Askey 8822CS Manuel utilisateur

Marque: Askey

Modèle: 8822CS

Catégorie: Antennes réseau

Taper: Manuel utilisateur

8822CS user manual

產品中文名稱:

無線藍牙模組

產品英文名稱:

WIFI+BT Combo Module

產品商標:

ASKEY

產品型號:

8822CS

額定電壓、電流:

DC 3.3V

頻率范围:

2.4~2.483GHz，5.15 GHz ~ 5.850 GHz

信道:

Ch1- Ch11,Ch36-48,CH52-64,Ch100-140,Ch149-165

天线类型:

PIFA ANTENNA

產品硬件版本:

V2.0

產品軟件版本:

V5.9

Features

Highly integrated wireless local area network(WLAN) system-on-chip (SOC)

for 5

GHZ 802.11ac, or 2.4G/5G 802.11n WLAN applications.

Dual-stream spatial multiplexing up to 867 Mbps data rate.

Supports 20/40MHz at 2.4GHz and supports 20/40/80MHz at 5GHz

Supports low power SDIO3.0 interface for WLAN and UART/PCM interface

for

Bluetooth.

Supports Bluetooth V5.0 system.

Supports WLAN-Bluetooth coexistence.

BT host digital interface:

- HCI UART (up to 4 Mbps)

- PCM for audio data

Module have 2 antenna port, BT port combine with WLAN1.

Wi-Fi RF Specification

2.4GHz RF Specification

Frequency Range:

802.11b/g/n-HT20: 2412 ~ 2462MHz

802.11n-HT40: 2422 ~ 2452MHz

Channel Number:

802.11b/g/n-HT20: 11

802.11n-HT40: 7

Type of Modulation:

802.11b: DSSS

802.11g/n: OFDM

Data Rate:

802.11b: 1/2/5.5/11Mbps

802.11g: 6/9/12/18/24/36/48/54Mbps

802.11n: up to 300Mbps

5GHz RF Specification

Note: The frequencies that fall in the 5600MHz to 5650MHz band will not be used in Canada.

Bluetooth Specification

Antenna Specification

Antenna Type

Frequency

Band

(GHz)

Paths

Per Chain Max

Antenna Gain (dBi)

Directional Gain

(dBi)

Ant 0

Ant 1

For Power

For PSD

Wi-Fi Internal Antenna

PIFA

2412 ~ 2462

2.1

1.9

2.1

5.11

5180 ~ 5240

4.2

1.9

4.2

7.21

5260 ~ 5320

3.8

3.0

3.8

6.81

5500 ~ 5720

3.8

2.9

3.8

6.81

5745 ~ 5825

3.4

2.3

3.4

6.41

Bluetooth Internal Antenna

PIFA

2402 ~ 2480

1.9

Frequency Range:

For 802.11a/n-HT20/ac-VHT20: 5180~5240MHz, 5260~5320MHz,

5500~5720MHz, 5745~5825MHz

For 802.11n-HT40/ac-VHT40: 5190~5230MHz, 5270~5310MHz,

5510~5710MHz, 5755~5795MHz

For 802.11ac-VHT80: 5210MHz, 5290MHz, 5530MHz, 5610MHz,

5690MHz, 5775MHz

Type of Modulation:

802.11a/n/ac: OFDM

Data Rate

802.11a: 6/9/12/18/24/36/48/54Mbps

802.11n: up to 300Mbps

802.11ac: up to 866.6Mbps

Operating Frequency:

2402~2480MHz

Channel Number:

BR/EDR: 79

BLE: 40

Type of modulation:

GFSK, Pi/4 DQPSK, 8DPSK

Data Rate:

1Mbps, 2Mbps, 3Mbps

Dimensions

Marking Description

Label

The Key Material List

Recommended Reflow Profile

Package Information

、

Moisture sensitivity

The Modules is a Moisture Sensitive Device level 3, in according with standard

IPC/JEDEC J-STD-020, take care

all the relatives requirements for using this kind of components.

Moreover, the customer has to take care of the following conditions:

a) Calculated shelf life in sealed bag: 12 months at <40°C and <90% relative humidity

(RH).

b) Environmental condition during the production: 30°C / 60% RH according to

IPC/JEDEC J-STD-033A paragraph 5.

c) The maximum time between the opening of the sealed bag and the reflow process

must be 168 hours if condition

b) “IPC/JEDEC J-STD-033A paragraph 5.2” is respected

d) Baking is required if conditions b) or c) are not respected

e) Baking is required if the humidity indicator inside the bag indicates 10% RH or more

U.S. FCC Statement

FCC ID: H8N-8822CS

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can

be determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one of the following measures:

o Reorient or relocate the receiving antenna.

o Increase the separation between the equipment and receiver.

o Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

o Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate the equipment.

This equipment complies with FCC RF radiation exposure limits set forth for an

uncontrolled environment. This device and its antenna must not be co-located or

operating in conjunction with any other antenna or transmitter.

The antennas used for this transmitter must be installed to provide a separation

distance of at least 20 cm from all persons and must not be co-located or operating in

conjunction with any other antenna or transmitter.

