Crate Amplifiers GFX-30 Manuel utilisateur
- Catégorie
- Amplificateur d'instruments de musique
- Taper
- Manuel utilisateur
OWNER’S MANUAL
Congratulations!
You are now the proud owner of the Crate GFX-30 guitar amplifier. Featuring a
“Clean” channel with a 3-band EQ and Level control, and an “Overdrive” channel with
our patented “Flex-Wave” circuitry with Gain, Level and Crate’s Shape control, plus an
easy to operate DSP section which lets you dial in a variety of digital effects such as
delay, flange, chorus and reverb (with its own level control), the GFX-30 offers you more
flexibility and performance than any amp in its class. Aspecial damping circuit simulates
the “current source” type output of a tube amp, giving you solid state reliability combined
with classic tube sounds.
Your GFX-30 is Musician Made in the U.S.A., using only the best components.
Extensive testing at the hands (and ears) of skilled technicians and musicians insures
you that this amplifier is the absolute best it can be.
In order to get the most out of your new amplifier, we strongly urge you to go over
the information contained in this manual before you begin playing.
And thank you
for choosing
GFX-30
GUITAR AMPLIFIER WITH
DIGITAL SIGNAL PROCESSING
1: INPUT: Connect your guitar here using
a shielded instrument cable.
OVERDRIVE CHANNEL: A high gain
channel giving you sounds from a slight
edge to serious overdrive.
2: GAIN: This control sets the amount of
compression and distortion from the ampli-
fier. With the control towards the far left,
the sound will have a thick compressed
quality. As you turn the control to the right
the amount of distortion increases. Crate’s
exclusive “Flex Wave” circuitry uses
sequential cascading gains to deliver dis-
tortion which is rich in harmonics and
“touch sensitive.” Use this control along
with the Shape and Level controls (#3 and
4) to create a wide variety of sounds.
3: SHAPE: To quickly “dial in” just the right
distortion sound, simply rotate the Shape
control until you find the sound you’re look-
ing for. Turning the control towards the left
enhances the mid frequencies; turning it to
the right enhances the low and high fre-
quencies.
4: LEVEL: Sets the output volume level
from the Overdrive Channel: in the far left
position there is no output; turning the con-
trol to the right increases the output. Use
this control along with the Gain and Shape
controls (#2 & 3) to create a wide variety of
sounds.
5: OVERDRIVE: When this switch is
pressed in the Overdrive Channel is
engaged. The Clean Channel is selected
when this switch is out. A footswitch (#12)
overrides this switch.
CLEAN CHANNEL: A normal gain channel
designed to give you crystal clear sounds.
6: LEVEL: Sets the output volume level
from the Clean Channel: in the far left posi-
tion there is no output; turning the control
to the right increases the output level.
7: LOW: Adjusts the low frequency output
level: to the left reduces the low frequency
output; to the right increases it. This control
allows a range of 25dB at 80Hz.
8: MID: Adjusts the mid frequency output
level: to the left reduces the midrange out-
put; turning it to the right increases it. This
control allows a range of 19dB at 900Hz.
9: HIGH: Adjusts the high frequency output
level: to the left reduces the high frequency
output; to the right increases it. This control
allows a range of 23dB at 5kHz.
10: DSP LEVEL: Adjust the amount of dig-
ital signal processing with this control: in
the full left position the output signal is
“dry” (no effect); rotating the control to the
right increases the amount of effect. The
DSP can be turned on and off with an
optional footswitch (see #12).
GFX-30 Amplifier
1 2 3 4 6 7 85 9
11: DSP MODE: Select the type of digital
effect(s) desired with this control. Each cat-
egory and its central location is called out
(delay, flange, etc.) by the markings around
the control; there are two variations per
effect, as follows:
• Slapback delay
• Long delay w/regeneration
• Light Flange
• Heavy Flange
• Slow Chorus
• Fast Chorus
• Chorus w/small room reverb
• Chorus w/large room reverb
• Small room reverb
• Large room reverb
12: FOOTSWITCH: Connect a two-button
footswitch (such as the Crate CFP-2) here
for remote control of the Channel Select
and DSP on/off.
