Crate Amplifiers GFX-20 Manuel utilisateur
- Catégorie
- Amplificateur d'instruments de musique
- Taper
- Manuel utilisateur
OWNER’S MANUAL
Congratulations!
You are now the proud owner of the Crate GFX-20 guitar amplifier. This small but
versatile amplifier features two separate channels – one crystal clear and the other with
our patented “Flex-Wave” distortion – combined with a three-band EQ and an easy to
operate DSP section which lets you dial in a variety of digital effects such as delay,
flange, chorus and reverb. Aspecial damping circuit simulates the “current source” type
output of a tube amp, giving you solid state reliability combined with classic tube
sounds.
Your GFX-20 is Musician Made in the U.S.A., using only the best components.
Extensive testing at the hands (and ears) of skilled technicians and musicians insures
you that this amplifier is the absolute best it can be.
In order to get the most out of your new amplifier, we strongly urge you to go over
the information contained in this manual before you begin playing.
And thank you
for choosing
GFX-20
GUITAR AMPLIFIER WITH
DIGITAL SIGNAL PROCESSING
1: INPUT: Connect your guitar here using a
shielded instrument cable.
OVERDRIVE CHANNEL: A high gain chan-
nel giving you sounds from a slight edge to
serious overdrive.
2: GAIN: This control sets the amount of
compression and distortion from the amplifi-
er. With the control towards far left, the
sound will have a thick compressed quality.
As you turn the control to the right the
amount of distortion increases. Crate’s
exclusive “Flex-Wave” circuitry uses sequen-
tial cascading gains to deliver distortion
which is rich in harmonics and “touch sensi-
tive.” Use this control along with the Level
(#3) to create a wide variety of sounds.
3: LEVEL: This control sets the output vol-
ume level from the Overdrive channel: in the
far left position there will be no output; as you
turn the control to the right the output
increases. Use this control along with the
Gain control (#2) to create a wide variety of
sounds.
4: OVERDRIVE SELECT: When this push-
button switch is pressed in the Overdrive
channel is engaged. The clean channel is
selected when this switch is out.
CLEAN CHANNEL: A normal gain channel
designed to give you crystal clear sounds to
medium distortion.
5: LEVEL: This control sets the output vol-
ume level from the Clean channel: in the far-
left position there will be no output; as you
turn the control to the right the output level
increases. The far right setting is maximum
output - as you increase the level, roll back
the Low control (#6).
EQUALIZATION
6: LOW: Adjust the low frequency output
level with this control: turning the control to
the left reduces the low frequency output;
turning it to the right increases the low fre-
quency output. The Low control allows a
total range of 25dB of boost or cut at 80Hz.
Due to the massive amount of low end avail-
able, you may want to “roll off” the bass at
high volumes.
7: MID: Adjust the mid frequency output
level with this control: the center position is
“flat” (no boost or cut). Turning the control to
the left reduces the midrange output; turning
it to the right increases the midrange output.
The Mid control allows for 19dB of boost or
cut at 900Hz.
8: HIGH: Adjust the high frequency output
level with this control: in the center position
the high frequency output will be “flat” (no
boost or cut). Turning the control to the left
reduces the high frequency output; turning it
to the right increases the high frequency out-
put. The High control allows a total range of
23dB of boost or cut at 5kHz.
GFX-20 Amplifier
1 2 3 4 6 7 85
9: DSP MODE: Select the type of digital
effect(s) desired with this control. Each cat-
egory and its central location is called out
(delay, flange, etc.) by the markings around
the control, with variations, as follows:
• Bypass (DSP off)
• Slapback delay
• Long delay w/regeneration
• Flange
• Slow Chorus
• Fast Chorus
• Chorus w/small room reverb
• Small room reverb
• Large room reverb
10: HEADPHONES: For private practice
sessions, plug a pair of stereo headphones
into this jack. The internal speaker is discon-
nected whenever headphones are being
used.
11: EXTERNAL SPEAKER*: You may con-
nect the GFX-20 to an external speaker with
a rated impedance of at least 4 ohms using
this jack. The internal speaker is disconnect-
ed whenever an external speaker is used.
12: ON LED: The word “ON” will glow when
you turn on the GFX-20, showing you that
the amplifier is activated and ready to play.
13: POWER: This heavy-duty rocker-type
switch is used to turn the amplifier ON in the
left position, off in the right position. The ON
LED (#12) works with this switch as a visual
indicator.
14: POWER CORD: (Rear panel, not
shown: This heavy-duty, grounded, three-
wire power cord is to be plugged into ONLY
a safely-wired, grounded 120 volt, 60 cycle
AC power outlet. DO NOT attempt to defeat
the ground connection of this cable! If your
GFX-20 was purchased outside the United
States, see the unit’s rear panel for its power
rating and follow the above guidelines.
GFX-20 Amplifier
10 11 12 139
*
*WARNING:
DO NOT attempt to
use headphones in
the Speaker jack!
Permanent hearing
damage could result!
www.crateamps.com
©1998 SLM ELECTRONICS, A DIVISION OF ST. LOUIS MUSIC, 1400 FERGUSON, ST. LOUIS, MO. 63133
P/N 47-452-01 • 03/02
GFX-20 Amplifier
Crate continually develops new products, as well as improves existing ones. For this reason, the
specifications and information in this Crate manual are subject to change without notice.
