Ubiquiti U6PLR UniFi + plus Long Range Access Point Manuel utilisateur
- Taper
- Manuel utilisateur
E-Label User Information
FCC ID: SWX-U6PLR
IC ID: 6545A-U6PLR
Ubiquiti Inc. will be incorporating the E-Label procedures per FCC KDB 784748-D02. The
information below is what will be included in the E-Labeling.
E-label and warning statements can be found in the device/controller GUI under Device >
Settings > About.
Detailed compliance information including Declaration of Conformity is available at the
following internet address: ui.com/compliance
FCC
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions.
This device may not cause harmful interference, and This device must accept any
interference received, including interference that may cause undesired operation.
Note:This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV technician for help.
.
ISED Canada
CAN ICES-3 (A) / NMB-3 (A)
This device complies with ISED Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference received, including interference that may
cause undesired operation.
CAN ICES-3 (A) / NMB-3 (A)
Le présent appareil est conforme aux CNR d’ISDE Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:
1. L’appareil ne doit pas produire de brouillage;
2. I’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
RF Exposure Warning
The antennas used for this transmitter must be installed to provide a separation distance of
at least 20 cm from all persons and must not be located or operating in conjunction with
any other antenna or transmitter.
Les antennes utilisées pour ce transmetteur doivent être installé en considérant une
distance de séparation de toute personnes d’au moins 20 cm et ne doivent pas être localisé
ou utilize en conflit avec tout autre antenne ou transmetteur.
-
1
-
2
Ubiquiti U6PLR UniFi + plus Long Range Access Point Manuel utilisateur
- Taper
- Manuel utilisateur
dans d''autres langues
Documents connexes
-
Ubiquiti UniFi Dream Machine Beacon Guide de démarrage rapide
-
-
-
-
-
Ubiquiti AFi-ALN Guide de démarrage rapide