Canada (IC) Notices

IC: 1353A-8822CS

CAN ICES-3 (B)/NMB-3(B)

This device complies with Industry Canada license-exempt RSSs. Operation is subject

to the following two conditions:

1. This device may not cause interference, and

2. This device must accept any interference, including interference that may

cause undesired operation of the device.

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux

appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions

suivantes:

1. l’appareil ne doit pas produire de brouillage

2. l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, meme si

le brouillage est susceptible d’en compromettre le fonctionnement.

Caution:

The device for operation in the band 5150–5250 MHz is only for indoor use to reduce

the potential for harmful interference to co-channel mobile satellite systems.

Avertissement:

Le dispositif fonctionnant dans la bande 5150-5250 MHz est réservé uniquement pour

une utilisation à l’intérieur afin de réduire les risques de brouillage préjudiciable aux

systèmes de satellites mobiles utilisant les memes canaux.

This equipment complies with IC radiation exposure limits set forth for an

uncontrolled environment. This equipment should be installed and operated with

minimum distance 20 cm between the radiator & your body.

Cet équipement est conforme aux limites d’exposition aux rayonnements

IC établies pour un environnement non contrôlé. Cet équipement doit être installé et

utilisé avec un minimum de 20 cm de distance entre la source de rayonnement et votre

corps.

OEM Integration Instructions：

This device is intended only for OEM integrators under the following conditions：

The module can be used to installation in another host. The antenna must be installed

such that 20 cm is maintained between the antenna and users, and the transmitter

module may not be co-located with any other transmit or antenna. The module shall

be only used with the integral antenna(s) that has been originally tested and certified

with this module. As long as 3 conditions above are met, further transmitter test will

not be required. However, the OEM integrator is still responsible for testing their

end-product for any additional compliance requirement with this module installed (for

example, digital device emission, PC peripheral requirements, etc.)

IMPORTANT NOTE：

In the event that these conditions cannot be met (for example certain laptop

configuration or co-location with another transmitter), then the FCC authorization for

this module in combination with the host equipment is no longer considered valid and

the FCC ID of the module cannot be used on the final product. In these and

circumstance, the OEM integrator will be responsible for re-evaluating. The end

product (including the transmitter) and obtaining a separate FCC authorization. The

final end product must be labeled in a visible area with the following: “Contains

Transmitter Module FCC ID: H8N-8822CS or Contains FCC ID: H8N-8822CS”.

Antenna Specification:

Antenna Type

Frequency

Band

(GHz)

Paths

Per Chain Max

Antenna Gain (dBi)

CDD Directional Gain

(dBi)

Ant 0

Ant 1

For Power

For PSD

Wi-Fi Internal Antenna

PIFA

2412 ~ 2462

2.1

1.9

2.1

5.11

5180 ~ 5240

4.2

1.9

4.2

7.21

5260 ~ 5320

3.8

3.0

3.8

6.81

5500 ~ 5720

3.8

2.9

3.8

6.81

5745 ~ 5825

3.4

2.3

3.4

6.41

Bluetooth Internal Antenna

PIFA

2402 ~ 2480

1.9

IMPORTANT NOTE：

This Wireless Module (IC: 1353A-8822CS) has been approved by Industry Canada to

operate with the antenna types listed below with the maximum permissible gain

indicated. Antenna types not included in this list, having a gain greater than the

maximum gain indicated for that type, are strictly prohibited for use with this device.

The Host Marketing Name (HMN) must be displayed (according to e-labelling

requirements) or

indicated at any location on the exterior of the host product or product packaging or

product literature,

which shall be available with the host product or online.

The host product shall be properly labelled to identify the modules within the host

product. The Innovation, Science and Economic Development Canada certification

label of a module shall be clearly visible at all times when installed in the host product;

otherwise, the host product must be labelled to display the Innovation, Science and

Economic Development Canada certification number for the module, preceded by the

word “Contains” or similar wording expressing the same meaning, as follows:

Contains IC: 1353A-8822CS.

Antenna Specification:

Antenna Type

Frequency

Band

(GHz)

Paths

Per Chain Max

Antenna Gain (dBi)

CDD Directional Gain

(dBi)

Ant 0

Ant 1

For Power

For PSD

Wi-Fi Internal Antenna

PIFA

2412 ~ 2462

2.1

1.9

2.1

5.11

5180 ~ 5240

4.2

1.9

4.2

7.21

5260 ~ 5320

3.8

3.0

3.8

6.81

5500 ~ 5720

3.8

2.9

3.8

6.81

5745 ~ 5825

3.4

2.3

3.4

6.41

Bluetooth Internal Antenna

PIFA

2402 ~ 2480

1.9

Askey 8822CS Manuel utilisateur

Marque: Askey

Modèle: 8822CS

Catégorie: Antennes réseau

Taper: Manuel utilisateur

Télécharger le PDF

rapport

dans d''autres langues

English: Askey 8822CS User manual

Documents connexes

Askey AP6275S Manuel utilisateur

Askey 8822CS Manuel utilisateur

Askey 8822CS Manuel utilisateur

dans d''autres langues

Documents connexes

Autres documents