Please read these instructions carefully before using this product, and save this manual for future use.

G-WIN Front IP65

P-Cap Panel PC

Intel® Core™ i5-5200U

Features - 8 -

Package Content - 9 -

Product Overview - 10 -

Turning On Your Device - 13 -

Operating the Panel CPC - 14 -

How to Enable Watchdog - 15 -

Panel Mounting - 23 -

Appendix A: Cleaning the Monitor - 26 -

Appendix B: Winmate Software Development Kit - 27 -

FCC Statement

This equipment has been tested and found to comply with the

limits for a class "B" digital device, pursuant to part 15 of the FCC

rules. These limits are designed to provide reasonable protection

against harmful interference when the equipment is operated in a

commercial environment. This equipment generates, uses, and

No part of this document may be reproduced, copied, translated, or

Winmate Inc. reserve the right to make changes, without notice, to

any product, including circuits and/or software described or contained

in this manual in order to improve design and/or performance. We

assume no responsibility or liability for the use of the described

product(s) conveys no license or title under any patent, copyright, or

masks work rights to these products, and make no representations or

warranties that these products are free from patent, copyright, or

mask work right infringement, unless otherwise specified. Applications

that are described in this manual are for illustration purposes only. We

his/her option, repair or replace the defective product at no charge to

the customer, provide it is returned during the warranty period of one

year, with transportation charges prepaid. The returned product must

be properly packaged in its original packaging to obtain warranty

service. If the serial number and the product shipping data differ by

over 30 days, the in-warranty service will be made according to the

shipping date. In the serial numbers the third and fourth two digits

give the year of manufacture, and the fifth digit means the month (e.

g., with A for October, B for November and C for December).

For example, the serial number 1W16Axxxxxxxx means October of

Turning Off Your Device

To shut down the device:

1. Tap Start >Shut down.

disconnecting the power cord (if necessary).

 Strive to use separate, non-intersecting paths to route power

and networking wires. If power wiring and device wiring paths

separate.

 When necessary, it is strongly advised that you label wiring to

all devices in the system.

 Do not run signal or communication wiring and power wiring in

the same conduit. To avoid interference, wires with different

signal characteristics (i.e., different interfaces) should be routed

 If the current goes above the maximum ratings, the wiring could

overheat, causing serious damage to your equipment.

 Be careful when handling the unit. When the unit is plugged in,

the outer casing too hot to touch.

Connecting to Other Devices

This section explains how to connect external interfaces to the Panel

GC65 Panel PC has a power jack connector that accepts12V DC-in

power input.

Signal Name

Voltage