Output Power Rating >20 watts RMS @ 5% THD 4 ohms, 120VAC
Gain, Overdrive Channel 86dB +/-6dB @ 1kHz
Gain, Clean Channel 46dB +/-6dB @ 1kHz
Tone Control Range, Low 25dB @ 80Hz
Tone Control Range, Mid 19dB @ 900Hz
Tone Control Range, High 23dB @ 5kHz
Signal To Noise, Overdrive Channel >50dB
Signal To Noise, Clean Channel >65dB
Maximum Signal Accepted >1.2 volts RMS min. @ 400Hz
Internal Speaker 10” Crate Custom Design 4 ohm
Input Power Requirements 120 VAC, 60Hz, 20VA
100/115VAC, 50/60Hz, 20VA
230VAC, 50/60Hz, 20VA
Size and Weight: 15” H x 16.75” W x 9.5” D, 21 lbs.
The GFX-20 is covered with a durable black Tolex material: wipe it clean with a lint-free cloth. Never
spray cleaning agents onto the cabinet. Avoid abrasive cleansers which could damage the finish.
GFX-20 TECHNICAL SPECIFICATIONS
IMPORTANT SAFETY INSTRUCTIONS
• READ, FOLLOW, HEED, AND KEEPALL INSTRUCTIONS AND WARNINGS.
• DO NOT OPERATE NEAR ANY HEAT SOURCE AND DO NOT BLOCK ANY VENTILATION OPENINGS ON THIS APPARATUS. FOR
PROPER OPERATION, THIS UNIT REQUIRES 3” (75mm) OF WELL VENTILATED SPACE AROUND HEATSINKS AND OTHER AIR
FLOW PROVISIONS IN THE CABINET.
• DO NOT USE THIS APPARATUS NEAR SPLASHING, FALLING, SPRAYING, OR STANDING LIQUIDS.
• CLEAN ONLY WITH LINT-FREE DAMP CLOTH AND DO NOT USE CLEANING AGENTS.
• ONLY CONNECT POWER CORD TO A POLARIZED, SAFETY GROUNDED OUTLET WIRED TO CURRENT ELECTRICAL CODES AND
COMPATIBLE WITH VOLTAGE, POWER, AND FREQUENCY REQUIREMENTS STATED ON THE REAR PANEL OF THE APPARATUS.
• PROTECT THE POWER CORD FROM DAMAGE DUE TO BEING WALKED ON, PINCHED, OR STRAINED.
• UNPLUG THE APPARATUS DURING LIGHTNING STORMS OR WHEN UNUSED FOR LONG PERIODS OF TIME.
• ONLY USE ATTACHMENTS, ACCESSORIES, STANDS, OR BRACKETS SPECIFIED BY THE MANUFACTURER FOR SAFE OPERA-
TION AND TO AVOID INJURY.
• THIS APPARATUS DOES NOT OPERATE NORMALLY AND REQUIRES SERVICE WITH ANY PHYSICAL DAMAGE FROM IMPACT OR
ANY EXPOSURE TO MOISTURE.
• SERVICE MUST BE PERFORMED BY QUALIFIED PERSONNEL.
• OUR AMPLIFIERS ARE CAPABLE OF PRODUCING HIGH SOUND PRESSURE LEVELS. CONTINUED EXPOSURE TO HIGH SOUND
PRESSURE LEVELS CAN CAUSE PERMANENT HEARING IMPAIRMENT OR LOSS. USER CAUTION IS ADVISED AND EAR PRO-
TECTION IS RECOMMENDED IF UNIT IS OPERATED AT HIGH VOLUME.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOIS-
TURE. TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER. NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
"IT IS NECESSARY FOR THE USER TO REFER TO THE INSTRUCTION MANUAL"
“ES NECESARIO QUE EL USUARIO SE REFIERA AL MANUAL DE INSTRUCCIONES.”
"REFERREZ-VOUS AU MANUAL D'UTILISATION"
EXPLANATION OF GRAPHICAL SYMBOLS:
EXPLICACION DE SIMBOLOS GRAFICOS:
EXPLICATION DES SYMBÔLES GRAPHIQUES:
"DANGEROUS VOLTAGE"
“VOLTAJE PELIGROSO”
"DANGER HAUTE TENSION"
=
=
PRECAUCION
RIESGO DE CORRIENTAZO
NO ABRA
PRECAUCION: PARA REDUCIR EL RIESGO DE INCENDIOS O DESCARGAS
ELECTRICAS, NO PERMITA QUE ESTE APARATO QUEDE EXPUESTO A LA
LLUVIA O LA HUMEDAD. PARA DISMINUOIR EL RIESGO DE CORRIENTAZO.
NO ABRA LA CUBIERTA. NO HAY PIEZAS ADENTRO QUE EL USARIO PUEDO
REPARAR DEJE TODO MANTENIMIENTO A LOS TECHNICOS CALIFICADOS.
ATTENTION
RISQUE D'ELECTROCUTION
NE PAS OUVRIR
ATTENTION: PROTÉGEZ CET APPAREIL DE LA PLUIE ET DE L'HUMIDITÉ
AFIN D'ÉVITER TOUT RISQUE D'INCENDIE OU D'ÉLECTROCUTION. POUR
REDUIRE D'ELECTROCUTION NE PAS ENLEVER LE COUVERCLE. AUCUNE
PIECE INTERNE N'EST REPRABLE PAR L'UTILISATEUR. POUR TOUTE
REPARATION, S'ADRESSER A UN TECHNICIEN QUALIFIE.
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
Crate Amplifiers GFX-20 Manuel utilisateur
- Catégorie
- Amplificateur d'instruments de musique
- Taper
- Manuel utilisateur
dans d''autres langues
- English: Crate Amplifiers GFX-20 User manual
Documents connexes
-
Crate Amplifiers GFX-30 Manuel utilisateur
-
-
-
-
Crate Amplifiers GX-40M Manuel utilisateur
-
-
-
-