Please read these instructions carefully before using this product, and save this guide for future use.

- 2 -

1.1 Features - 7 -

1.2 Package Contents - 8 -

1.3 Product Overview - 9 -

2.3 Turning off Your Device - 15 -

3.1 Wiring Requirements - 16 -

3.2 Connector Pin Assignment - 17 -

3.3 Mounting - 21 -

- 3 -

This device complies with part 15 FCC rules.

Operation is subject to the following two

conditions:

interference that may cause undesired operation.

and used in accordance with the instruction manual, may cause harmful

interference to radio communications. Operation of this equipment in a

residential area is likely to cause harmful interference in which case the user

will be required to correct the interference at him own expense.

This equipment is in conformity with the requirement of the following EU

legislations and harmonized standards. Product also complies with the

Council directions.

- 4 -

their respective owners.

Winmate Inc. reserve the right to make changes, without notice, to

any product, including circuits and/or software described or contained

in this manual in order to improve design and/or performance. We

assume no responsibility or liability for the use of the described

product(s) conveys no license or title under any patent, copyright, or

masks work rights to these products, and make no representations or

warranties that these products are free from patent, copyright, or

mask work right infringement, unless otherwise specified. Applications

from the invoice date. If the customer discovers a defect, we will, at

his/her option, repair or replace the defective product at no charge to

the customer, provide it is returned during the warranty period of one

year, with transportation charges prepaid. The returned product must

be properly packaged in its original packaging to obtain warranty

service. If the serial number and the product shipping data differ by

over 30 days, the in-warranty service will be made according to the

shipping date. In the serial numbers the third and fourth two digits

give the year of manufacture, and the fifth digit means the month (e.

g., with A for October, B for November and C for December).

- 5 -

In addition, free technical support is available from our engineers

every business day. We are always ready to give advice on

application requirements or specific information on the installation and

operation of any of our products.

- 6 -

1.2 Package Contents

installing any electronic device:

 Strive to use separate, non-intersecting paths to route power

and networking wires. If power wiring and device wiring paths

must cross make sure the wires are perpendicular at the

intersection point.

all devices in the system.

 Do not run signal or communication wiring and power wiring in

the same conduit. To avoid interference, wires with different

signal characteristics (i.e., different interfaces) should be routed

separately.

 Be sure to disconnect the power cord before installing and/or

the internal components generate a lot of heat which may leave

the outer casing too hot to touch.

3.2 Connector Pin Assignment

This Panel PC is equipped with four connectors which are IP67 level

and fool-proofing design. Use only the cables that are included in the

package. The pin assignments of the cables are as follows.

The IP67 Stainless Resistive Panel PC has IP67 connector. Use

power cable to connect Panel PC to the source of power.

IP67 Stainless Resistive Panel PC supports 12V DC power input.

mouse or keyboard to the Panel PC.