplies may have similar specifications, but may not be equivalent in
emissions ratings, in-rush current, etc. Use of an unapproved power supply may leave the device partially or completely inoperable, and
will void the warranty.
This apparatus has been designed with class-1 construction and must be connected to a main socket outlet with a protective ground
connection (the third grounding prong).
Protect the power cord from being walked on or pinched, particularly at plugs, receptacles, and near the power jack on the charger.
This apparatus must be grounded.
The MAINS plug or an appliance coupler is used as the disconnect device, so the disconnect device should remain readily operable.
1
MAN 252B
FCC Compliance Statement Innovation, Science and Economic Development Canada Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment o and on, the user is encouraged to try
to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit dierent from
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
Caution: Any changes or modifications to the equipment not expressly
approved by the party responsible for compliance could void your authority to
operate the equipment.
SAR Requirement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This product meets the applicable national or international RF exposure
guidance (SAR guideline) when used normally against your head or, when worn
or carried, at a distance of 0.5 cm from the body. The SAR guideline includes
a considerable safety margin designed to assure the safety of all persons,
regardless of age and health.
This equipment complies with IC RSS-102 radiation exposure limits set forth for
an uncontrolled environment.
Operation is subject to the following two conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received, including
interference that may cause undesired operation
Cet équipement est conforme aux limites d’exposition de rayonnement d’IC
RSS-102 déterminées pour un environnement non contrôlé. Cet Son utilisation
est soumise aux deux conditions suivantes:
1. Cet appareil ne doit pas causer d’interférences et
2. il doit accepter toutes interférences reçues, y compris
celles susceptibles d’avoir des eets indésirables sur son
fonctionnement.
SAR Requirement
This product meets the applicable national or international RF exposure
guidance (SAR guideline) when used normally against your head or, when worn
or carried, at a distance of 0.5 cm from the body. The SAR guideline includes
a considerable safety margin designed to assure the safety of all persons,
regardless of age and health.
Ce produit est conforme aux directives nationales ou internationales sur
l’exposition aux fréquences radioélectriques (directives SAR) en vigueur lorsqu’il
est utilisé normalement contre la tête ou, porté ou porté, à une distance de 0,5
cm du corps.
La directive SAR inclut une marge de sécurité considérable conçue pour assurer
la sécurité de toutes les personnes, indépendamment de leur âge et de leur
santé.
Two-Year Warranty
Williams AV products are engineered, designed and manufactured under carefully controlled conditions to provide you with
many years of reliable service. Williams AV warrants the CHG 412 Digi-Wave™ 12-Bay Charger against defects in materials and
workmanship for TWO (2) years. During the first two years from the purchase date, we will promptly repair or replace the CHG 412
Charger.
Microphones, earphones, headphones, batteries, cables, carry cases, and all other accessory products carry a 90-day warranty.
WILLIAMS AV HAS NO CONTROL OVER THE CONDITIONS UNDER WHICH THIS PRODUCT IS USED. WILLIAMS AV, THEREFORE,
DISCLAIMS ALL WARRANTIES NOT SET FORTH ABOVE, BOTH EXPRESS AND IMPLIED, WITH RESPECT TO THE CHG 412
DIGIWAVE™ 12BAY CHARGER, INCLUDING BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE. WILLIAMS AV SHALL NOT BE LIABLE TO ANY PERSON OR ENTITY FOR ANY MEDICAL
EXPENSES OR ANY DIRECT, INCIDENTAL OR CONSEQUENTIAL DAMAGES CAUSED BY ANY USE, DEFECT, FAILURE OR
MALFUNCTION OF THE PRODUCT, WHETHER A CLAIM FOR SUCH DAMAGES IS BASED UPON WARRANTY, CONTRACT, TORT
OR OTHERWISE. THE SOLE REMEDY FOR ANY DEFECT, FAILURE OR MALFUNCTION OF THE PRODUCT IS REPLACEMENT OF
THE PRODUCT. NO PERSON HAS ANY AUTHORITY TO BIND WILLIAMS AV TO ANY REPRESENTATION OR WARRANTY WITH
RESPECT TO THE CHG412 DIGIWAVE™ 12BAY CHARGER. UNAUTHORIZED REPAIRS OR MODIFICATIONS WILL VOID THE
WARRANTY.
The exclusions and limitations set out above are not intended to, and should not be construed so as to contravene mandatory
provisions of applicable law. If any part or term of this Disclaimer of Warranty is held to be illegal, unenforceable or in conflict with
applicable law by a court of competent jurisdiction, the validity of the remaining portions of this Disclaimer of Warranty shall not be
aected, and all rights and obligations shall be construed and enforced as if this Two-Year Warranty did not contain the particular
part or term held to be invalid.
If you experience diculty with your system, call Toll-Free for Customer Assistance:
1-800-843-3544 (U.S.A.) or 1-952-943-2252 (International)
Register your warranty at https://williamsav.com/support/warranty-product-registration/
If it is necessary to return the system for service, your Customer Service Representative will give you a Return Authorization
Number (RA) and shipping instructions.
Pack the system carefully and send it to:
Williams AV
Attn: Repair Dept.
10300 Valley View Road
Eden Prairie, MN 55344
2
CHG 412 - Charger
info@williamsav.com / www.williamsav.com
800-843-3544 / INTL: +1-952-943-2252
© 2022, Williams AV, LLC MAN 252B
  • Page 1 1
  • Page 2 2

Williams AV CHG 412 Manuel utilisateur

Taper
Manuel utilisateur

dans d''autres langues