13. HEADPHONES: For private practice
sessions, plug a pair of stereo headphones
into this jack. The internal speaker is dis-
connected whenever headphones are
used.
14: SPEAKER*: Connect to an extension
speaker cabinet with this jack. The jack is
wired in series with the internal speaker(s).
15: ON LED: The word “ON” will glow
when you turn on the GFX-30, showing you
that the amplifier is activated and ready to
play.
16: POWER SWITCH: Turns the amplifier
ON in the up position, off in the down posi-
tion.
17: POWER CORD (rear panel, not
shown): Your GFX-30 is equipped with a
heavy duty grounded three-wire power
cord. Be sure this cord is properly plugged
into a safely wired grounded 120 volt,
60Hz AC power outlet before use. (If your
GFX-30 was purchased outside the United
States, refer to the rear panel for power
ratings.) For your safety, never attempt to
defeat the ground connection on this cord.
18: FUSE (rear panel, not shown):
Protects the amplifier against damages
caused from a faulty AC power source or
other problems. If the fuse blows, replace it
ONLY with the same size and type fuse. If
the fuse blows repeatedly check the AC
source; if it’s okay, contact your Crate deal-
er for service information.
GFX-30 Amplifier
10 11 12 13 14 15 16
*WARNING: DO NOT attempt to use
headphones in the Speaker jack!
Permanent hearing damage could result!
GFX-30 Amplifier
Crate continually develops new products, as well as improves existing ones. For this reason, the
specifications and information in this Crate manual are subject to change without notice.
Output Power Rating >30 watts RMS @ 5% THD 4 ohms, 120VAC
Gain, Overdrive Channel 86dB +/-6dB @ 1kHz
Gain, Clean Channel 46dB +/-6dB @ 1kHz
Tone Control Range, Low 25dB @ 80Hz
Tone Control Range, Mid 19dB @ 900Hz
Tone Control Range, High 23dB @ 5kHz
Signal To Noise, Overdrive Channel >50dB
Signal To Noise, Clean Channel >65dB
Maximum Signal Accepted >1.2 volts RMS min. @ 400Hz
Internal Speaker 12” Crate Custom Design 4 ohm
Input Power Requirements 120 VAC, 60Hz, 50VA
100/115VAC, 50/60Hz, 50VA
230VAC, 50/60Hz, 50VA
Size and Weight: 18.5” H x 19.5” W x 11” D, 20 lbs.
The GFX-30 is covered with a durable black Tolex material: wipe it
clean with a lint-free cloth. Never spray cleaning agents onto the
cabinet. Avoid abrasive cleansers which could damage the finish.
GFX-30 TECHNICAL SPECIFICATIONS
www.crateamps.com
©1998 SLM ELECTRONICS, A DIVISION OF ST. LOUIS MUSIC, 1400 FERGUSON, ST. LOUIS, MO. 63133
P/N 47-454-01 • 03/02
IMPORTANT SAFETY INSTRUCTIONS
• READ, FOLLOW, HEED, AND KEEP ALL INSTRUCTIONS AND WARNINGS.
• DO NOT OPERATE NEAR ANY HEAT SOURCE AND DO NOT BLOCK ANY VENTILATION OPENINGS ON THIS APPARATUS. FOR
PROPER OPERATION, THIS UNIT REQUIRES 3” (75mm) OF WELL VENTILATED SPACE AROUND HEATSINKS AND OTHER AIR
FLOW PROVISIONS IN THE CABINET.
• DO NOT USE THIS APPARATUS NEAR SPLASHING, FALLING, SPRAYING, OR STANDING LIQUIDS.
• CLEAN ONLY WITH LINT-FREE DAMP CLOTH AND DO NOT USE CLEANING AGENTS.
