Please read these instructions carefully before using this product, and save this manual for future use.

This equipment has been tested and found to comply with the limits for a

class "B" digital device, pursuant to part 15 of the FCC rules. These limits are

designed to provide reasonable protection against harmful interference when

the equipment is operated in a commercial environment. This equipment

generates, uses, and can radiate radio frequency energy and, if not installed

iii

Copyright Notice

No part of this document may be reproduced, copied, translated, or transmitted in

any form or by any means, electronic or mechanical, for any purpose, without the

including circuits and/or software described or contained in this manual in order

to improve design and/or performance. We assume no responsibility or liability

for the use of the described product(s) conveys no license or title under any

patent, copyright, or masks work rights to these products, and make no

representations or warranties that these products are free from patent, copyright,

or mask work right infringement, unless otherwise specified. Applications that are

described in this manual are for illustration purposes only. We make no

representation or guarantee that such application will be suitable for the specified

use without further testing or modification.

Warranty

service. If the serial number and the product shipping data differ by over 30 days,

the in-warranty service will be made according to the shipping date. In the serial

numbers the third and fourth two digits give the year of manufacture, and the fifth

digit means the month (e. g., with A for October, B for November and C for

December).

For example, the serial number 1W14Axxxxxxxx means October of year 2014.

Customer Service

We provide a service guide for any problem by the following steps: First, visit the

website of our distributor to find the update information about the product.

In addition, free technical support is available from our engineers every business

day. We are always ready to give advice on application requirements or specific

information on the installation and operation of any of our products.

Safety Information

v

Dimensions 17”

INSTALLATION

any electronic device:

 Strive to use separate, non-intersecting paths to route power and

networking wires. If power wiring and device wiring paths must cross

make sure the wires are perpendicular at the intersection point.

 Keep the wires separated according to interface. The rule of thumb is that

 Do not run signal or communication wiring and power wiring in the same

conduit. To avoid interference, wires with different signal characteristics

(i.e., different interfaces) should be routed separately.

 Be sure to disconnect the power cord before installing and/or wiring your

device.

 Verify the maximum possible current for each wire gauge, especially for

the power cords. Observe all electrical codes dictating the maximum

internal components generate a lot of heat which may leave the outer

Power Cable

The Flat Stainless P-CAP Panel PC has IP65 connector. Use power cable to

connect Panel PC to the source of power.

Flat Stainless P-CAP Panel PC support 12V DC power input.

cable to connect serial interfaces.

cable to connect the Panel PC to the Internet.

USB2.0 cable to connect external devices such as mouse or keyboard to the