• ONLY CONNECT POWER CORD TO A POLARIZED, SAFETY GROUNDED OUTLET WIRED TO CURRENT ELECTRICAL CODES AND
COMPATIBLE WITH VOLTAGE, POWER, AND FREQUENCY REQUIREMENTS STATED ON THE REAR PANEL OF THE APPARATUS.
• PROTECT THE POWER CORD FROM DAMAGE DUE TO BEING WALKED ON, PINCHED, OR STRAINED.
• UNPLUG THE APPARATUS DURING LIGHTNING STORMS OR WHEN UNUSED FOR LONG PERIODS OF TIME.
• ONLY USE ATTACHMENTS, ACCESSORIES, STANDS, OR BRACKETS SPECIFIED BY THE MANUFACTURER FOR SAFE OPERA-
TION AND TO AVOID INJURY.
• THIS APPARATUS DOES NOT OPERATE NORMALLY AND REQUIRES SERVICE WITH ANY PHYSICAL DAMAGE FROM IMPACT OR
ANY EXPOSURE TO MOISTURE.
• SERVICE MUST BE PERFORMED BY QUALIFIED PERSONNEL.
• OUR AMPLIFIERS ARE CAPABLE OF PRODUCING HIGH SOUND PRESSURE LEVELS. CONTINUED EXPOSURE TO HIGH SOUND
PRESSURE LEVELS CAN CAUSE PERMANENT HEARING IMPAIRMENT OR LOSS. USER CAUTION IS ADVISED AND EAR PRO-
TECTION IS RECOMMENDED IF UNIT IS OPERATED AT HIGH VOLUME.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOIS-
TURE. TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER. NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
"IT IS NECESSARY FOR THE USER TO REFER TO THE INSTRUCTION MANUAL"
“ES NECESARIO QUE EL USUARIO SE REFIERA AL MANUAL DE INSTRUCCIONES.”
"REFERREZ-VOUS AU MANUAL D'UTILISATION"
EXPLANATION OF GRAPHICAL SYMBOLS:
EXPLICACION DE SIMBOLOS GRAFICOS:
EXPLICATION DES SYMBÔLES GRAPHIQUES:
"DANGEROUS VOLTAGE"
“VOLTAJE PELIGROSO”
"DANGER HAUTE TENSION"
=
=
PRECAUCION
RIESGO DE CORRIENTAZO
NO ABRA
PRECAUCION: PARA REDUCIR EL RIESGO DE INCENDIOS O DESCARGAS
ELECTRICAS, NO PERMITA QUE ESTE APARATO QUEDE EXPUESTO A LA
LLUVIA O LA HUMEDAD. PARA DISMINUOIR EL RIESGO DE CORRIENTAZO.
NO ABRA LA CUBIERTA. NO HAY PIEZAS ADENTRO QUE EL USARIO PUEDO
REPARAR DEJE TODO MANTENIMIENTO A LOS TECHNICOS CALIFICADOS.
ATTENTION
RISQUE D'ELECTROCUTION
NE PAS OUVRIR
ATTENTION: PROTÉGEZ CET APPAREIL DE LA PLUIE ET DE L'HUMIDITÉ
AFIN D'ÉVITER TOUT RISQUE D'INCENDIE OU D'ÉLECTROCUTION. POUR
REDUIRE D'ELECTROCUTION NE PAS ENLEVER LE COUVERCLE. AUCUNE
PIECE INTERNE N'EST REPRABLE PAR L'UTILISATEUR. POUR TOUTE
REPARATION, S'ADRESSER A UN TECHNICIEN QUALIFIE.
-
1
-
2
-
3
-
4
Crate Amplifiers GFX-30 Manuel utilisateur
- Catégorie
- Amplificateur d'instruments de musique
- Taper
- Manuel utilisateur
dans d''autres langues
- English: Crate Amplifiers GFX-30 User manual
Documents connexes
-
Crate Amplifiers GFX-20 Manuel utilisateur
-
-
-
Crate Amplifiers GX-40M Manuel utilisateur
-
-
-
-
-
-